
669
11028E–ATARM–22-Apr-13
SAM9G46
35.7.3
Receiver Operations
A received frame is triggered by a start event and can be followed by synchronization data
before data transmission.
The start event is configured setting the Receive Clock Mode Register (SSC_RCMR).
SeeThe frame synchronization is configured setting the Receive Frame Mode Register
The receiver uses a shift register clocked by the receiver clock signal and the start mode
selected in the SSC_RCMR. The data is transferred from the shift register depending on the
data format selected.
When the receiver shift register is full, the SSC transfers this data in the holding register, the sta-
tus flag RXRDY is set in SSC_SR and the data can be read in the receiver holding register. If
another transfer occurs before read of the RHR register, the status flag OVERUN is set in
SSC_SR and the receiver shift register is transferred in the RHR register.
Figure 35-10. Receiver Block Diagram
35.7.4
Start
The transmitter and receiver can both be programmed to start their operations when an event
occurs, respectively in the Transmit Start Selection (START) field of SSC_TCMR and in the
Receive Start Selection (START) field of SSC_RCMR.
Under the following conditions the start event is independently programmable:
Continuous. In this case, the transmission starts as soon as a word is written in SSC_THR
and the reception starts as soon as the Receiver is enabled.
Synchronously with the transmitter/receiver
On detection of a falling/rising edge on TF/RF
On detection of a low level/high level on TF/RF
On detection of a level change or an edge on TF/RF
SSC_RFMR.MSBF
SSC_RFMR.DATNB
SSC_TCMR.START
SSC_RCMR.START
SSC_RHR
SSC_RSHR
SSC_RFMR.FSLEN
SSC_RFMR.DATLEN
RX Controller counter reached STTDLY
RX Controller
RD
SSC_CR.RXEN
SSC_CR.RXDIS
SSC_SR.RXEN
Receiver Clock
RF
TXEN
RX Start
RF
RXEN
RC0R
SSC_RCMR.STTDLY != 0
Receive Shift Register
Start
Selector
Start
Selector
RX Start
load