
2
PI5V330A
Low On-Resistance Wideband/Video
Quad 2-Channel Mux/DeMux
PS8695A
02/22/08
Storage Temperature ..........................................................–65°C to +150°C
Ambient Temperature with Power Applied .........................–40°C to +85°C
Supply Voltage to Ground Potential (Inputs & VCC Only)...–0.5V to +7.0V
Supply Voltage to Ground Potential (Outputs & D/O Only) –0.5V to +7.0V
DC Input Voltage ..................................................................–0.5V to +7.0V
DC Output Current.............................................................................120mA
Power Dissipation .................................................................................0.5W
Note:
Stresses greater than those listed under MAXIMUM RAT-
INGS may cause permanent damage to the device. This is
a stress rating only and functional operation of the device
at these or any other conditions above those indicated in the
operational sections of this specication is not implied. Ex-
posure to absolute maximum rating conditions for extended
periods may affect reliability.
Notes:
1.
For Max. or Min. conditions, use appropriate value specied under Electrical Characteristics for the applicable device type.
2.
Typical values are at VCC = 5.0V, T
A
= 25°C ambient and maximum loading.
3.
Not more than one output should be shorted at one time. Duration of the test should not exceed one second.
4.
Measured by the voltage drop between S1, S2, and D I/O pins at indicated current through the switch. On-Resistance is determined by the
lower of the voltages on the S1, S2, and D I/O pins.
Maximum Ratings
(Above which the useful life may be impaired. For user guidelines, not tested.)
DC Electrical Characteristics (Over the Operating Range, TA = –40°C to +85°C, VCC = 5V ±5%)
Parameters
Description
Test Conditions(1)
Min.
Typ.(2)
Max.
Units
VANALOG
Analog Signal Range
0
2.0
V
VIH
Input HIGH Voltage
Guaranteed Logic HIGH level
2.0
VIL
Input LOW Voltage
Guaranteed Logic LOW Level
-0.5
0.8
IIH
Input HIGH Current
VCC = Max., VIN = VCC
±1
μA
IIL
Input LOW Current
VCC = Max., VIN = GND
±1
IO
Analog Output
Leakage Currnet
0 ≤ S1, S2, or D ≤ VCC, Switch OFF
±1
VIK
Clamp Diode Voltage
VCC = Min., IIN = -18mA
-0.7
-1.2
V
IOS
Short Circuit Current(3)
150
mA
VH
Input Hysteresis at
Control Pins
VCC = MIN., VIN = 1.0V RL = 75Ω, ION = 13 mA
3
7
mV
RON
Switch On-Resistance
VCC = MIN., VIN = 2.0V RL ON = 26 mA
3
7
10
Ω
08-0288