參數資料
型號: M37221M4-XXXSP
元件分類: 微控制器/微處理器
英文描述: 8-BIT, MROM, 8.1 MHz, MICROCONTROLLER, PDIP42
封裝: 0.600 INCH, 1.78 MM PITCH, PLASTIC, SDIP-42
文件頁數: 90/114頁
文件大?。?/td> 1653K
代理商: M37221M4-XXXSP
76
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER for VOLTAGE SYNTHESIZER
with ON-SCREEN DISPLAY CONTROLLER
M37221M4/M8/MA–XXXSP, M37221M6–XXXSP/FP
M37221EASP/FP
MITSUBISHI MICROCOMPUTERS
Rev. 1.0
8.14 CLOCK GENERATING CIRCUIT
The built-in clock generating circuit is shown in Figure 8.13.3. When
the STP instruction is executed, the internal clock
φ stops at HIGH.
At the same time, timers 3 and 4 are connected by hardware and
“FF16” is set in timer 3 and “0716” is set in the timer 4. Select f(XIN)/16
as the timer 3 count source (set bit 0 of the timer mode register 2 to
“0” before the execution of the STP instruction). Moreover, set the
timer 3 and timer 4 interrupt enable bits to disabled (“0”) before ex-
ecution of the STP instruction). The oscillator restarts when external
interrupt is accepted. However, the internal clock
φ keeps its HIGH
until timer 4 overflows, allowing time for oscillation stabilization when
a ceramic resonator or a quartz-crystal oscillator is used.
When the WIT instruction is executed, the internal clock
φ stops in
the HIGH but the oscillator continues running. This wait state is re-
leased when an interrupt is accepted (See note). Since the oscillator
does not stop, the next instruction can be executed at once.
When returning from the stop or the wait state, to accept an interrupt,
set the corresponding interrupt enable bit to “1” before executing the
STP or the WIT instructions.
Note: In the wait mode, the following interrupts are invalid.
VSYNC interrupt
OSD interrupt
Timer 2 interrupt using external clock input from TIM2 pin as count
source
Timer 3 interrupt using external clock input from TIM3 pin as count
source
Timer 4 interrupt using f(XIN)/2 as count source
Timer 1 interrupt using f(XIN)/4096 as count source
f(XIN)/4096 interrupt
Multi-master I2C-BUS interface interrupt
A circuit example using a ceramic resonator (or a quartz-crystal os-
cillator) is shown in Figure 8.14.1. Use the circuit constants in accor-
dance with the resonator manufacture’s recommended values. A cir-
cuit example with external clock input is shown in Figure 8.14.2. In-
put the clock to the XIN pin, and open the XOUT pin.
Fig. 8.14.1 Ceramic Resonator Circuit Example
Fig. 8.14.2 External Clock Input Circuit Example
XIN
XOUT
CIN
Microcomputer
COUT
XIN
Microcomputer
Vcc
Vss
External oscillation circuit
Fig. 8.14.3 Clock Generating Circuit Block Diagram
Interrupt request
Interrupt disable
flag I
Reset
S
Q
R
STP instruction
S
Q
R
WIT
instruction
S
Q
R
STP
instruction
Reset
Internal clock
φ
1/2
1/8
Timer 3
Timer 4
XOUT
XIN
T34M0
T34M2
Selection gate :
Connected to black
side at reset.
T34M :
Timer 34 mode register
相關PDF資料
PDF描述
M37224M3-XXXSP 8-BIT, MROM, 8.1 MHz, MICROCONTROLLER, PDIP42
M37225M6-XXXSP 8-BIT, MROM, 8.1 MHz, MICROCONTROLLER, PDIP42
M37225MA-XXXSP 8-BIT, MROM, 8.1 MHz, MICROCONTROLLER, PDIP42
M37225MC-XXXSP 8-BIT, MROM, 8.1 MHz, MICROCONTROLLER, PDIP42
M37225ECSP 8-BIT, OTPROM, 8.1 MHz, MICROCONTROLLER, PDIP42
相關代理商/技術參數
參數描述
M37221M6 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER for VOLTAGE SYNTHESIZER with ON-SCREEN DISPLAY CONTROLLER
M37221M6_03 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER for VOLTAGE SYNTHESIZER with ON-SCREEN DISPLAY CONTROLLER
M37221M6-054SP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER for VOLTAGE SYNTHESIZER
M37221M6-079SP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER for VOLTAGE SYNTHESIZER
M37221M6-286SP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER for VOLTAGE SYNTHESIZER