參數資料
型號: TS4974IQT
廠商: STMICROELECTRONICS
元件分類: 音頻控制
英文描述: 1 CHANNEL(S), VOLUME CONTROL CIRCUIT, DSO10
封裝: 3 X 3 MM, 0.50 MM PITCH, ROHS COMPLIANT, DFN-10
文件頁數: 11/25頁
文件大小: 319K
代理商: TS4974IQT
TS4974
Application information
19/25
4.4
Decoupling of the circuit
Two capacitors are needed to correctly bypass the TS4974. A power supply bypass
capacitor CS and a bias voltage bypass capacitor Cb.
CS has particular influence on the THD+N in the high frequency region (above 7 kHz) and
an indirect influence on power supply disturbances. With a value for CS of 1 F, you can
expect similar THD+N performance to that shown in the datasheet.
In the high frequency region, if CS is lower than 1 F, it increases the THD+N, and
disturbances on the power supply rail are less filtered.
On the other hand, if CS is higher than 1 F, the disturbances on the power supply rail are
more filtered.
Cb has an influence on THD+N at lower frequencies, but its function is critical to the final
result of PSRR (with input grounded and in the lower frequency region).
4.5
Wake-up time (tWU)
When the standby is released to put the device ON, the bypass capacitor Cb is not charged
immediately. As Cb is directly linked to the bias of the amplifier, the bias will not work
properly until the Cb voltage is correct. The time to reach this voltage is called the wake-up
time or tWU and is specified in the tables in Section 3: Electrical characteristics on page 5,
with Cb=1 F. During the wake-up phase, the TS4974 gain is close to zero. After the wake-
up time, the gain is released and set to its nominal value.
If Cb has a value other than 1 F, refer to Figure 40 to establish the wake-up time.
Figure 40.
Startup time vs. bypass capacitor
4.6
Shutdown time
When the standby command is set, the time required to put the two output stages in high
impedance and the internal circuitry in shutdown mode is a few microseconds.
Note:
In shutdown mode, the Bypass pin and Vin+, Vin- pins are short-circuited to ground by
internal switches. This allows a quick discharge of Cb and Cin capacitors.
0,4
0,8
1,2
1,6
2,0
0
5
10
15
Tamb=25
°C
Vcc=2.6V
Vcc=3.3V
Vcc=5V
St
a
rtup
Time
(
m
s
)
Bypass Capacitor Cb (
μF)
相關PDF資料
PDF描述
TS4975EIJT 2 CHANNEL(S), VOLUME CONTROL CIRCUIT, PBGA12
TS4982IQT 2 W, 2 CHANNEL, AUDIO AMPLIFIER, QCC32
TS4984EIJT 1.2 W, 2 CHANNEL, AUDIO AMPLIFIER, PBGA15
TS4984EIKJT 1.2 W, 2 CHANNEL, AUDIO AMPLIFIER, PBGA15
TS4984EKIJT 1.2 W, 2 CHANNEL, AUDIO AMPLIFIER, PBGA15
相關代理商/技術參數
參數描述
TS4975 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Stereo Headphone Drive Amplifier with Digital Volume Control via I2C Bus
TS4975_05 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Stereo Headphone Drive Amplifier with Digital Volume Control via I2C Bus
TS4975EIJT 功能描述:音頻放大器 Stereo headphone amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel
TS4982IQT 功能描述:音頻放大器 2W Stereo Audio Amp 125 mW 16 ohm 3 lvl RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel
TS4984 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:2 x 1W Stereo audio power amplifier with active low standby mode