- 您現在的位置：買賣IC網 > PDF目錄361112 > NE555 (永盛國際集團) Precision Timer PDF資料下載
參數資料
| 型號： | NE555 |
| 廠商： | 永盛國際集團 |
| 英文描述： | Precision Timer |
| 中文描述： | 精密定時器 |
| 文件頁數： | 4/5頁 |
| 文件大?。?/td> | 273K |
| 代理商： | NE555 |
Applications Information
MONOSTABLE OPERATION
In this mode of operation, the timer functions as a one-shot
(Figure 1). The external capacitor is initially held discharged
by a transistor inside the timer. Upon application of a nega-
tive trigger pulse of less than 1/3 V
to pin 2, the flip-flop is
set which both releases the short circuit across the capacitor
and drives the output high.
The voltage across the capacitor then increases exponen-
tially for a period of t = 1.1 R
C, at the end of which time the
voltage equals 2/3 V
. The comparator then resets the
flip-flop which in turn discharges the capacitor and drives the
output to its low state. Figure 2 shows the waveforms gener-
ated in this mode of operation. Since the charge and the
threshold level of the comparator are both directly propor-
tional to supply voltage, the timing internal is independent of
supply.
During the timing cycle when the output is high, the further
application of a trigger pulse will not effect the circuit so long
as the trigger input is returned high at least 10μs before the
end of the timing interval. However the circuit can be reset
during this time by the application of a negative pulse to the
reset terminal (pin 4). The output will then remain in the low
state until a trigger pulse is again applied.
When the reset function is not in use, it is recommended that
it be connected to V
CC
to avoid any possibility of false trig-
gering.
Figure 3 is a nomograph for easy determination of R, C val-
ues for various time delays.
NOTE:
In monostable operation, the trigger should be driven
high before the end of timing cycle.
ASTABLE OPERATION
If the circuit is connected as shown in Figure 4 (pins 2 and 6
connected) it will trigger itself and free run as a multivibrator.
The external capacitor charges through R
+ R
and dis-
charges through R
. Thus the duty cycle may be precisely
set by the ratio of these two resistors.
In this mode of operation, the capacitor charges and dis-
charges between 1/3 V
and 2/3 V
. As in the triggered
mode, the charge and discharge times, and therefore the fre-
quency are independent of the supply voltage.
FIGURE 1. Monostable
V
CC
= 5V
TIME = 0.1 ms/DIV.
R
A
= 9.1k
C = 0.01μF
Top Trace: Input 5V/Div.
Middle Trace: Output 5V/Div.
Bottom Trace: Capacitor Voltage 2V/Div.
FIGURE 2. Monostable Waveforms
FIGURE 3. Time Delay
FIGURE 4. Astable
4
NE555
相關PDF資料 |
PDF描述 |
|---|---|
| NE555 | Timers for Timing Delays and Oscillator Application in Commercial, Industrial and Military Equipment |
| NE555DR | PRECISION TIMERS |
| NE555PSR | PRECISION TIMERS |
| NE555PW | PRECISION TIMERS |
| NE555PWR | PRECISION TIMERS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| NE555_07 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:General purpose single bipolar timers |
| NE555_12 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:General-purpose single bipolar timers |
| NE555_95 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:GENERAL PURPOSE SINGLE BIPOLAR TIMERS |
| NE5550234 | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:Silicon Power MOS FET |
| NE5550234_13 | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:Silicon Power MOS FET |
發布緊急采購，3分鐘左右您將得到回復。