參數資料
型號： LTC4098EUDC-1#TRPBF
廠商： LINEAR TECHNOLOGY CORP
元件分類： 穩壓器
英文描述： BATTERY CHARGE CONTROLLER, 2650 kHz SWITCHING FREQ-MAX, PQCC20
封裝： 4 X 3 MM, 0.75 MM HEIGHT, LEAD FREE, PLASTIC, QFN-20
文件頁數： 7/32頁
文件大?。?/td> 443K
代理商： LTC4098EUDC-1#TRPBF
LTC4098/LTC4098-1
15
40981fc
For very low battery voltages, the battery charger acts like
a load and, due to limited input power, its current will tend
to pull VOUT below the 3.6V instant-on voltage. To prevent
VOUT from falling below this level, an undervoltage circuit
automatically detects that VOUT is falling and reduces the
battery charge current as needed. This reduction ensures
that load current and voltage are always prioritized while
allowing as much battery charge current as possible. Refer
to Overprogramming the Battery Charger in the Applica-
tions Information section.
The voltage regulation loop compensation is controlled by
the capacitance on VOUT. An MLCC capacitor of 10μF is
required for loop stability. Additional capacitance beyond
this value will improve transient response.
An internal undervoltage lockout circuit monitors VBUS and
keeps the switching regulator off until VBUS rises above
the rising UVLO threshold (4.3V). If VBUS falls below the
falling UVLO threshold (4V), system power at VOUT will
be drawn from the battery via the ideal diodes. The volt-
age at VBUS must also be higher than the voltage at BAT
by approximately 170mV for the switching regulator to
operate.
Bat-Track High Voltage External Switching Regulator
Control
The WALL, ACPR and VC pins can be used in conjunction
with an external high voltage step-down switching regulator
such as the LT3653 or LT3480 to minimize heat production
when operating from higher voltage sources, as shown in
Figures 3 and 4. Bat-Track control circuitry regulates the
external switching regulator’s output voltage to the larger
of BAT + 300mV or 3.6V. This maximizes battery charger
efficiency while still allowing instant-on operation when
the battery is deeply discharged.
When using the LT3480, the feedback network should be set
to generate an output voltage between 4.5V and 5.5V. When
high voltage is applied to the external regulator, WALL will
rise toward this programmed output voltage. When WALL
exceeds approximately 4.3V, ACPR is brought low and the
Bat-Track control of the LTC4098/LTC4098-1 overdrives
the local VC control of the external high voltage step-down
switching regulator. Therefore, once the Bat-Track control
is enabled, the output voltage is set independent of the
switching regulator feedback network.
Bat-Track control provides a significant efficiency advantage
over the simple use of a 5V switching regulator output to
drive the battery charger. With a 5V output driving VOUT,
battery charger efficiency is approximately:
ηTOTAL =ηBUCK
VBAT
5V
where
ηBUCK is the efficiency of the high voltage switching
regulator and 5V is the output voltage of the switching
regulator. With a typical switching regulator efficiency of
87% and a typical battery voltage of 3.8V, the total battery
charger efficiency is approximately 66%. Assuming a 1A
charge current, nearly 2W of power is dissipated just to
charge the battery!
OPERATION
ACPR
40981 F03
LTC4098/
LTC4098-1
VOUT
ISENSE
WALL
VC
LT3653
VC
HVOK
SYSTEM
LOAD
SW
ACPR
40981 F04
LTC4098/
LTC4098-1
VOUT
WALL
VC
LT3480
VC
SYSTEM
LOAD
SW
FB
Figure 3. LT3653 Typical Interface
Figure 4. LT3480 Typical Interface
相關PDF資料
PDF描述
LTC4098EPDC-1#PBF BATTERY CHARGE CONTROLLER, 2650 kHz SWITCHING FREQ-MAX, PQCC20
LTC4098EUDC-1#PBF BATTERY CHARGE CONTROLLER, 2650 kHz SWITCHING FREQ-MAX, PQCC20
LTC4110EUHF#TR 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC38
LTC4110EUHF 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC38
LTC4151CS-2#TRPBF 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO16
相關代理商/技術參數
參數描述
LTC4098EUDC-3.6#PBF 功能描述:IC CHARGER USB COMP 3.6V 20UTQFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:Bat-Track™, PowerPath™ 標準包裝:2,000 系列:Impedance Track™ 功能:燃料，電量檢測計/監控器 電池化學:鋰離子（Li-Ion） 電源電壓:2.4 V ~ 2.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:20-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:20-TSSOP 包裝:帶卷 (TR) 產品目錄頁面:1020 (CN2011-ZH PDF) 配用:BQ27350EVM-ND - BQ27350EVM 其它名稱:296-21665-2
LTC4098EUDC-3.6#PBF 制造商:Linear Technology 功能描述:IC, POWER MANAGER/BATTERY CHARGER, QFN20
LTC4098EUDC-3.6#TRPBF 功能描述:IC CHARGER USB COMP 3.6V 20UTQFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:Bat-Track™, PowerPath™ 標準包裝:61 系列:- 功能:電源管理 電池化學:鋰離子（Li-Ion）、鋰聚合物（Li-Pol） 電源電壓:4.35 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:22-WFDFN 裸露焊盤 供應商設備封裝:22-DFN（6x3）裸露焊盤 包裝:管件
LTC4099 制造商:LINER 制造商全稱:Linear Technology 功能描述:I2C Controlled USB Power Manager/Charger with Overvoltage Protection
LTC4099EPDC#PBF 功能描述:IC USB PWR MANAGER/CHRGR 20UTQFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:PowerPath™ 標準包裝:1 系列:- 功能:充電管理 電池化學:鋰離子（Li-Ion）、鋰聚合物（Li-Pol） 電源電壓:3.75 V ~ 6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SC-74A，SOT-753 供應商設備封裝:SOT-23-5 包裝:剪切帶 (CT) 產品目錄頁面:669 (CN2011-ZH PDF) 其它名稱:MCP73831T-2ACI/OTCT
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*