- 您現在的位置：買賣IC網 > PDF目錄98290 > TS4974IQT (STMICROELECTRONICS) 1 CHANNEL(S), VOLUME CONTROL CIRCUIT, DSO10 PDF資料下載
參數資料
| 型號： | TS4974IQT |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 音頻控制 |
| 英文描述： | 1 CHANNEL(S), VOLUME CONTROL CIRCUIT, DSO10 |
| 封裝： | 3 X 3 MM, 0.50 MM PITCH, ROHS COMPLIANT, DFN-10 |
| 文件頁數： | 14/25頁 |
| 文件大?。?/td> | 319K |
| 代理商： | TS4974IQT |
TS4974
Application information
21/25
The volume is controlled by means of two pins, UP/DVC and DOWN/DVC. When the VIL
voltage is applied, it activates the increase or decrease in gain. When one of the input pins
is grounded, volume changing is activated. When both volume UP and DOWN functions are
activated at the same time, there is no effect on the volume.
The UP/DVC and DOWN/DVC inputs need to be pulled-up or pulled-down, so a pair of
external pull-up or pull-down resistors are required. When pull-up resistors are used, it is
dependent on the application which values of resistors you should choose in the range from
10k
Ω to 1MΩ. The current flowing through the switch S1 or S2 during volume changing is
adjusted by the value of the pull-up resistors.
When pull-down resistors are used, the values are chosen in the range from at least 430k
Ω
to 1M
Ω (a value 470kΩ is recommended). Typically, in this case a 10A current flows through
the switch S1 or S2 during volume changing.
or decrease in volume. The volume can also be controlled by a microcontroller. In this case,
transistors can be used as switches for grounding the UP/DVC and DOWN/DVC pins.
The TS4974 integrates a debouncing system which does not take into account UP or
DOWN pulses that are shorter than the tdebounce time. In addition, an autorepeat function is
implemented. When a continuous voltage is applied to the UP or DOWN pin, the gain is
continuously increased or decreased after a certain time called tautorepeat. The first period of
each autorepeat sequence is longer (tautorepeat x 1.5) to avoid any parasitic activation. In this
mode, the time trange is necessary to cover the whole gain range of the device.
Figure 42 explains the meaning of the debounce, autorepeat and range times (respectively
tdebounce, tautorepeat and trange). It shows how the volume increases over the whole volume
range from the minimum gain -33 dB to the maximum gain +12 dB by 3 dB steps.
Figure 42.
Example of volume change
V
UP
G=+12dB
G=-33dB
Gain
(dB)
t
debounce
t
range
1.5 x t
autorepeat
Time
G=3dB
t
autorepeat
相關PDF資料 |
PDF描述 |
|---|---|
| TS4975EIJT | 2 CHANNEL(S), VOLUME CONTROL CIRCUIT, PBGA12 |
| TS4982IQT | 2 W, 2 CHANNEL, AUDIO AMPLIFIER, QCC32 |
| TS4984EIJT | 1.2 W, 2 CHANNEL, AUDIO AMPLIFIER, PBGA15 |
| TS4984EIKJT | 1.2 W, 2 CHANNEL, AUDIO AMPLIFIER, PBGA15 |
| TS4984EKIJT | 1.2 W, 2 CHANNEL, AUDIO AMPLIFIER, PBGA15 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TS4975 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Stereo Headphone Drive Amplifier with Digital Volume Control via I2C Bus |
| TS4975_05 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Stereo Headphone Drive Amplifier with Digital Volume Control via I2C Bus |
| TS4975EIJT | 功能描述:音頻放大器 Stereo headphone amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TS4982IQT | 功能描述:音頻放大器 2W Stereo Audio Amp 125 mW 16 ohm 3 lvl RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TS4984 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:2 x 1W Stereo audio power amplifier with active low standby mode |
發布緊急采購，3分鐘左右您將得到回復。