參數資料
型號： M37531
廠商： Mitsubishi Electric Corporation
英文描述： Single Chip 8 Bits CMOS Microcomputer(8位單片機)
中文描述： 單芯片的CMOS 8位單片機（8位單片機）
文件頁數： 22/64頁
文件大小： 631K
代理商： M37531
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
7531 Group
MITSUBISHI MICROCOMPUTERS
22
Fig. 25 Continuous transmission operation of UART serial I/O
[Serial I/O1 control register] SIO1CON
The serial I/O1 control register consists of eight control bits for the
serial I/O1 function.
[UART control register] UARTCON
The UART control register consists of four control bits (bits 0 to 3)
which are valid when asynchronous serial I/O is selected and set the
data format of an data transfer. One bit in this register (bit 4) is al-
ways valid and sets the output structure of the P1
1
/TxD pin.
[Serial I/O1 status register] SIO1STS
The read-only serial I/O1 status register consists of seven flags (bits
0 to 6) which indicate the operating status of the serial I/O function
and various errors.
The receive buffer full flag (bit 1) is cleared to “0” when the receive
buffer is read.
If there is an error, it is detected at the same time that data is trans-
ferred from the receive shift register to the receive buffer, and the
receive buffer full flag is set. A write to the serial I/O1 status register
clears all the error flags OE, PE, FE, and SE (bit 3 to bit 6, respec-
tively). Writing “11” to bits 7 and 6 of the serial I/O1 control register
initializes this register.
All bits of the serial I/O1 status register are initialized to “81
16
” at
reset.
[Transmit/Receive buffer register] TB/RB
The transmit buffer and the receive buffer are located at the same
address. The transmit buffer is write-only and the receive buffer is
read-only. If a character bit length is 7-bit, the MSB of data stored in
the receive buffer is "0".
[Baud Rate Generator] BRG
The baud rate generator determines the baud rate for serial transfer.
The baud rate generator divides the frequency of the count source
by 1/(n + 1), where n is the value written to the baud rate generator.
TSC=0
TBE=1
TBE=0
ST
D
0
D
1
SP
D
0
D
1
ST
SP
ST
1 :
When the serial I/O1 enable bit (b7) is “1”, the transmit enable bit is “1”, and continuous transmit valid bit is “1”, writing on the
transmit buffer initiates continuous transmission of the same data.
2 :
Select 0 for continuous transmit valid bit to stop continuous transmission.
The T
X
D pin will stop at high level after completing transmission of 1 byte.
3 :
If the transmit buffer contents are rewritten during a continuous transmission, transmission of the rewritten data will be started after
completing transmission of 1 byte.
Notes
1 Start Bit
7 or 8 Data Bit
1 or 0 Parity Bit
1 or 2 Stop Bit
Transmit/Receive Clock
Transmit Buffer Register
Write Signal
Serial Output T
X
D
相關PDF資料
PDF描述
M37534 Single Chip 8 Bits CMOS Microcomputer(8位單片機)
M37700 16-Bit Single-Chip Microcomputer(16位單片微控制器)
M37721 16-Bit Single-Chip Microcomputer(16位單片微控制器)
M37733MHB Single Chip 16 Bits CMOS Microcomputer(16位單片機)
M37735S4L Single Chip 16 Bits CMOS Microcomputer(16位單片機)
相關代理商/技術參數
參數描述
M37531E4FP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M37531E4FP#U0 制造商:Renesas Electronics Corporation 功能描述:MITSUBISHI 8 BIT OTP MCU
M37531E4GP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M37531E4SP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M37531E8FP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*