- 您現在的位置：買賣IC網 > PDF目錄383327 > MAX16049ETN (Maxim Integrated Products, Inc.) Hold function, Loop detection; Vin (V) max.: 24; Icc (mA) max.: 6.45; Fmax (kHz) max.: 400; Topr [Tjopr] (°C): -40 to +125; Remarks: Power factor collection; Package: SOP; Pin count: 16 PDF資料下載
參數資料
| 型號： | MAX16049ETN |
| 廠商： | Maxim Integrated Products, Inc. |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | Hold function, Loop detection; Vin (V) max.: 24; Icc (mA) max.: 6.45; Fmax (kHz) max.: 400; Topr [Tjopr] (°C): -40 to +125; Remarks: Power factor collection; Package: SOP; Pin count: 16 |
| 中文描述： | 12-Channel/8-Channel EEPROM的可編程系統的故障寄存器經理非易失 |
| 文件頁數： | 43/62頁 |
| 文件大?。?/td> | 535K |
| 代理商： | MAX16049ETN |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁當前第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁
M
Independent Watchdog Timer Operation
When r4Dh[3] is ‘1,’ the watchdog timer operates in the
independent mode. In the independent mode, the
watchdog timer operates as if it were a separate chip.
The watchdog timer is activated immediately upon V
CC
exceeding UVLO and once the boot-up sequence is
finished. If
RESET
is asserted by the sequencer state
machine, the watchdog timer and WDO will not be
affected.
There will be a long startup delay if r55h[6] is a ‘1.’ If
r55h[6] is a ‘0,’ there will not be a long startup delay.
In independent mode, if the Watchdog
RESET
Output
Enable bit r55h[7] is set to ‘1,’ when the watchdog timer
expires, WDO will be asserted then
RESET
will be
asserted. WDO will then be deasserted. WDO will be
low for 3 system clock cycles or approximately 1μs. If
the Watchdog
RESET
Output Enable bit (r55h[7]) is set
to ‘0,’ when the WDT expires, WDO will be asserted but
RESET
will not be affected.
Miscellaneous
Table 24 lists several miscellaneous programmable
items. Register r5Ch provides storage space for a user-
defined configuration or firmware version number. Bit
r5Dh[0] locks and unlocks the configuration registers.
Bit r5Dh[1] locks and unlocks EEPROM addresses 00h
to 11h. The r65h[2:0] bits contain a read-only manufac-
turing revision code.
Write data to EEPROM r5Dh as normally done; howev-
er, to toggle a bit in register r5Dh, write a ‘1’ to that bit.
Table 24. Miscellaneous Settings
REGISTER/
EEPROM
ADDRESS
BIT RANGE
DESCRIPTION
5Ch
[7:0]
User Identification. 8 bits of memory for user-defined identification
[0]
Configuration Lock
0 = Configuration registers writable
1 = Configuration registers (RAM and EEPROM) [except r5Dh] locked
[1]
EEPROM Lock Flag (set automatically after fault log is triggered):
0 = EEPROM is not locked. A triggered fault log stores fault information to EEPROM.
1 = EEPROM addresses 00h to 11h are locked. Write a ‘1’ to this bit to toggle the flag.
5Dh
[7:2]
[2:0]
[7:3]
Not used
Manufacturing revision code. This register is read only. Not stored in EEPROM.
Not used
65h
12-Channel/8-Channel EEPROM-Programmable
System Managers with Nonvolatile Fault Registers
______________________________________________________________________________________
43
相關PDF資料 |
PDF描述 |
|---|---|
| MAX16048 | 12-Channel/8-Channel EEPROM-Programmable System Managers with Nonvolatile Fault Registers |
| MAX16046 | 12-Channel/8-Channel EEPROM-Programmable System Managers with Nonvolatile Fault Registers |
| MAX16050 | Voltage Monitors/Sequencer Circuits with Reverse-Sequencing Capability |
| MAX1605ETT-T | 30V Internal Switch LCD Bias Supply |
| MAX1605EUT-T | 30V Internal Switch LCD Bias Supply |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX16049ETN+ | 功能描述:監控電路 8Ch EEPROM Prob System Manager RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| MAX16049ETN+T | 功能描述:監控電路 8Ch EEPROM Prob System Manager RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| MAX1604EAI | 功能描述:電源開關 IC - 配電 RoHS:否 制造商:Exar 輸出端數量:1 開啟電阻（最大值）:85 mOhms 開啟時間（最大值）:400 us 關閉時間（最大值）:20 us 工作電源電壓:3.2 V to 6.5 V 電源電流（最大值）: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-5 |
| MAX1604EAI+ | 功能描述:電源開關 IC - 配電 RoHS:否 制造商:Exar 輸出端數量:1 開啟電阻（最大值）:85 mOhms 開啟時間（最大值）:400 us 關閉時間（最大值）:20 us 工作電源電壓:3.2 V to 6.5 V 電源電流（最大值）: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-5 |
| MAX1604EAI+T | 功能描述:電源開關 IC - 配電 RoHS:否 制造商:Exar 輸出端數量:1 開啟電阻（最大值）:85 mOhms 開啟時間（最大值）:400 us 關閉時間（最大值）:20 us 工作電源電壓:3.2 V to 6.5 V 電源電流（最大值）: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-5 |
發布緊急采購，3分鐘左右您將得到回復。