參數資料
型號： SC16IS752IBS,151
廠商： NXP Semiconductors
文件頁數： 26/60頁
文件大小： 0K
描述： IC UART DUAL I2C/SPI 32-HVQFN
產品培訓模塊： Bridge Solutions
Stand-Alone UARTs
I²C Bus Fundamentals
特色產品： NXP - I2C Interface
標準包裝： 490
特點： 低電流
通道數： 2，DUART
FIFO's： 64 字節
規程： RS232，RS485
電源電壓： 2.5V, 3.3V
帶自動流量控制功能： 是
帶IrDA 編碼器/解碼器： 是
帶故障啟動位檢測功能： 是
帶調制解調器控制功能： 是
安裝類型： 表面貼裝
封裝/外殼： 32-VFQFN 裸露焊盤
供應商設備封裝： 32-HVQFN（5x5）
包裝： 托盤
產品目錄頁面： 828 (CN2011-ZH PDF)
配用： 568-4000-ND - DEMO BOARD SPI/I2C TO DUAL UART
568-3510-ND - DEMO BOARD SPI/I2C TO UART
其它名稱： 568-2236
935279288151
SC16IS752IBS-S
SC16IS752_SC16IS762
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2012. All rights reserved.
Product data sheet
Rev. 9 — 22 March 2012
32 of 60
NXP Semiconductors
SC16IS752; SC16IS762
Dual UART with I2C-bus/SPI interface, 64-byte FIFOs, IrDA SIR
8.19 Extra Features Control Register (EFCR)
[1]
For SC16IS762 only.
8.20 Division registers (DLL, DLH)
These are two 8-bit registers which store the 16-bit divisor for generation of the baud clock
in the baud rate generator. DLH stores the most significant part of the divisor. DLL stores
the least significant part of the divisor.
Note that DLL and DLH can only be written to before Sleep mode is enabled (before
IER[4] is set).
Table 30.
Extra Features Control Register bits description
Bit
Symbol
Description
7
IRDA MODE
IrDA mode.
0 = IrDA SIR, 316 pulse ratio, data rate up to 115.2 kbit/s
1 = IrDA SIR, 14 pulse ratio, data rate up to 1.152 Mbit/s[1]
6-
reserved
5
RTSINVER
Invert RTS signal in RS-485 mode.
0: RTS = 0 during transmission and RTS = 1 during reception
1: RTS = 1 during transmission and RTS = 0 during reception
4
RTSCON
Enable the transmitter to control the RTS pin.
0: transmitter does not control RTS pin
1: transmitter controls RTS pin
3-
reserved
2
TXDISABLE
Disable transmitter. UART does not send serial data out on the
transmit pin, but the transmit FIFO will continue to receive data from
host until full. Any data in the TSR will be sent out before the
transmitter goes into disable state.
0: transmitter is enabled
1: transmitter is disabled
1
RXDISABLE
Disable receiver. UART will stop receiving data immediately once this
bit is set to 1, and any data in the TSR will be sent to the receive FIFO.
User is advised not to set this bit during receiving.
0: receiver is enabled
1: receiver is disabled
0
9-BIT MODE
Enable 9-bit or Multidrop mode (RS-485).
0: normal RS-232 mode
1: enables RS-485 mode
相關PDF資料
PDF描述
SC16IS752IPW,112 IC UART DUAL 12C/SPI 28TSSOP
SC16C850IBS,151 IC UART SGL-CH 3.3V 32-HVQFN
SC16IS760IPW,112 IC UART 64BYTE 24TSSOP
FT2232HL-REEL IC USB HS DUAL UART/FIFO 64-LQFP
ATMEGA168P-20AUR MCU AVR 16K FLASH 20MHZ 32-TQFP
相關代理商/技術參數
參數描述
SC16IS752IBS-F 功能描述:UART 接口集成電路 I2C/SPI-UARTBRIDGE W/IRDA AND GPIO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16IS752IPW 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Dual UART with I2C-bus/SPI interface, 64 bytes of transmit and receive FIFOs, IrDA SIR built-in support
SC16IS752IPW,112 功能描述:UART 接口集成電路 UART DUAL 12C/SPI RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16IS752IPW,128 功能描述:UART 接口集成電路 I2C/SPI-UARTBRIDGE RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16IS752IPW112 制造商:NXP Semiconductors 功能描述:IC DUAL UART FIFO 5MBPS 3.6V TSSOP28
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*