- 您現在的位置：買賣IC網 > PDF目錄15742 > MPC5554EVB (Freescale Semiconductor)BOARD EVALUATION MPC5554 PDF資料下載
參數資料
| 型號： | MPC5554EVB |
| 廠商： | Freescale Semiconductor |
| 文件頁數： | 2/58頁 |
| 文件大小： | 0K |
| 描述： | BOARD EVALUATION MPC5554 |
| 標準包裝： | 1 |
| 類型： | 微控制器 |
| 適用于相關產品： | MPC5554 |
| 所含物品： | 評估板和演示軟件 |
| 相關產品： | MPC5554MZP132R2-ND - IC MCU 2M FLASH 132MHZ 416-PBGA MPC5554MZP132-ND - IC MCU 2M FLASH 132MHZ 416-PBGA MPC5554MVR132R2-ND - IC MCU 2M FLASH 132MHZ 416-PBGA MPC5554MVR132-ND - IC MCU 2M FLASH 132MHZ 416-PBGA MPC5554AZP132-ND - IC MPU 2M FLASH 132MHZ 416-PBGA |
第1頁當前第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁
MPC5554 Microcontroller Data Sheet, Rev. 4
Electrical Characteristics
Freescale Semiconductor
10
3.7
Power-Up/Down Sequencing
Power sequencing between the 1.5 V power supply and VDDSYN or the RESET power supplies is required
if using an external 1.5 V power supply with VRC33 tied to ground (GND). To avoid power-sequencing,
VRC33 must be powered up within the specified operating range, even if the on-chip voltage regulator
controller is not used. Refer to Section 3.7.2, “Power-Up Sequence (VRC33 Grounded),” and
Power sequencing requires that VDD33 must reach a certain voltage where the values are read as ones
before the POR signal negates. Refer to Section 3.7.1, “Input Value of Pins During POR Dependent on
Although power sequencing is not required between VRC33 and VDDSYN during power up, VRC33 must
not lead VDDSYN by more than 600 mV or lag by more than 100 mV for the VRC stage turn-on to operate
within specification. Higher spikes in the emitter current of the pass transistor occur if VRC33 leads or lags
VDDSYN by more than these amounts. The value of that higher spike in current depends on the board power
supply circuitry and the amount of board level capacitance.
8
Voltage differential during power up such that:
VDD33 can lag VDDSYN or VDDEH6 before VDDSYN and VDDEH6 reach the
VPOR33 and VPOR5 minimums respectively.
VDD33_LAG
—1.0
V
9
Absolute value of slew rate on power supply pins
—
50
V/ms
10
Required gain at Tj:
IDD IVRCCTL (@ fsys = fMAX)
BETA11
70
—
– 40o C70
—
——
150o C
10511
500
—
1 The internal POR signals are V
POR15, VPOR33, and VPOR5. On power up, assert RESET before the internal POR negates.
RESET must remain asserted until the power supplies are within the operating conditions as specified in Table 9 DC Electrical
Specifications. On power down, assert RESET before any power supplies fall outside the operating conditions and until the
internal POR asserts.
2 V
3 Supply full operating current for the 1.5 V supply when the 3.3 V supply reaches this range.
4 It is possible to reach the current limit during ramp up—do not treat this event as short circuit current.
5 At peak current for device.
6 Requires compliance with Freescale’s recommended board requirements and transistor recommendations. Board signal
traces/routing from the VRCCTL package signal to the base of the external pass transistor and between the emitter of the pass
transistor to the VDD package signals must have a maximum of 100 nH inductance and minimal resistance
(less than 1
). V
RCCTL must have a nominal 1 F phase compensation capacitor to ground. VDD must have a 20 F (nominal)
bulk capacitor (greater than 4
F over all conditions, including lifetime). Place high-frequency bypass capacitors consisting of
eight 0.01
F, two 0.1 F, and one 1 F capacitors around the package on the V
DD supply signals.
7 Only available on devices that support -55o C.
8 I
VRCCTL is measured at the following conditions: VDD = 1.35 V, VRC33 = 3.1 V, VVRCCTL = 2.2 V.
9 Refer to Table 1 for the maximum operating frequency.
10 Values are based on I
DD from high-use applications as explained in the IDD Electrical Specification.
11 BETA represents the worst-case external transistor. It is measured on a per-part basis and calculated as (I
DD IVRCCTL).
Table 6. VRC and POR Electrical Specifications (continued)
Spec
Characteristic
Symbol
Min.
Max.
Units
相關PDF資料 |
PDF描述 |
|---|---|
| MAX6440UTMRRD3+T | IC BATTERY MON SNGL SOT23-6 |
| MAX6440UTLSYD3+T | IC BATTERY MON SNGL SOT23-6 |
| MPC5553EVBGHS | KIT EVAL GREEN HILLS SOFTWARE |
| MPC5553EVB | KIT EVAL MPC5553MZP132 |
| MAX6440UTLSTD7+T | IC BATTERY MON SNGL SOT23-6 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MPC5554EVBE | 功能描述:開發板和工具包 - 其他處理器 MPC5554 CUSTOMER Qorivva RoHS:否 制造商:Freescale Semiconductor 產品:Development Systems 工具用于評估:P3041 核心:e500mc 接口類型:I2C, SPI, USB 工作電源電壓: |
| MPC5554EVBE | 制造商:Freescale Semiconductor 功能描述:MPC5554 CUSTOMER DEMO BD |
| MPC5554EVBGHS | 功能描述:開發軟件 GREEN HILLS SW Qorivva RoHS:否 制造商:Atollic Inc. 產品:Compilers/Debuggers 用于:ARM7, ARM9, Cortex-A, Cortex-M, Cortex-R Processors |
| MPC5554EVBISYS | 功能描述:開發軟件 ISYSTEMS CONTENT Qorivva RoHS:否 制造商:Atollic Inc. 產品:Compilers/Debuggers 用于:ARM7, ARM9, Cortex-A, Cortex-M, Cortex-R Processors |
| MPC5554FS | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Qorivva MPC5554 Family |
發布緊急采購，3分鐘左右您將得到回復。