- 您現在的位置：買賣IC網 > PDF目錄372063 > RJ80530GZ009512 Microprocessor PDF資料下載
參數資料
| 型號： | RJ80530GZ009512 |
| 元件分類： | 微處理器 |
| 英文描述： | Microprocessor |
| 中文描述： | 微處理器 |
| 文件頁數： | 89/89頁 |
| 文件大小： | 1672K |
| 代理商： | RJ80530GZ009512 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁當前第89頁
Mobile Intel
Pentium
III Processor-M Datasheet
298340-002
Datasheet
89
Table 51. PLL Filter Resistor Recommendations
Resistor
Part Number
Value
Tolerance
Power
R1
Various
1
10%
1/16W
To satisfy damping requirements, total series resistance in the filter (from V
CCT
to the top plate of the
capacitor) must be at least 0.35
. This resistor can be in the form of a discrete component, or routing,
or both. For example, if the picked inductor has minimum DCR of 0.25
, then a routing resistance of
at least 0.10
is required. Be careful not to exceed the maximum resistance rule (2
). For example, if
using discrete R1, the maximum DCR of the L should be less than 2.0 - 1.1 = 0.9
, which precludes
using L2 and possibly L1.
Other routing requirements include:
The capacitor should be close to the PLL1 and PLL2 pins, with less than 0.1
per route (These
routes do not count towards the minimum damping resistance requirement).
The PLL2 route should be parallel and next to the PLL1 route (minimize loop area).
The inductor should be close to the capacitor; any routing resistance should be inserted between
VCCT and the inductor.
Any discrete resistor should be inserted between V
CCT
and the inductor.
A4.
Comments
A magnetically shielded inductor protects the circuit from picking up external flux noise. This
should provide better timing margins than with an unshielded inductor.
A discrete or routed resistor is required because the LC filter by nature has an under-damped
response, which can cause resonance at the LC pole. Noise amplification at this band, although
not in the PLL-sensitive spectrum, could cause a fatal headroom reduction for analog circuitry.
The resistor serves to dampen the response. Systems with tight space constraints should consider
a discrete resistor to provide the required damping resistance. Too large of a damping resistance
can cause a large IR drop, which means less analog headroom and lower frequency.
Ceramic capacitors have very high self-resonance frequencies, but they are not available in large
capacitance values. A high self-resonant frequency coupled with low ESL/ESR is crucial for
sufficient rejection in the PLL and high frequency band. The recommended tantalum capacitors
have acceptably low ESR and ESL.
The capacitor must be close to the PLL1 and PLL2 pins; otherwise the value of the low ESR
tantalum capacitor is wasted. Note the distance constraint should be translated from the 0.1-
requirement.
相關PDF資料 |
PDF描述 |
|---|---|
| RJ80530LZ800512 | Microprocessor |
| RJ80530MY650256 | MICROPROCESSOR|32-BIT|CMOS|BGA|479PIN|CERAMIC |
| RJ80530NZ001256 | Microprocessor |
| RJ80530VY700256 | Microprocessor |
| RJ80530VZ733256 | Microprocessor |
相關代理商/技術參數 |
參數描述 |
|---|---|
| RJ80530GZ009512S L5CT | 制造商:Intel 功能描述:MPU Pentium |
| RJ80530GZ009512S L6AK | 制造商:Intel 功能描述:MPU Pentium |
| RJ80530KZ001512 | 制造商:Rochester Electronics LLC 功能描述: 制造商:Intel 功能描述: |
| RJ80530KZ001512S L6QU | 制造商:Intel 功能描述:32BIT MPU 80530KZ001512 1.00G |
| RJ80530KZ800512 | 制造商:Rochester Electronics LLC 功能描述:PIII PROCESSOR LV, 800MHZ, 512K, PBGA - Bulk |
發布緊急采購，3分鐘左右您將得到回復。