<samp id="9i1hr"></samp>
  • <menuitem id="9i1hr"></menuitem>
            
    
    
    參數資料
    型號: X3100
    英文描述: Reed Relay; Contacts:SPST; Switching Current Max:0.5A; Switching Voltage Max:200V; Contact Carry Current:1A; Coil Voltage DC Max:5V; Relay Terminals:DIP-14; Relay Mounting:PC Board; Contact Carrying Power:10W
    中文描述: 3或4芯鋰離子電池保護和監控器IC
    文件頁數: 13/40頁
    文件大?。?/td> 249K
    代理商: X3100
    X3100/X3101 – Preliminary Information
    Characteristics subject to change without notice.
    13 of 40
    REV 1.1.8 12/10/02
    www.xicor.com
    over-charge and over-discharge protection circuitry is on
    for approximately 2ms in each 125ms period. Over-
    current monitoring is continuous. In monitor mode (see
    page 20) over-charge and over-discharge monitoring is
    also continuous.
    Over-charge Protection
    The X3100 and X3101 monitor the voltage on each
    battery cell (V
    CELL
    ). If for any cell, V
    CELL
    > V
    OV
    for a
    time exceeding T
    OV
    , then the Charge FET will be
    switched OFF (OVP/LMON=V
    CC
    ). The device has now
    entered Over-charge protection mode (Figure 5). The
    status of the discharge FET (via pin UVP) will remain
    unaffected.
    While in over-charge protection mode, it is possible to
    change the state of the OVPC bit in the control register
    such
    that
    OVP/LMON=Vss
    Although the OVPC bit in the control register can be
    changed, the change will not be seen at pin OVP until
    the X3100 or X3101 returns from over-charge
    protection mode.
    (Charge
    FET=ON).
    The over-charge detection delay T
    OV
    , is varied using a
    capacitor (C
    OV
    ) connected between pin OVT and GND.
    A typical delay time is shown in Table 10. The delay T
    OV
    that results from a particular capacitance C
    OV
    , can be
    approximated by the following linear equation:
    T
    OV
    (s)
    10 x C
    OV
    (μF).
    Table 19. Typical over-charge detection time
    The device further continues to monitor the battery cell
    voltages, and is released from over-charge protection
    mode when V
    CELL
    < V
    OVR
    , for all cells. When the X3100
    or X3101 is released from over-charge protection
    mode, the charge FET is automatically switched ON
    (OVP/LMON=V
    SS
    ). When the device returns from over-
    charge protection mode, the status of the discharge
    FET (pin UVP/OCP) remains unaffected.
    The value of V
    OV
    can be selected from the values
    shown in Table 4 by setting bits VOV1, VOV0. These bits
    are set by using the WCFIG instruction to write to the
    configuration register.
    Figure 5. Over-charge Protection Mode—Event Diagram
    Symbol
    T
    OV
    C
    OV
    0.1μF
    Delay
    1.0s (Typ)
    V
    CELL
    OVP/LMON
    Normal Operation Mode
    Over-charge
    Protection
    Mode
    V
    OV
    V
    OVR
    T
    OV
    Normal Operation Mode
    V
    CC
    V
    SS
    Event
    0
    1
    2
    3
    相關PDF資料
    PDF描述
    X3100Q WAFER(ARM)
    X3100V QFN,GREEN,IND TEMP,T&R(ARM)
    X3101PT-V 3 or 4 Cell Li-Ion Battery Protection and Monitor IC
    X3100 Reed Relay; Contacts:SPST; Switching Current Max:0.5A; Switching Voltage Max:200V; Contact Carry Current:1A; Coil Voltage DC Max:5V; Relay Terminals:DIP-14; Relay Mounting:PC Board; Contact Carrying Power:10W
    X3100V28 Reed Relay; Contacts:SPST; Contact Carry Current:1A; Coil Voltage DC Max:5V; Relay Terminals:Thru Hole; Switching Current Max:0.5A; Switching Voltage Max:200V; Contact Carrying Power:10W; Leaded Process Compatible:Yes RoHS Compliant: Yes
    相關代理商/技術參數
    參數描述
    X3100_08 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:3 or 4 Cell Li-ion Battery Protection and Monitor IC
    X310014 制造商:MERSEN / FERRAZ SHAWMUT 功能描述:MICROCONTACT FOR PROTISTOR 制造商:MERSEN / FERRAZ SHAWMUT 功能描述:MICROCONTACT, FOR PROTISTOR 制造商:MERSEN / FERRAZ SHAWMUT 功能描述:MICROCONTACT, FOR PROTISTOR; Contact Configuration:-; Microswitch Type:-; Actuator Style:Top; Switch Operation:-; Contact Current AC:3A; Contact Current AC Max:16A; Contact Current DC Max:10A; Contact Voltage AC Max:1kV; Contact
    X3100PT-V 制造商:XICOR 制造商全稱:Xicor Inc. 功能描述:3 or 4 Cell Li-Ion Battery Protection and Monitor IC
    X3100Q 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Battery Management
    X3100V 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Battery Management