- 您現在的位置：買賣IC網 > PDF目錄383966 > TS83C51RB2-LCE (International Rectifier) High Performance 8-bit Microcontroller PDF資料下載
參數資料
| 型號： | TS83C51RB2-LCE |
| 廠商： | International Rectifier |
| 英文描述： | High Performance 8-bit Microcontroller |
| 中文描述： | 高性能8位微控制器 |
| 文件頁數： | 26/85頁 |
| 文件大?。?/td> | 762K |
| 代理商： | TS83C51RB2-LCE |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁當前第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁
26
4188E–8051–08/06
AT/TS8xC51Rx2
The CIDL bit which allows the PCA to stop during idle mode.
The WDTE bit which enables or disables the watchdog function on module 4.
The ECF bit which when set causes an interrupt and the PCA overflow flag CF (in the CCON
SFR) to be set when the PCA timer overflows.
The CCON SFR
contains the run control bit for the PCA and the flags for the PCA timer (CF)
and each module (Refer to Table 6-5).
Bit CR (CCON.6) must be set by software to run the PCA. The PCA is shut off by clearing this
bit.
Bit CF: The CF bit (CCON.7) is set when the PCA counter overflows and an interrupt will be
generated if the ECF bit in the CMOD register is set. The CF bit can only be cleared by
software.
Bits 0 through 4 are the flags for the modules (bit 0 for module 0, bit 1 for module 1, etc.) and
are set by hardware when either a match or a capture occurs. These flags also can only be
cleared by software.
Table 6-5.
CCON: PCA Counter Control Register
The watchdog timer
function is implemented in module 4 (See Figure 6-7).
The PCA interrupt
system is shown in Figure 6-5.
CCON
Address 0D8H
CF
CR
-
CCF4
CCF3
CCF2
CCF1
CCF0
Reset value
0
0
X
0
0
0
0
0
Symbol
Function
CF
PCA Counter Overflow flag. Set by hardware when the counter rolls over. CF flags
an interrupt if bit ECF in CMOD is set. CF may be set by either hardware or software but can only be
cleared by software.
CR
PCA Counter Run control bit. Set by software to turn the PCA counter on. Must be cleared by
software to turn the PCA counter off.
-
Not implemented, reserved for future use.
(1)
1.
User software should not write 1s to reserved bits. These bits may be used in future 8051 family
products to invoke new features. In that case, the reset or inactive value of the new bit will be 0,
and its active value will be 1. The value read from a reserved bit is indeterminate.
CCF4
PCA Module 4 interrupt flag. Set by hardware when a match or capture occurs. Must be cleared by
software.
CCF3
PCA Module 3 interrupt flag. Set by hardware when a match or capture occurs. Must be cleared by
software.
CCF2
PCA Module 2 interrupt flag. Set by hardware when a match or capture occurs. Must be cleared by
software.
CCF1
PCA Module 1 interrupt flag. Set by hardware when a match or capture occurs. Must be cleared by
software.
CCF0
PCA Module 0 interrupt flag. Set by hardware when a match or capture occurs. Must be cleared by
software.
相關PDF資料 |
PDF描述 |
|---|---|
| TS83C51RB2-LIB | High Performance 8-bit Microcontroller |
| TS83C51RB2-LIE | High Performance 8-bit Microcontroller |
| TS83C51RB2-MCB | High Performance 8-bit Microcontroller |
| TS83C51RB2-MCE | High Performance 8-bit Microcontroller |
| TS83C51RB2-MIB | High Performance 8-bit Microcontroller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TS83C51RB2-LCEB | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-Bit Microcontroller |
| TS83C51RB2-LCED | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-Bit Microcontroller |
| TS83C51RB2-LIA | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-Bit Microcontroller |
| TS83C51RB2-LIB | 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:High Performance 8-bit Microcontroller |
| TS83C51RB2-LIBR | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-Bit Microcontroller |
發布緊急采購，3分鐘左右您將得到回復。