- 您現在的位置：買賣IC網 > PDF目錄98148 > STK17T88-RF45 PROGRAMMABLE TIMER, PDSO48 PDF資料下載
參數資料
| 型號： | STK17T88-RF45 |
| 元件分類： | 時鐘/數據恢復及定時提取 |
| 英文描述： | PROGRAMMABLE TIMER, PDSO48 |
| 封裝： | 0.300 INCH, ROHS COMPLIANT, PLASTIC, SSOP-48 |
| 文件頁數： | 11/29頁 |
| 文件大小： | 535K |
| 代理商： | STK17T88-RF45 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁
19
STK17T88
Jan, 2008
Document Control #ML0024 Rev 2.0
INTERRUPT REGISTER
Watchdog Interrupt Enable (WIE). When set to 1,
the watchdog timer drives the INT pin when a watch-
dog time-out occurs. When WIE is set to 0, the
watchdog time-out only sets the WDF flag bit.
Alarm Interrupt Enable (AIE). When set to 1, the INT
pin is driven when an alarm match occurs. When set
to 0, the alarm match only sets the AF flag bit.
Power Fail Interrupt Enable (PFE). When set to 1,
the INT pin is driven by a power fail signal from the
power monitor. When set to 0, only the PF flag is set.
High/Low (H/L). When set to a 1, the INT pin is
active high and the driver mode is push-pull. The
INT pin can drive high only when VCC>VSWITCH.
When set to a 0, the INT pin is active low and the
drive mode is open-drain. The active low (open
drain) output is maintained even when power is lost.
Pulse/Level (P/L). When set to a 1, the INT pin is
driven for approximately 200 ms when the interrupt
occurs. The pulse is reset when the Flags register is
read. When P/L is set to a 0, the INT pin is driven
high or low (determined by H/L) until the Flags regis-
ter is read.
The Interrupt register is loaded with the default value
00h at the factory. The user should configure the
Interrupt register to the value desired for their
desired mode of operation. Once configured, the
value is retained during power failures.
FLAGS REGISTER
The Flags register has three flag bits: WDF, AF, and
PF. These flags are set by the watchdog time-out,
alarm match, or power fail monitor respectively. The
processor can either poll this register or enable the
interrupts to be informed when a flag is set. The
flags are automatically reset once the register is
read.
The Flags register is automatically loaded with the
value 00h on power up (with the exception of the
OSCF bit).
相關PDF資料 |
PDF描述 |
|---|---|
| STK17T88-RF25ITR | PROGRAMMABLE TIMER, PDSO48 |
| STK17TA8-R25I | REAL TIME CLOCK, PDSO48 |
| STK17TA8-R35 | REAL TIME CLOCK, PDSO48 |
| STK17TA8-W25 | REAL TIME CLOCK, PDIP40 |
| STK17TA8-R45 | REAL TIME CLOCK, PDSO48 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| STK17T88-RF45I | 功能描述:NVRAM 32Kbx8+RTC 2.7-3.6V RoHS:否 制造商:Maxim Integrated 數據總線寬度:8 bit 存儲容量:1024 Kbit 組織:128 K x 8 接口類型:Parallel 訪問時間:70 ns 電源電壓-最大:5.5 V 電源電壓-最小:4.5 V 工作電流:85 mA 最大工作溫度:+ 70 C 最小工作溫度:0 C 封裝 / 箱體:EDIP 封裝:Tube |
| STK17T88-RF45ITR | 功能描述:NVRAM 32Kbx8+RTC 2.7-3.6V RoHS:否 制造商:Maxim Integrated 數據總線寬度:8 bit 存儲容量:1024 Kbit 組織:128 K x 8 接口類型:Parallel 訪問時間:70 ns 電源電壓-最大:5.5 V 電源電壓-最小:4.5 V 工作電流:85 mA 最大工作溫度:+ 70 C 最小工作溫度:0 C 封裝 / 箱體:EDIP 封裝:Tube |
| STK17T88-RF45TR | 功能描述:NVRAM 32Kbx8+RTC 2.7-3.6V RoHS:否 制造商:Maxim Integrated 數據總線寬度:8 bit 存儲容量:1024 Kbit 組織:128 K x 8 接口類型:Parallel 訪問時間:70 ns 電源電壓-最大:5.5 V 電源電壓-最小:4.5 V 工作電流:85 mA 最大工作溫度:+ 70 C 最小工作溫度:0 C 封裝 / 箱體:EDIP 封裝:Tube |
| STK17TA8-RF25 | 功能描述:NVRAM 128Kbx8+RTC 2.7-3.6V RoHS:否 制造商:Maxim Integrated 數據總線寬度:8 bit 存儲容量:1024 Kbit 組織:128 K x 8 接口類型:Parallel 訪問時間:70 ns 電源電壓-最大:5.5 V 電源電壓-最小:4.5 V 工作電流:85 mA 最大工作溫度:+ 70 C 最小工作溫度:0 C 封裝 / 箱體:EDIP 封裝:Tube |
| STK17TA8-RF25I | 功能描述:NVRAM 128Kbx8+RTC 2.7-3.6V RoHS:否 制造商:Maxim Integrated 數據總線寬度:8 bit 存儲容量:1024 Kbit 組織:128 K x 8 接口類型:Parallel 訪問時間:70 ns 電源電壓-最大:5.5 V 電源電壓-最小:4.5 V 工作電流:85 mA 最大工作溫度:+ 70 C 最小工作溫度:0 C 封裝 / 箱體:EDIP 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。