- 您現在的位置：買賣IC網 > PDF目錄385553 > MAX8621Y (Maxim Integrated Products, Inc.) Dual Step-Down DC-DC Power-Management ICs for Portable Devices PDF資料下載
參數資料
| 型號： | MAX8621Y |
| 廠商： | Maxim Integrated Products, Inc. |
| 英文描述： | Dual Step-Down DC-DC Power-Management ICs for Portable Devices |
| 中文描述： | 雙路、降壓型DC-DC電源管理IC，用于便攜式設備 |
| 文件頁數： | 9/18頁 |
| 文件大小： | 360K |
| 代理商： | MAX8621Y |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁
M
Dual Step-Down DC-DC Power-Management ICs
for Portable Devices
_______________________________________________________________________________________
9
Pin Description
PIN
1
2
3
NAME
FB1
FB2
GND
FUNCTION
Voltage Feedback for Step-Down Converter 1. FB1 regulates to 0.6V nominal.
Voltage Feedback for Step-Down Converter 2. FB2 regulates to 0.6V nominal.
Ground. Ground for all LDOs and the control section.
Reference Noise Bypass. Connect a 0.01μF ceramic capacitor from REFBP to GND. Not intended to drive resistive
load. REFBP is high impedance in shutdown.
Enable Input for OUT4. Drive EN4 high to turn on OUT4.
150mA LDO4 output. Bypass OUT4 to GND with a 2.2μF ceramic capacitor. OUT4 is high impedance when
disabled. OUT4 can only be activated if OUT1 is within 87% of regulation.
Enable Input for OUT3. Drive EN3 high to turn on OUT3.
4
REFBP
5
EN4
6
OUT4
7
EN3
8
EN2
Enable Input for OUT2. Drive
EN2
high to disable OUT2. Drive
EN2
low or leave open to enable OUT2.
EN2
is
internally pulled to GND by an 800k
Ω
(typ) pulldown resistor. If the MAX8621Y/MAX8621Z are placed into shutdown
using PWRON (PWRON = low), OUT2 does not power regardless of the status of
EN2
.
9
OUT2
300mA LDO2 Output. Bypass with a 4.7μF ceramic capacitor to GND. OUT2 is high impedance when disabled.
OUT2 can only be activated if OUT1 is within 87% of regulation.
10
IN2
Supply Voltage to the Output MOSFET of All 4 LDOs. IN2 must be shorted to IN1 and IN3. Connect a 4.7μF ceramic
capacitor from IN2 to GND.
11
RESET
Open-Drain, Active-Low Reset Output.
RESET
asserts low when V
OUT1
drops below 87% (typ) of regulation.
RESET
deasserts 60ms after V
OUT1
rises above 87% (typ) of regulation (Figure 2).
300m A LD O1 O utp ut. Byp ass w h a 4.7μF cer am c cap aci or to G N D OU T1 i s hi g h i m p ed ance w hen d sab ed
150mA LDO3 Output. Bypass OUT3 to GND with a 2.2μF ceramic capacitor. OUT3 is high impedance when
disabled. OUT3 can only be activated if OUT1 is within 87% of regulation.
12
OUT1
13
OUT3
14
PWRON
Power Enable Input. Drive PWRON high to enable the MAX8621Y/MAX8621Z. Drive PWRON low to enter shutdown
mode. PWRON has an internal 800k
Ω
(typ) pulldown resistor.
Enable Input for DR. Drive ENDR low for DR to go into high impedance. Drive ENDR high to activate DR, pulling
DR low.
15
ENDR
16
IN3
Supply Voltage to the Control Section. IN3 must be shorted to IN1 and IN2. Connect a 4.7μF ceramic capacitor from
IN3 to GND.
17
SEL2
LDO Output-Voltage Select Input 2. SEL1 and SEL2 set the OUT1, OUT2, OUT3, and OUT4 voltages to one of nine
combinations (Table 1).
18
SEL1
LDO Output-Voltage Select Input 1. SEL1 and SEL2 set the OUT1, OUT2, OUT3, and OUT4 voltages to one of nine
combinations (Table 1).
19
DR
200mA Driver Output. Connects to the open drain of an internal n-channel MOSFET whose gate is controlled by
ENDR.
PGND2 Power Ground for BUCK2 and DR Switch
Inductor Connection for BUCK2. LX2 is internally connected to the drain of the internal p-channel MOSFET and the
drain of the internal n-channel synchronous rectifier for BUCK2. LX2 is high impedance when BUCK2 is disabled.
20
21
LX2
22
IN1
Supply Voltage to the Output Stage of BUCK1 and BUCK2. IN1 must be shorted to IN2 and IN3. Connect a 10μF
ceramic capacitor from IN1 to GND.
23
LX1
Inductor Connection for BUCK1. LX1 is internally connected to the drain of the internal p-channel MOSFET and the
drain of the internal n-channel synchronous rectifier for BUCK1. LX1 is high impedance when BUCK1 is disabled.
PGND1 Power Ground for BUCK1
EP
Exposed Paddle. Connect the exposed paddle to GND, PGND1, and PGND2.
24
—
相關PDF資料 |
PDF描述 |
|---|---|
| MAX8621ZETG | Dual Step-Down DC-DC Power-Management ICs for Portable Devices |
| MAX863 | Dual, High-Efficiency, PFM, Step-Up DC-DC Controller(雙輸出,高效,PFM,步升DC-DC變換器) |
| MAX870C | TV 55C 55#20 PIN WALL RECP |
| MAX870D | Switched-Capacitor Voltage Inverters |
| MAX871 | Switched-Capacitor Voltage Inverters |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX8621YETG | 功能描述:PMIC 解決方案 RoHS:否 制造商:Texas Instruments 安裝風格:SMD/SMT 封裝 / 箱體:QFN-24 封裝:Reel |
| MAX8621YETG+ | 功能描述:PMIC 解決方案 Dual Step-Down PMIC for Portable Devices RoHS:否 制造商:Texas Instruments 安裝風格:SMD/SMT 封裝 / 箱體:QFN-24 封裝:Reel |
| MAX8621YETG+T | 功能描述:PMIC 解決方案 Dual Step-Down PMIC for Portable Devices RoHS:否 制造商:Texas Instruments 安裝風格:SMD/SMT 封裝 / 箱體:QFN-24 封裝:Reel |
| MAX8621YETG-T | 功能描述:PMIC 解決方案 RoHS:否 制造商:Texas Instruments 安裝風格:SMD/SMT 封裝 / 箱體:QFN-24 封裝:Reel |
| MAX8621ZETG | 功能描述:PMIC 解決方案 Dual Step-Down PMIC for Portable Devices RoHS:否 制造商:Texas Instruments 安裝風格:SMD/SMT 封裝 / 箱體:QFN-24 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。