![](http://datasheet.mmic.net.cn/30000/M30260M3A-XXXGP-U5_datasheet_2358673/M30260M3A-XXXGP-U5_345.png)
REVISION HISTORY
M16C/26A Hardware Manual
Rev.
Date
Description
Page
Summary
C-3
169
Table 14.1 is partly revised.
172
Figure 14.4 is partly revised.
173
Figure 14.5 is partly revised.
178
The section “14.1.3. Single Sweep Mode” is partly revised.
184
The section “14.1.6 Simultaneous Sample sweep Mode” is partly revised.
187
The section “14.1.7 Delayed Trigger Mode 0” and Table 15.1.7.1 are partly revised.
188
Figure 14.1.7.1 is revised.
189, 190 Figure 14.1.7.2 and 14.1.7.3 are revised
191
Figure 14.1.7.3 is deleted.
192
Figure 14.1.7.6 is partly revised.
193
The section “14.1.8 Delayed Trigger Mode 1” and Table 15.1.8.1 are partly revised.
195, 196 Figure 14.1.8.2 and 14.1.8.3 are partly revised.
200
Figure 14.5.1 is partly revised.
202
The chapter “15. CRC Calculation Circuit” is partly revised.
204
Figure 15.3 is partly revised.
205
The chapter “16. Programmable I/O Ports” is partly revised.
206
The section “16.5 Pin Assignment Control register(PACR)” is partly revised.
214
“Pull-up control register 2” in Figure 16.3.1 is partly revised.
222
Table 17.4 and 17.5 are revised partly revised. Note 6 and 10 are partly revised.
223
Note 3 in Table 17.6 is added.
241
Table 17.41 and 17.42 are revised partly revised. Note 10 is partly revised.
242
Note 3 in Table 17.43 is added.
257 to 268 The section “17.3 V version” is deleted.
269
Table 18.1 is partly revised.
270 to 227 Setction “18.2. Memory Map” and Figure18.2.3 and 18.2.4 are revised.
280
“FMR17 Bit” in the section 18.5.2 is partly revised.
269 to 300 Chapter “18. Flash memory Version” is revised.
302
Capter “20 Difference between M16C/26A and M16C/27” is partly revised.
1.00 Mar/15/05 All pages Word standardized (on-chip oscillator, A/D)
1
“M16C/26T” in “1. Overview” is added.
2,3
Table 1.1 and Table 1.2 are revised.
6
“1.4 Product List” and Table 1.3 to 1.5 are revised.
7
“ROM/RAM capacity” and “Product code” in Figure 1.3 are partly revised.
Table 1.6 is added.
8
“Figure 1.4 Marking Diagram” is added.
9, 10
The 24 and 25 pin in Figure 1.5 and the 27 and 28 pin in Figure 1.6 are revised.
11
“Power supply input” in Talbe 1.6 is revised. “I/O port P6” and “/O port P7” are
partly revised.
12
“I/O prot P9” is partly revised.