- 您現在的位置：買賣IC網 > PDF目錄1949 > MC7457VG733NC (Freescale Semiconductor)IC MPU RISC 733MHZ 483FCCBGA PDF資料下載
參數資料
| 型號： | MC7457VG733NC |
| 廠商： | Freescale Semiconductor |
| 文件頁數： | 50/71頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC MPU RISC 733MHZ 483FCCBGA |
| 標準包裝： | 36 |
| 系列： | MPC74xx |
| 處理器類型： | 32-位 MPC74xx PowerPC |
| 速度： | 733MHz |
| 電壓： | 1.1V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 483-BCBGA，F(xiàn)CCBGA |
| 供應商設備封裝： | 483-FCCBGA（29x29） |
| 包裝： | 托盤 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁當前第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁
MPC7457 RISC Microprocessor Hardware Specifications, Rev. 8
System Design Information
Freescale Semiconductor
54
9.2
PLL Power Supply Filtering
The AVDD power signal is provided on the MPC7457 to provide power to the clock generation PLL. To
ensure stability of the internal clock, the power supplied to the AVDD input signal should be filtered of any
noise in the 500 kHz to 10 MHz resonant frequency range of the PLL. A circuit similar to the one shown
in Figure 24 using surface mount capacitors with minimum effective series inductance (ESL) is
recommended.
The circuit should be placed as close as possible to the AVDD pin to minimize noise coupled from nearby
circuits. It is often possible to route directly from the capacitors to the AVDD pin, which is on the periphery
of the 360 CBGA footprint and very close to the periphery of the 483 CBGA footprint, without the
inductance of vias.
Figure 24. PLL Power Supply Filter Circuit
NOTE
All production 7447 and 7457 Rev. B devices require a 400
Ω resistor
instead of the 10
Ω resistor shown above. All production 7457 Rev. C
devices require a 10
Ω resistor. For more information, see the MPC7450
Family Chip Errata for the MPC7457 and MPC7447.
9.3
Decoupling Recommendations
Due to the MPC7457 dynamic power management feature, large address and data buses, and high
operating frequencies, the MPC7457 can generate transient power surges and high frequency noise in its
power supply, especially while driving large capacitive loads. This noise must be prevented from reaching
other components in the MPC7457 system, and the MPC7457 itself requires a clean, tightly regulated
source of power. Therefore, it is recommended that the system designer place at least one decoupling
capacitor at each VDD, OVDD, and GVDD pin of the MPC7457. It is also recommended that these
decoupling capacitors receive their power from separate VDD, OVDD/GVDD, and GND power planes in
the PCB, utilizing short traces to minimize inductance. If compromises must be made due to board
constraints, VDD pins should receive the highest priority for decoupling.
These capacitors should have a value of 0.01 or 0.1 F. Only ceramic surface mount technology (SMT)
capacitors should be used to minimize lead inductance, preferably 0508 or 0603 orientations where
connections are made along the length of the part. Consistent with the recommendations of Dr. Howard
Johnson in High Speed Digital Design: A Handbook of Black Magic (Prentice Hall, 1993) and contrary to
previous recommendations for decoupling Freescale microprocessors, multiple small capacitors of equal
value are recommended over using multiple values of capacitance.
In addition, it is recommended that there be several bulk storage capacitors distributed around the PCB,
feeding the VDD, GVDD, and OVDD planes, to enable quick recharging of the smaller chip capacitors.
These bulk capacitors should have a low equivalent series resistance (ESR) rating to ensure the quick
VDD
AVDD
10
Ω
2.2 F
GND
Low ESL Surface Mount Capacitors
相關PDF資料 |
PDF描述 |
|---|---|
| MC74HC4052AFG | IC MUX/DEMUX DUAL 4X1 16SOEIAJ |
| MC74HC4066AFEL | IC MUX/DEMUX QUAD 1X1 14SOEIAJ |
| MC74HC4067ADWG | IC MUX/DEMUX/QUAD SWITCH 24SOIC |
| MC74HC4316AFELG | IC MUX/DEMUX QUAD 1X1 16SOEIAJ |
| MC74HC4852AN | IC MUX/DEMUX DUAL 4X1 16DIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC7457VG867NC | 功能描述:微處理器 - MPU APOLO7 RV1.2 1.1V 105C RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
| MC74A5-33SNTR | 制造商:Rochester Electronics LLC 功能描述:- Tape and Reel |
| MC74A5-50T | 制造商:Rochester Electronics LLC 功能描述:- Tape and Reel |
| MC74AC00 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:QUAD 2-INPUT NAND GATE |
| MC74AC00D | 功能描述:邏輯門 2-6V Quad 2-Input RoHS:否 制造商:Texas Instruments 產品:OR 邏輯系列:LVC 柵極數量:2 線路數量（輸入/輸出）:2 / 1 高電平輸出電流:- 16 mA 低電平輸出電流:16 mA 傳播延遲時間:3.8 ns 電源電壓-最大:5.5 V 電源電壓-最小:1.65 V 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:DCU-8 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。