- 您現在的位置：買賣IC網 > PDF目錄368631 > TDA938X (NXP Semiconductors N.V.) TV signal processor-Teletext decoder with embedded m-Controller PDF資料下載
參數資料
| 型號： | TDA938X |
| 廠商： | NXP Semiconductors N.V. |
| 英文描述： | TV signal processor-Teletext decoder with embedded m-Controller |
| 中文描述： | 電視信號處理器與嵌入式米圖文電視解碼器控制器 |
| 文件頁數： | 36/140頁 |
| 文件大?。?/td> | 570K |
| 代理商： | TDA938X |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁當前第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁
Philips Semiconductors
Preliminary specification
1999 Sep 28
36
TV signal processor-Teletext decoder with
embedded
μ
-Controller
TDA 935X/6X/8X series
TCON, TMOD, TL0, TH0, TL1 and TH1.
The Timer/Counter function is selected by control bits C/T in the Timer Mode SFR(TMOD). These two Timer/
Counter have four operating modes, which are selected by bit-pairs (M1.M0) in the TMOD. Details of the modes
of operation are given in the "80C51 Based 8-Bit Microcontrollers - Philips Semiconductors (ref. IC20)"
(Reference [1]).
TL0 and TH0 are the actual timer/counter registers for timer 0. TL0 is the low byte and TH0 is the high byte. TL1
and TH1 are the actual timer/counter registers for timer 1. TL1 is the low byte and TH1 is the high byte.
WatchDog Timer
The WatchDog timer is a counter that when it overflows forces the microcontroller in to a reset. The purpose of
the WatchDog timer is to reset the microcontroller if it enters an erroneous processor state (possibly caused by
electrical noise or RFI) within a reasonable period of time. When enabled, the WatchDog circuitry will generate
a system reset if the user program fails to reload the WatchDog timer within a specified length of time known as
the WatchDog interval.
The WatchDog timer consists of an 8-bit counter with an 11 bit prescaler. The prescaler is fed with a signal
whose frequency is 1/12 fosc (1MHz). The 8 bit timer is incremented every ‘t’ seconds where:
t=12x2048x1/fosc=12x2048x1/12x10
6
= 2.048ms
W
ATCH
D
OG
T
IMER OPERATION
The WatchDog operation is activated when the WLE bit in the Power Control SFR (PCON) is set. The WatchDog
can be disabled by Software by loading the value 55H into the WatchDog Key SFR (WDTKEY). This must be
performed before entering Idle/Power Down mode to prevent exiting the mode prematurely.
Once activated the WatchDog timer SFR (WDT) must be reloaded before the timer overflows. The WLE bit must
be set to enable loading of the WDT SFR, once loaded the WLE bit is reset by hardware, this is to prevent
erroneous Software from loading the WDT SFR.
The value loaded into the WDT defines the WatchDog interval.
WatchDog interval = (256 - WDT) * t = (256 -WDT)*2.048ms
The range of intervals is from WDT = 00H which gives 524ms to WDT = FFH which gives 2.048ms
PORT Alternate Functions
The Ports 1,2 and 3 are shared with alternate functions to enable control of external devices and circuitry. The
alternate functions are enabled by setting the appropriate SFR and also writing a logic ‘1’ to the Port bit that the
function occupies.
If the Pulse Width Modulator outputs (PWM) are required on Ports 3.0 to 3.3, they require an additional bit to be
set in the Character ROM. If this facility is required, it should be requested when ordering the Language Set.
The PWMs may be enabled per pin, thus giving any combination of either PWM output, SFR output or SAD
input.
相關PDF資料 |
PDF描述 |
|---|---|
| TDA9829T | Downconverter For DVB(下變頻器 （DVB應用）) |
| TDAT04622 | TDAT SONET/SDH 155/622/2488 Mbits/s Data Interfaces |
| TDAT042G51A-3BLL1 | TDAT SONET/SDH 155/622/2488 Mbits/s Data Interfaces |
| TE13004D | Silicon NPN High Voltage Switching Transistor |
| TE13005D | Silicon NPN High Voltage Switching Transistor |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TDA9400 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:INTEGRATED CIRCUITS FOR TV AND RADIO RECEVERS |
| TDA9403 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:INTEGRATED CIRCUITS FOR TV AND RADIO RECEVERS |
| TDA9500 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:INTEGRATED CIRCUITS FOR TV AND RADIO RECEVERS |
| TDA9501 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:AC COUPLING HIGH VOLTAGE VIDEO AMPLIFIER |
| TDA9503 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:INTEGRATED CIRCUITS FOR TV AND RADIO RECEVERS |
發布緊急采購，3分鐘左右您將得到回復。