- 您現在的位置：買賣IC網 > PDF目錄45010 > M30100M2-XXXFP 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP32 PDF資料下載
參數資料
| 型號： | M30100M2-XXXFP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP32 |
| 封裝： | 7 X 7 MM, 0.80 MM PITCH, PLASTIC, LQFP-32 |
| 文件頁數： | 18/166頁 |
| 文件大?。?/td> | 2060K |
| 代理商： | M30100M2-XXXFP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁
Under
development
Tentative Specifications REV.E1
Specifications in this manual are tentative and subject to change.
Mitsubishi microcomputers
M30100/M30102 Group
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
A-D Converter
111
A-D Converter
The A-D converter consists of one 10-bit successive approximation A-D converter circuit with a capacitive
coupling amplifier. Pins P00 to P07, P10 to P13, P40 and P41 also function as the analog signal input pins.
The direction registers of these pins for A-D conversion must therefore be set to input. The Vref connect bit
(bit 5 at address 00D716) can be used to isolate the resistance ladder of the A-D converter from the refer-
ence voltage input pin (VREF) when the A-D converter is not used. Doing so stops any current flowing into
the resistance ladder from VREF, reducing the power dissipation. When using the A-D converter, start A-D
conversion only after connecting to VREF.
The result of A-D conversion is stored in the A-D registers. When set to 10-bit precision, the low 8 bits are
stored in the even addresses and the high 2 bits in the odd addresses. When set to 8-bit precision, the low
8 bits are stored in the even addresses.
Table 1.16.1 shows the performance of the A-D converter. Figure 1.16.1 shows the block diagram of the A-
D converter, and Figures 1.16.2 and 1.16.3 show the A-D converter-related registers.
Table 1.16.1. Performance of A-D converter
Item
Performance
Method of A-D conversion Successive approximation (capacitive coupling amplifier)
Analog input voltage (Note 1) 0V to VCC
Operating clock
φAD (Note 2) VCC = 5V
fAD, divide-by-2 of fAD, divide-by-4 of fAD, fAD=f(XIN)
VCC = 3V
divide-by-2 of fAD, divide-by-4 of fAD, fAD=f(XIN)
Resolution
8-bit or 10-bit (selectable)
Absolute precision
VCC = 5V
Without sample and hold function
±3LSB
With sample and hold function (8-bit resolution)
±2LSB
With sample and hold function (10-bit resolution)
AN0 to AN11 input :
±3LSB
ANEX0 and ANEX1 input (including mode in which external
operation amp is connected) :
±7LSB
VCC = 3V
Without sample and hold function (8-bit resolution)
±2LSB
Operating modes
One-shot mode and repeat mode (Note 3)
Analog input pins
12 pins (AN0 to AN11) + 2 pins (ANEX0 to ANEX1)
A-D conversion start condition Software trigger
A-D conversion starts when the A-D conversion start flag changes to “1”
Conversion speed per pin Without sample and hold function
8-bit resolution: 49
φAD cycles, 10-bit resolution: 59 φAD cycles
With sample and hold function
8-bit resolution: 28
φAD cycles, 10-bit resolution: 33 φAD cycles
Note 1: Does not depend on use of sample and hold function.
Note 2: Divide fAD if (XIN) exceeds 10MHz, and make
φAD equal to or lower than 10MHz. Also if Vcc is less
than 4.2V or an external RC circuit is used for the main clock, divide fAD and make
φAD equal to or
lower than fAD/2.
Without sample and hold function, set the
φAD frequency to 250kHz min.
With the sample and hold function, set the
φAD frequency to 1MHz min.
Note 3: In repeat mode, only 8-bit mode can be used.
相關PDF資料 |
PDF描述 |
|---|---|
| M30100F3TFP | 16-BIT, FLASH, 16 MHz, MICROCONTROLLER, PQFP32 |
| M30100M3-XXXFP | 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP32 |
| M30100M3T-XXXFP | 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP32 |
| M301N2M8T-XXXFP | 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP48 |
| M301N2M4T-XXXFP | 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP48 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M30100T3-RPD-E | 制造商:Renesas Electronics Corporation 功能描述:DEV EMULATOR POD M16C/10 SERIES - Bulk |
| M30100T-PTC | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:Converter for Connecting 32-pin 0.8mm-pitch QFP for M30100T-PRB (for M16C/10 Group M30100) |
| M30-1010046 | 功能描述:集管和線殼 1.25MM FEMALE CRIMP TIN PK OF 105 RoHS:否 產品種類:1.0MM Rectangular Connectors 產品類型:Headers - Pin Strip 系列:DF50 觸點類型:Pin (Male) 節距:1 mm 位置/觸點數量:16 排數:1 安裝風格:SMD/SMT 安裝角:Right 端接類型:Solder 外殼材料:Liquid Crystal Polymer (LCP) 觸點材料:Brass 觸點電鍍:Gold 制造商:Hirose Connector |
| M3010102636207.32LLZZ | 制造商:3M Electronic Products Division 功能描述:QUOTE # V05-0068 |
| M30102 | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
發布緊急采購，3分鐘左右您將得到回復。