- 您現在的位置：買賣IC網 > PDF目錄39600 > MK2049-44SI (INTEGRATED DEVICE TECHNOLOGY INC) 51.84 MHz, OTHER CLOCK GENERATOR, PDSO20 PDF資料下載
參數資料
| 型號： | MK2049-44SI |
| 廠商： | INTEGRATED DEVICE TECHNOLOGY INC |
| 元件分類： | 時鐘產生/分配 |
| 英文描述： | 51.84 MHz, OTHER CLOCK GENERATOR, PDSO20 |
| 封裝： | 0.300 INCH, SOIC-20 |
| 文件頁數： | 7/10頁 |
| 文件大?。?/td> | 239K |
| 代理商： | MK2049-44SI |
MK2049-44
3.3 VOLT COMMUNICATIONS CLOCK PLL
VCXO AND SYNTHESIZER
IDT / ICS 3.3 VOLT COMMUNICATIONS CLOCK PLL
6
MK2049-44
REV A 050203
evaluation. Please refer to MAN05 for the procedure to
determine capacitor values.
PCB Layout Recommendations
For optimum device performance and lowest output phase
noise, the following guidelines should be observed. Please
also refer to the Recommended PCB Layout drawing on
Page 7.
1) Each 0.01 F decoupling capacitor should be mounted on
the component side of the board as close to the VDD pin as
possible. No via’s should be used between decoupling
capacitor and VDD pin. The PCB trace to VDD pin should
be kept as short as possible, as should the PCB trace to the
ground via. Distance of the ferrite bead and bulk decoupling
from the device is less critical.
2) The loop filter components must also be placed close to
the CHGP and VIN pins. CP should be closest to the device.
Coupling of noise from other system signal traces should be
minimized by keeping traces short and away from active
signal traces. Use of vias should be avoided.
3) The external crystal should be mounted just next to the
device with short traces. The X1 and X2 traces should not
be routed next to each other with minimum spaces, instead
they should be separated and away from other traces.
4) To minimize EMI the 33
series termination resistor, if
needed, should be placed close to the clock output.
5) An optimum layout is one with all components on the
same side of the board, minimizing vias through other signal
layers (the ferrite bead and bulk decoupling capacitor can be
mounted on the back). Other signal traces should be routed
away from the MK2049-44. This includes signal traces just
underneath the device, or on layers adjacent to the ground
plane layer used by the device.
MAN05 may also be referenced for additional suggestions
on layout of the crystal section.
Absolute Maximum Ratings
Stresses above the ratings listed below can cause permanent damage to the MK2049-44. These ratings, which are
standard values for ICS commercially rated parts, are stress ratings only. Functional operation of the device at
these or any other conditions above those indicated in the operational sections of the specifications is not implied.
Exposure to absolute maximum rating conditions for extended periods can affect product reliability. Electrical
parameters are guaranteed only over the recommended operating temperature range.
Recommended Operation Conditions
Item
Rating
Supply Voltage, VDD
7V
All Inputs and Outputs
-0.5V to VDD+0.5V
Ambient Operating Temperature
-40 to +85
°C
Storage Temperature
-65 to +150
°C
Junction Temperature
175
°C
Soldering Temperature
250
°C
Parameter
Min.
Typ.
Max.
Units
Ambient Operating Temperature
-40
+85
°C
Power Supply Voltage (measured in respect to GND)
+3.15
+3.3
+3.45
V
相關PDF資料 |
PDF描述 |
|---|---|
| MK2049-45ASITR | 125 MHz, OTHER CLOCK GENERATOR, PDSO20 |
| MK2049-45SITR | 125 MHz, OTHER CLOCK GENERATOR, PDSO20 |
| MK2049-45SILFTR | 125 MHz, OTHER CLOCK GENERATOR, PDSO20 |
| MK2058-01SILF | OTHER CLOCK GENERATOR, PDSO20 |
| MK2704SLF | 36.864 MHz, VIDEO CLOCK GENERATOR, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MK2049-45 | 制造商:ICS 制造商全稱:ICS 功能描述:3.3V Communications Clock PLL |
| MK2049-45ASI | 功能描述:IC CLK PLL COMM 3.3V 20-SOIC RoHS:否 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:- 標準包裝:39 系列:- 類型:* PLL:帶旁路 輸入:時鐘 輸出:時鐘 電路數:1 比率 - 輸入:輸出:1:10 差分 - 輸入:輸出:是/是 頻率 - 最大:170MHz 除法器/乘法器:無/無 電源電壓:2.375 V ~ 3.465 V 工作溫度:0°C ~ 70°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:* |
| MK2049-45ASILF | 功能描述:時鐘發生器及支持產品 3.3 VOLT COMMUNICA. CLOCK VCXO PLL RoHS:否 制造商:Silicon Labs 類型:Clock Generators 最大輸入頻率:14.318 MHz 最大輸出頻率:166 MHz 輸出端數量:16 占空比 - 最大:55 % 工作電源電壓:3.3 V 工作電源電流:1 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-56 |
| MK2049-45ASILFTR | 功能描述:時鐘發生器及支持產品 3.3 VOLT COMMUNICA. CLOCK VCXO PLL RoHS:否 制造商:Silicon Labs 類型:Clock Generators 最大輸入頻率:14.318 MHz 最大輸出頻率:166 MHz 輸出端數量:16 占空比 - 最大:55 % 工作電源電壓:3.3 V 工作電源電流:1 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-56 |
| MK2049-45ASITR | 功能描述:IC CLK PLL COMM 3.3V 20-SOIC RoHS:否 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:- 標準包裝:39 系列:- 類型:* PLL:帶旁路 輸入:時鐘 輸出:時鐘 電路數:1 比率 - 輸入:輸出:1:10 差分 - 輸入:輸出:是/是 頻率 - 最大:170MHz 除法器/乘法器:無/無 電源電壓:2.375 V ~ 3.465 V 工作溫度:0°C ~ 70°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:* |
發布緊急采購，3分鐘左右您將得到回復。