- 您現在的位置：買賣IC網 > PDF目錄44996 > LTC4215CUFD-3 (LINEAR TECHNOLOGY CORP) 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC24 PDF資料下載
參數資料
| 型號： | LTC4215CUFD-3 |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 電源管理 |
| 英文描述： | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC24 |
| 封裝： | 4 X 5 MM, PLASTIC, MO-220, QFN-24 |
| 文件頁數： | 9/28頁 |
| 文件大?。?/td> | 307K |
| 代理商： | LTC4215CUFD-3 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
LTC4215-1/LTC4215-3
17
421513fc
Current Limit Stability
For many applications the LTC4215-1/LTC4215-3 current
limits will be stable without additional components. How-
ever there are certain conditions where additional compo-
nents may be needed to improve stability. The dominant
pole of the current limit circuit is set by the capacitance
and resistance at the gate of the external MOSFET, and
larger gate capacitance makes the current limit loop more
stable. Usually a total of 8nF gate to source capacitance
is sufcient for stability and is typically provided by in-
herent MOSFET CGS, however the stability of the loop is
degraded by increasing RSENSE or by reducing the size of
the resistor on a gate RC network if one is used, which
may require additional gate to source capacitance. Board
level short-circuit testing is highly recommended as board
layout can also affect transient performance, for stability
testing the worst case condition for current limit stabil-
ity occurs when the output is shorted to ground after a
normal start-up.
There are two possible parasitic oscillations when the
MOSFET operates as a source follower when ramping
at power-up or during current limiting. The rst type of
oscillation occurs at high frequencies, typically above
1MHz. This high frequency oscillation is easily damped
with R5 as shown in Figure 1. In some applications, one
may nd that R5 helps in short-circuit transient recovery
as well. However, too large of an R5 value will slow down
the turn-off time. The recommended R5 range is between
5Ω and 500Ω.
The second type of source follower oscillation occurs
at frequencies between 200kHz and 800kHz due to load
capacitance being between 0.2μF and 9μF, the presence
of R5 resistance, the absence of a drain bypass capacitor,
a combination of bus wiring inductance and bus supply
output impedance. To prevent the second type of oscillation
avoid load capacitance below 10μF, alternately connect an
external capacitor from the MOSFET gate to ground with
a value greater than 1.5nF.
Supply Transients
The LTC4215-1/LTC4215-3 are designed to ride through
supply transients caused by load steps. If there is a shorted
load and the parasitic inductance back to the supply is
greater than 0.5μH, there is a chance that the supply col-
lapses before the active current limit circuit brings down
the GATE pin. If this occurs, the undervoltage monitors
pull the GATE pin low. The undervoltage lockout circuit
has a 2μs lter time after VDD drops below 2.74V. The UV
pin reacts in 2μs to shut the GATE off, but it is recom-
mended to add a lter capacitor CF to prevent unwanted
shutdown caused by a transient. Eventually either the UV
pin or undervoltage lockout responds to bring the current
under control before the supply completely collapses.
Supply Transient Protection
The LTC4215-1/LTC4215-3 are safe from damage with
supply voltages up to 24V. However, spikes above 24V
may damage the part. During a short-circuit condition,
Figure 5. Recommended Layout
APPLICATIONS INFORMATION
UV
OV
SS
GND
ON
EN
SDAO
FB
GPIO1
INTVCC
TIMER
ADIN
GPIO3
ADR1
V
DD
SENSE
+
SENSE
–
GA
TE
SOURCE
SDAI
SCL
GPIO2
NC
ADR0
R2
R3
CF
Z1
R1
SENSE RESISTOR RS
C3
LTC4215-1
R8
ILOAD
4215 F05
ILOAD
相關PDF資料 |
PDF描述 |
|---|---|
| LTC4215IUFD-3#PBF | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC24 |
| LTC4222CG#PBF | 2-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO36 |
| LTC4222CG#TRPBF | 2-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO36 |
| LTC4222IUH#TRPBF | 2-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC32 |
| LTC4222IUH#PBF | 2-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC32 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC4215CUFD-3#PBF | 功能描述:IC CTRLR HOT SWAP 24-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:119 系列:- 類型:熱交換控制器 應用:通用型，PCI Express? 內部開關:無 電流限制:- 電源電壓:3.3V，12V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:80-TQFP 供應商設備封裝:80-TQFP（12x12） 包裝:托盤 產品目錄頁面:1423 (CN2011-ZH PDF) |
| LTC4215CUFD-3#TRPBF | 功能描述:IC CTRLR HOT SWAP 24-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:119 系列:- 類型:熱交換控制器 應用:通用型，PCI Express? 內部開關:無 電流限制:- 電源電壓:3.3V，12V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:80-TQFP 供應商設備封裝:80-TQFP（12x12） 包裝:托盤 產品目錄頁面:1423 (CN2011-ZH PDF) |
| LTC4215IGN | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Hot Swap Controller with I2C Compatible Monitoring |
| LTC4215IGN#PBF | 功能描述:IC CNTRLR HOT SWAP 16-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:119 系列:- 類型:熱交換控制器 應用:通用型，PCI Express? 內部開關:無 電流限制:- 電源電壓:3.3V，12V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:80-TQFP 供應商設備封裝:80-TQFP（12x12） 包裝:托盤 產品目錄頁面:1423 (CN2011-ZH PDF) |
| LTC4215IGN#TRPBF | 功能描述:IC CNTRLR HOT SWAP 16-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:119 系列:- 類型:熱交換控制器 應用:通用型，PCI Express? 內部開關:無 電流限制:- 電源電壓:3.3V，12V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:80-TQFP 供應商設備封裝:80-TQFP（12x12） 包裝:托盤 產品目錄頁面:1423 (CN2011-ZH PDF) |
發布緊急采購，3分鐘左右您將得到回復。