參數資料
型號： SAA7712
廠商： NXP Semiconductors N.V.
英文描述： Sound effects DSP
中文描述： DSP的音效
文件頁數： 14/44頁
文件大?。?/td> 178K
代理商： SAA7712
1999 Aug 05
14
Philips Semiconductors
Preliminary specification
Sound effects DSP
SAA7712H
8.1.8
P
IN
VREFDA
With two internal resistors half the supply voltage (V
DDA2
)
is obtained and coupled to an internal buffer. This
reference voltage is used as DC voltage for the output
operational amplifiers and as reference for the DAC.
In order to obtain the lowest noise and to have the best
ripple rejection, a filter capacitor has to be added between
this pin and ground.
8.1.9
I
NTERNAL
DAC
CURRENT REFERENCE
As a reference for the internal DAC current and for the
DAC current source output, a current is drawn from the
level on pin VREFDA to pin V
SSA2
(ground) via an internal
resistor. The absolute value of this resistor also
determines the absolute current of the DAC. This means
that the absolute value of the current is not that fixed due
to the spread of the current reference resistor value. This,
however, does not influence the absolute output voltages
because these voltages are also derived from a
conversion of the DAC current to the actual output voltage
via internal resistors.
8.1.10
S
UPPLY OF THE ANALOG OUTPUTS
All the analog circuitry of the DACs and the operational
amplifiers are fed by 2 supply pins, V
DDA2
and V
SSA2
.
Pin V
DDA2
must have sufficient decoupling to prevent THD
degradation and to ensure a good power supply rejection
ratio.
The digital part of the DAC is fully supplied from the chip
core supply.
8.2
I
2
S-bus inputs and outputs
8.2.1
D
IGITAL DATA STREAM FORMATS
For communication with external digital sources a serial
3-line bus is used. This I
2
S-bus has one line for data, one
line for clock and one line for the word select.
See Fig.7 for the general waveform formats of the four
possible formats.
Theserialdigitalinputs(andoutputs)oftheSAA7712Hare
capable of handling multiple formats: Philips I
2
S-bus and
LSB-justified formats of 16, 18 and 20 bits word sizes.
In Philips I
2
S-bus format, the number of bit clock (BCK)
pulses may vary in the application. When the transmitter
word length is smaller than the receiver word length, the
receiver will fill in zeroes at the LSB side. When the
transmitter word length exceeds the receiver word length,
the LSBs are skipped. For correct operation of the DACs,
there should be a minimum of 16 bit clocks per word
select.
In the LSB-justified formats, the transmitter and receiver
must be set to the same format. Be aware that a format
switch between 20, 18 and 16 bits LSB-justified formats is
done by changing the relative timing of the word select
edges. The data bits remain unchanged. In the 20 bits
format, the 2 LSBs are zeroes. In the 16 bits format, the
2 data bits following the word select edge are not zero, but
undefined. In fact, these are the LSBs of the 18-bit word.
The timing specification for the waveforms of the serial
digital inputs and outputs are given in Fig.17.
相關PDF資料
PDF描述
SAA8110G Digital Signal Processor (DSP) for cameras(應用于照相中的數字信號處理器)
SAA8122A Digital Still Camera Processor (ImagIC family)(數字靜態照相處理器)
SAA8122AEL Digital Still Camera Processor ImagIC family
SAB-C504-2R24M 8-Bit CMOS Microcontroller
SAB-C504-2R40M 8-Bit CMOS Microcontroller
相關代理商/技術參數
參數描述
SAA7712H 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Sound effects DSP
SAA7715 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Digital Signal Processor
SAA7715H 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Digital Signal Processor
SAA7724H 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Car radio digital signal processor
SAA7740 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Digital Audio Processing IC DAPIC
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*