參數資料
型號: SI3050-E1-FT
廠商: Silicon Laboratories Inc
文件頁數: 53/128頁
文件大?。?/td> 0K
描述: IC VOICE DAA SYSTEM SIDE 20TSSOP
標準包裝: 74
系列: *
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁當前第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁
Si3050 + Si3011/18/19
30
Rev. 1.5
Figure 22. Typical Application Circuit for
Ground Start Support on the SI3050
5.14.1. Ground Start Idle
Ensure the relay in series with TIP is closed by clearing
the TGOE bit (Register 32, bit 1). This enables the DAA
to sense if the CO grounds TIP. Set RG to 1
(Register 32, bit 0) so that no current flows through the
relay connecting RING to ground.
5.14.2. DAA Requests Line Seizure
With TGOE set to zero, seize the line by closing the
relay
in
series
with
RING
(clear
the
RG
bit,
Register 32, bit 0). The CO detects this current flowing
on RING and grounds TIP. This sets the TGD bit
(Register 32, bit 2). The DAA may then be taken
off-hook and the relay in series with RING opened (clear
the RG bit). The call continues as in loop-start mode.
5.14.3. CO Requests Line Seizure
In a normal on-hook state, the relay in series with TIP
should be closed, connecting the –24 V isolated supply.
The CO grounds TIP to request line seizure, causing
current to flow. The opto-isolator U3 (see Figure 22 on
page 30) detects this current and sets the TGD bit
(Register 32, bit 2). This bit remains high as long as
current is detected. The TGDI bit (Register 4, bit 1) is a
sticky bit, and remains high until cleared. A hardware
interrupt on the AOUT/INT can be made to occur when
TIP current begins to flow by enabling the TGDM bit
(Register 3, bit 1). Clear the interrupt by writing 0 to the
TGDI bit (Register 4 bit 1). The DAA may then be taken
off-hook and the call continued as in loop-start mode.
5.15. Interrupts
The AOUT/INT pin can be used as a hardware interrupt
pin by setting the INTE bit (Register 2, bit 7). When this
bit is set, the analog output used for call progress
monitoring is not available. The default state of this
interrupt output pin is active low, but active high
operation can be enabled by setting the INTP bit
(Register 2, bit 6). This pin is an open-drain output
when the INTE bit is set and requires a 4.7 k
pullup or
pulldown for correct operation. If multiple INT pins are
connected to a single input, the combined pullup or
pulldown resistance should equal 4.7 k
Bits 7–0 in
Register 3 and bit 1 in Register 44 can be set to enable
hardware interrupt sources (bit 0 is available with the
Si3011 and Si3019 line-side devices only). When one or
more of these bits is set, the AOUT/INT pin goes into an
active state and stays active until the interrupts are
serviced. If more than one hardware interrupt is enabled
in Register 3, use software polling to determine the
cause of the interrupts. Register 4 and bit 3 of
Register 44 contain sticky interrupt flag bits. Clear these
bits after servicing the interrupt.
Registers 43 and 44 contain the line current/voltage
threshold interrupt. These line current/voltage registers
and interrupt are only available with the Si3011 and
Si3019 line-side devices. This interrupt is triggered
when the measured line voltage or current in the LVS or
LCS2
registers,
as
selected
by
the
CVS
bit
(Register 44, bit 2), crosses the threshold programmed
into the CVT[7:0] bits. With the CVP bit, the interrupt
can be programmed to occur when the measured value
rises above or falls below the threshold. Only the
magnitude
of
the
measured
value
is
used
for
comparison to the threshold programmed into the
Table 15. Component Values for the Ground
Start Support Schematic
Symbol
Value
Supplier(s)
R101
200
, 2 W, ±5%
Venkel, SMEC,
Panasonic
R102, R103,
R106
1k
, 1/10 W, ±5% Venkel, SMEC,
Panasonic
R104
1.5 k
, 1/10 W, ±5% Venkel, SMEC,
Panasonic
R105
10 k
, 1/2 W, ±5% Venkel, SMEC,
Panasonic
RL1
AQW210S
Aromat, NEC
U3
PS2501L-1
NEC, Fairchild
VD
-24V
VD
TIP
RING
TGDb
RGb
TGDEb
RL1
Opto-Relay
1
2
3
4
5 5
6 6
7 7
8 8
U3
Opto-Isolator
1
2
3 3
4 4
R105
R101
R102
R103
R104
R106
相關PDF資料
PDF描述
PIC16C54/JW IC MCU EPROM 512X12 18CDIP
SI3056-D-FS IC SYSTEM-SIDE DAA 16SOIC
PIC16C71/JW IC MCU EPROM 1KX14 A/D 18CDIP
SI3018-F-FS-R IC ISOMODEM LINE-SIDE DAA 16SOIC
VE-2N3-IX-F4 CONVERTER MOD DC/DC 24V 75W
相關代理商/技術參數
參數描述
SI3050-E1-FTR 制造商:Silicon Laboratories Inc 功能描述:Voice DAA Chipset 20-Pin TSSOP T/R 制造商:Silicon Laboratories Inc 功能描述:SI3050 VOICE DAA SYSTEM-SIDE - Tape and Reel 制造商:Silicon Laboratories Inc 功能描述:3.3VH PROGRAMMABLE VOICE DAA SYSTM-SIDE 制造商:Silicon Laboratories Inc 功能描述:IC VOICE DAA SYSTEM SIDE 20TSSOP 制造商:Silicon Laboratories Inc 功能描述:Si3050 Voice DAA System-Side
Si3050-E1-GM 功能描述:電信線路管理 IC System-side Voice DAA RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
SI3050-E1-GMR 制造商:Silicon Laboratories Inc 功能描述:SI3050 VOICE DAA SYSTEM-SIDE - LEAD-FREE - Tape and Reel 制造商:Silicon Laboratories Inc 功能描述:IC VOICE DAA SYSTEM SIDE 24QFN 制造商:Silicon Laboratories Inc 功能描述:Si3050 Voice DAA System-Side
Si3050-E1-GT 功能描述:電信線路管理 IC System-side Voice DAA RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
SI3050-E1-GTR 制造商:Silicon Laboratories Inc 功能描述:SI3050 VOICE DAA SYSTEM-SIDE - Tape and Reel 制造商:Silicon Laboratories Inc 功能描述:IC VOICE DAA SYSTEM SIDE 24QFN 制造商:Silicon Laboratories Inc 功能描述:Si3050 Voice DAA System-Side