- 您現在的位置：買賣IC網 > PDF目錄103068 > TPS62421DRC (TEXAS INSTRUMENTS INC) 1.61 A DUAL SWITCHING CONTROLLER, 2500 kHz SWITCHING FREQ-MAX, PDSO10 PDF資料下載
參數資料
| 型號： | TPS62421DRC |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | 1.61 A DUAL SWITCHING CONTROLLER, 2500 kHz SWITCHING FREQ-MAX, PDSO10 |
| 封裝： | 3 X 3 MM, PLASTIC, SON-10 |
| 文件頁數： | 10/37頁 |
| 文件大?。?/td> | 1020K |
| 代理商： | TPS62421DRC |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁
SLVS676C – JUNE 2006 – REVISED JUNE 2010
www.ti.com
SHORT-CIRCUIT PROTECTION
Both outputs are short-circuit protected with maximum output current = ILIMF(P-MOS and N-MOS). Once the
PMOS switch reaches its current limit, it will be turned off and the NMOS turned on. The PMOS only turns on
again, once the current in the NMOS decreases below the NMOS current limit.
THERMAL SHUTDOWN
As soon as the junction temperature, TJ, exceeds typically 150°C the device goes into thermal shutdown. In this
mode, the P and N-Channel MOSFETs are turned-off. The device continues its operation when the junction
temperature falls below the thermal shutdown hysteresis again.
EasyScale: One Pin Serial Interface for Dynamic Output Voltage Adjustment
General
EasyScale is a simple but very flexible one pin interface to configure the output voltage of both DC/DC
converters. The interface is based on a master – slave structure, where the master is typically a mController or
Application processor. Figure 28 and Table 3 give an overview of the protocol. The protocol consists of a device
specific address byte and a data byte. The device specific address byte is fixed to 4E hex. The data byte
consists of five bit for information, two address bits and the RFA bit. RFA bit set to high indicates the Request
For Acknowledge condition. The Acknowledge condition is only applied if the protocol was received correctly.
The advantage of EasyScale compared to other one-pin interfaces is that its bit detection is, to a large extent,
independent from the bit transmission rate. It can automatically detect bit rates between 1.7kBit/sec and up to
160kBit/sec. Furthermore, the interface is shared with the Mode/Data Pin and requires therefore no additional
pin.
Protocol
All bits are transmitted MSB first and LSB last. Figure 29 shows the protocol without acknowledge request (bit
RFA = 0), Figure 30 with acknowledge (bit RFA = 1) request.
Prior to both bytes, device address byte and data byte, a start condition needs to be applied. For this, the
Mode/Data pin needs to be pulled high for at least tStart before the bit transmission starts with the falling edge. In
case the Mode/Data line was already at high level (forced PWM Mode selection) no start condition need be
applied prior the device address byte.
The transmission of each byte needs to be closed with an End Of Stream condition for at least TEOS.
Addressable Registers
Three registers with a data content of 5 bits can be addressed. With 5 bit data content, 32 different values for
each register are available. Table 1 shows the addressable registers to set the output voltage when DEF_1 pin
works as digital input. In this case, converter 1 has a related register for each DEF_1 Pin condition, and one
register for converter 2. With a high/low condition on pin DEF_1 (TPS62421) either the content of register
REG_DEF_1_high/REG_DEF1_low is selected. The output voltage of converter 1 is set according to the values
in Table 4. Table 2 shows the addressable registers if DEF_1 pin acts as analog input with external resistors
connected. In this case one register is available for each converter. The output voltage of converter 1 is set
according to the values in Table 5. For converter 2, the available voltages are shown in Table 6. To generate
these output voltages a precise internal resistor divider network is used, making external resistors unnecessary
(less board space), and provides higher output voltage accuracy. The Interface is activated if at least one of the
converters is enabled (EN1 or EN2 is high). After the startup-time tStart (170ms) the interface is ready for data
reception.
18
Copyright 2006–2010, Texas Instruments Incorporated
相關PDF資料 |
PDF描述 |
|---|---|
| TC54VC3302EMBTR | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PSSO3 |
| TC54VC4501EMBRT | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PSSO3 |
| TC54VC5302ECBRT | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO3 |
| TC54VN1802ECBTR | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO3 |
| TC54VN2002ECBTR | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO3 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS62421DRCR | 功能描述:直流/直流開關轉換器 2.25MHz 600mA/1000 mA Dual Step Down RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| TPS62421DRCT | 功能描述:直流/直流開關轉換器 2.25MHz 600mA/1000 mA Dual Step Down RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| TPS62480EVM-671 | 功能描述:EVALUATION MODULE 制造商:texas instruments 系列:* 零件狀態:在售 標準包裝:1 |
| TPS62480RNCT | 功能描述:Buck Switching Regulator IC Positive Adjustable 0.6V 2 Output 6A 16-VFQFN 制造商:texas instruments 系列:- 包裝:剪切帶（CT） 零件狀態:有效 功能:降壓 輸出配置:正 拓?fù)?降壓 輸出類型:可調式 輸出數:2 電壓 - 輸入（最小值）:2.4V 電壓 - 輸入（最大值）:5.5V 電壓 - 輸出（最小值/固定）:0.6V 電壓 - 輸出（最大值）:5.5V 電流 - 輸出:6A 頻率 - 開關:2.2MHz 同步整流器:是 工作溫度:-40°C ~ 125°C （TJ） 安裝類型:表面貼裝 封裝/外殼:16-VFQFN 供應商器件封裝:16-VQFN（3x2.5） 標準包裝:1 |
| TPS62500DRCR | 制造商:Texas Instruments 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。