參數資料
型號： LTC4098EUDC-1#TRPBF
廠商： LINEAR TECHNOLOGY CORP
元件分類： 穩壓器
英文描述： BATTERY CHARGE CONTROLLER, 2650 kHz SWITCHING FREQ-MAX, PQCC20
封裝： 4 X 3 MM, 0.75 MM HEIGHT, LEAD FREE, PLASTIC, QFN-20
文件頁數： 8/32頁
文件大?。?/td> 443K
代理商： LTC4098EUDC-1#TRPBF
LTC4098/LTC4098-1
16
40981fc
With Bat-Track, battery charger efficiency is approximately:
ηTOTAL =ηBUCK
BAT
+ 0.3V
With the same assumptions as above, the total battery
charger efficiency is approximately 81%. This example
works out to less than 1W of power dissipation, or almost
60% less heat.
See the Typical Applications section for complete circuits
using the LT3653 and LT3480 with Bat-Track control.
Overvoltage Protection
The LTC4098/LTC4098-1 can protect itself from the inad-
vertent application of excessive voltage to VBUS or WALL
with just two external components: an N-channel FET and
a 6.04k resistor. The maximum safe overvoltage magnitude
will be determined by the choice of the external NMOS and
its associated drain breakdown voltage.
The overvoltage protection module consists of two pins.
The first, OVSENS, is used to measure the externally ap-
plied voltage through an external resistor. The second,
OVGATE, is an output used to drive the gate pin of an
external FET. The voltage at OVSENS will be lower than
the OVP input voltage by (IOVSENS 6.04k) due to the
OVP circuit’s quiescent current. The OVP input will be
200mV to 400mV higher than OVSENS under normal
operating conditions. When OVSENS is below 6V, an in-
ternal charge pump will drive OVGATE to approximately
1.88 OVSENS. This will enhance the N-channel FET and
provide a low impedance connection to VBUS or WALL
which will, in turn, power the LTC4098/LTC4098-1. If
OVSENS should rise above 6V (6.35V OVP input) due to
a fault or use of an incorrect wall adapter, OVGATE will
be pulled to GND, disabling the external FET to protect
downstream circuitry. When the voltage drops below 6V
again, the external FET will be reenabled.
In an overvoltage condition, the OVSENS pin will be
clamped at 6V. The external 6.04k resistor must be sized
appropriately to dissipate the resultant power. For example,
a 1/10W 6.04k resistor can have at most √PMAX 6.04kΩ
= 24V applied across its terminals. With the 6V at OVSENS,
the maximum overvoltage magnitude that this resistor can
withstand is 30V. A 1/4W 6.04k resistor raises this value
to 44V. WALL’s absolute maximum current rating of 10mA
imposes an upper protection limit of 66V.
The charge pump output on OVGATE has limited output
drive capability. Care must be taken to avoid leakage on
this pin, as it may adversely affect operation.
See the Applications Information section for examples of
multiple input protection, reverse input protection, and a
table of recommended components.
Ideal Diode from BAT to VOUT
The LTC4098/LTC4098-1 have an internal ideal diode as
well as a controller for an external ideal diode. Both the
internal and the external ideal diodes are always on and
will respond quickly whenever VOUT drops below BAT.
If the load current increases beyond the power allowed
from the switching regulator, additional power will be pulled
from the battery via the ideal diodes. Furthermore, if power
to VBUS (USB or wall power) is removed, then all of the
application power will be provided by the battery via the
ideal diodes. The ideal diodes will be fast enough to keep
VOUT from drooping with only the storage capacitance
required for the switching regulator. The internal ideal
diode consists of a precision amplifier that activates a
large on-chip MOSFET transistor whenever the voltage at
VOUT is approximately 15mV (VFWD) below the voltage at
BAT. Within the amplifier’s linear range, the small-signal
resistance of the ideal diode will be quite low, keeping
the forward drop near 15mV. At higher current levels, the
OPERATION
相關PDF資料
PDF描述
LTC4098EPDC-1#PBF BATTERY CHARGE CONTROLLER, 2650 kHz SWITCHING FREQ-MAX, PQCC20
LTC4098EUDC-1#PBF BATTERY CHARGE CONTROLLER, 2650 kHz SWITCHING FREQ-MAX, PQCC20
LTC4110EUHF#TR 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC38
LTC4110EUHF 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC38
LTC4151CS-2#TRPBF 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO16
相關代理商/技術參數
參數描述
LTC4098EUDC-3.6#PBF 功能描述:IC CHARGER USB COMP 3.6V 20UTQFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:Bat-Track™, PowerPath™ 標準包裝:2,000 系列:Impedance Track™ 功能:燃料，電量檢測計/監控器 電池化學:鋰離子（Li-Ion） 電源電壓:2.4 V ~ 2.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:20-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:20-TSSOP 包裝:帶卷 (TR) 產品目錄頁面:1020 (CN2011-ZH PDF) 配用:BQ27350EVM-ND - BQ27350EVM 其它名稱:296-21665-2
LTC4098EUDC-3.6#PBF 制造商:Linear Technology 功能描述:IC, POWER MANAGER/BATTERY CHARGER, QFN20
LTC4098EUDC-3.6#TRPBF 功能描述:IC CHARGER USB COMP 3.6V 20UTQFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:Bat-Track™, PowerPath™ 標準包裝:61 系列:- 功能:電源管理 電池化學:鋰離子（Li-Ion）、鋰聚合物（Li-Pol） 電源電壓:4.35 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:22-WFDFN 裸露焊盤 供應商設備封裝:22-DFN（6x3）裸露焊盤 包裝:管件
LTC4099 制造商:LINER 制造商全稱:Linear Technology 功能描述:I2C Controlled USB Power Manager/Charger with Overvoltage Protection
LTC4099EPDC#PBF 功能描述:IC USB PWR MANAGER/CHRGR 20UTQFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:PowerPath™ 標準包裝:1 系列:- 功能:充電管理 電池化學:鋰離子（Li-Ion）、鋰聚合物（Li-Pol） 電源電壓:3.75 V ~ 6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SC-74A，SOT-753 供應商設備封裝:SOT-23-5 包裝:剪切帶 (CT) 產品目錄頁面:669 (CN2011-ZH PDF) 其它名稱:MCP73831T-2ACI/OTCT
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*