參數資料
型號: MC7457RX1000LC
廠商: Freescale Semiconductor
文件頁數: 21/71頁
文件大?。?/td> 0K
描述: IC MPU RISC 32BIT 483FCCBGA
標準包裝: 36
系列: MPC74xx
處理器類型: 32-位 MPC74xx PowerPC
速度: 1.0GHz
電壓: 1.3V
安裝類型: 表面貼裝
封裝/外殼: 483-BCBGA,F(xiàn)CCBGA
供應商設備封裝: 483-FCCBGA(29x29)
包裝: 托盤
MPC7457 RISC Microprocessor Hardware Specifications, Rev. 8
Electrical and Thermal Characteristics
Freescale Semiconductor
28
L3_CLK to high impedance: All
other outputs
tL3CHOZ
—(tL3CLK/4)
+ 0.65
—(tL3CLK/4)
+ 0.65
ns
Notes:
1. Rise and fall times for the L3_CLK output are measured from 20% to 80% of GVDD.
2. For DDR, all input specifications are measured from the midpoint of the signal in question to the midpoint voltage of the rising
or falling edge of the input L3_ECHO_CLK
n (see Figure 10). Input timings are measured at the pins.
3. For DDR, the input data will typically follow the edge of L3_ECHO_CLK
n as shown in Figure 10. For consistency with other
input setup time specifications, this will be treated as negative input setup time.
4. tL3_CLK/4 is one-fourth the period of L3_CLKn. This parameter indicates that the MPC7457 can latch an input signal that is
valid for only a short time before and a short time after the midpoint between the rising and falling (or falling and rising) edges
of L3_ECHO_CLK
n at any frequency.
5. All output specifications are measured from the midpoint voltage of the rising (or for DDR write data, also the falling) edge of
L3_CLK to the midpoint of the signal in question. The output timings are measured at the pins. All output timings assume a
purely resistive 50-
Ω load (see Figure 8).
6. For DDR, the output data will typically lead the edge of L3_CLK
n as shown in Figure 10. For consistency with other output
valid time specifications, this will be treated as negative output valid time.
7. tL3_CLK/4 is one-fourth the period of L3_CLKn. This parameter indicates that the specified output signal is actually launched
by an internal clock delayed in phase by 90°. Therefore, there is a frequency component to the output valid and output hold
times such that the specified output signal will be valid for approximately one L3_CLK period starting three-fourths of a clock
before the edge on which the SRAM will sample it and ending one-fourth of a clock period after the edge it will be sampled.
8. Assumes default value of L3OHCR. See Section 5.2.4.1, “Effects of L3OHCR Settings on L3 Bus AC Specifications,” for more
information.
9. L3 I/O voltage mode must be configured by L3VSEL as described in Table 3, and voltage supplied at GVDD must match mode
selected as specified in Table 4. See Table 22 for revision level information and part marking.
Table 13. L3 Bus Interface AC Timing Specifications for MSUG2 (continued)
At recommended operating conditions. See Table 4.
Parameter
Symbol
Device Revision (L3 I/O Voltage) 9
Unit
Notes
Rev 1.1. (All I/O Modes)
Rev 1.2 (1.5-V I/O Mode)
Rev 1.2
(1.8-, 2.5-V I/O Modes)
Min
Max
Min
Max
相關PDF資料
PDF描述
XF2B-3545-31A CONN FPC 35POS 0.3MM PITCH SMD
MPC8547EVTAUJB MPU POWERQUICC III 783-PBGA
IDT7005L17J IC SRAM 64KBIT 17NS 68PLCC
XC4028XL-2HQ304I IC FPGA I-TEMP 3.3V 2SPD 304HQFP
ACB105DHAT CONN EDGECARD 210PS R/A .050 DIP
相關代理商/技術參數
參數描述
MC7457RX1000NB 制造商:Motorola Inc 功能描述:
MC7457RX1000NC 功能描述:微處理器 - MPU APOLO7 RV1.2 1.1V 105C RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324
MC7457RX1200PB 制造商:Freescale Semiconductor 功能描述:A7, 1.35V +50MV/-30MV - Trays
MC7457RX1267LB 制造商:Freescale Semiconductor 功能描述:MPC74XX RISC 32-BIT 0.13UM 1.267GHZ 1.5V/1.8V/2.5V 483-PIN F - Trays
MC7457RX1267LC 功能描述:微處理器 - MPU APOLO7 RV1.2 1.3V 105C RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324