- 您現在的位置：買賣IC網 > PDF目錄44996 > LTC4098EUDC-1#PBF (LINEAR TECHNOLOGY CORP) BATTERY CHARGE CONTROLLER, 2650 kHz SWITCHING FREQ-MAX, PQCC20 PDF資料下載
參數資料
| 型號： | LTC4098EUDC-1#PBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | BATTERY CHARGE CONTROLLER, 2650 kHz SWITCHING FREQ-MAX, PQCC20 |
| 封裝： | 4 X 3 MM, 0.75 MM HEIGHT, LEAD FREE, PLASTIC, QFN-20 |
| 文件頁數： | 4/32頁 |
| 文件大?。?/td> | 443K |
| 代理商： | LTC4098EUDC-1#PBF |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
LTC4098/LTC4098-1
12
40981fc
Introduction
The LTC4098/LTC4098-1 are high efficiency power manage-
ment and Li-Ion charger solutions designed to make optimal
use of the power available from a variety of sources, while
minimizing power dissipation and easing thermal budgeting
constraints. The innovative PowerPath architecture ensures
that the application is powered immediately after external
voltage is applied, even with a completely dead battery by
prioritizing power to the application over the battery.
The LTC4098/LTC4098-1 include a Bat-Track monolithic
step-down switching regulator for USB, wall adapters and
other 5V sources. Designed specifically for USB applica-
tions, the switching regulator incorporates a precision
average input current limit for USB compatibility. Because
power is conserved, the LTC4098/LTC4098-1 allow the load
current on VOUT to exceed the current drawn by the USB
port, making maximum use of the allowable USB power
for battery charging.
The switching regulator and battery charger communicate
to ensure that the average input current never exceeds the
USB specifications.
For automotive, Firewire, and other high voltage applica-
tions, the LTC4098/LTC4098-1 provide Bat-Track control
of an external LTC step-down switching regulator to
maximize battery charger efficiency and minimize heat
production.
When power is available from both the USB and high
voltage inputs, the high voltage input is prioritized and
the USB input is automatically disabled.
The LTC4098/LTC4098-1 feature an overvoltage protec-
tion circuit which is designed to work with an external
N-channel FET to prevent damage to its inputs caused by
accidental application of high voltage.
The LTC4098/LTC4098-1 contain both an internal 180m
Ω
ideal diode and an ideal diode controller designed for use
with an external P-channel FET. The ideal diodes from BAT
to VOUT guarantee that ample power is always available
to VOUT even if there is insufficient or absent power at
VBUS or WALL.
Finally, to prevent battery drain when a device is connected
to a suspended USB port, an LDO from VBUS to VOUT
provides either low power or high power USB suspend
current to the application.
Bat-Track Input Current Limited Step Down Switching
Regulator
The power delivered from VBUS to VOUT is controlled
by a 2.25MHz constant-frequency step-down switching
regulator. To meet the USB maximum load specification,
the switching regulator contains a measurement and
control system that ensures that the average input cur-
rent remains below the level programmed at CLPROG.
VOUT drives the combination of the external load and the
battery charger.
If the combined load does not cause the switching power
supply to reach the programmed input current limit, VOUT
will track approximately 0.3V above the battery voltage.
By keeping the voltage across the battery charger at this
low level, power lost to the battery charger is minimized.
Figure 1 shows the power path components.
If the combined external load plus battery charge current is
large enough to cause the switching power supply to reach
the programmed input current limit, the battery charger
will reduce its charge current by precisely the amount
necessary to enable the external load to be satisfied. Even
if the battery charge current is programmed to exceed the
allowable USB current, the USB specification for average
input current will not be violated; the battery charger will
reduce its current as needed. Furthermore, if the load cur-
rent at VOUT exceeds the programmed power from VBUS,
load current will be drawn from the battery via the ideal
diodes even when the battery charger is enabled.
The current at CLPROG is a precise fraction of the VBUS
current. When a programming resistor and an averaging
capacitor are connected from CLPROG to GND, the voltage
on CLPROG represents the average input current of the
switching regulator. As the input current approaches the
programmed limit, CLPROG reaches 1.188V and power
delivered by the switching regulator is held constant.
Several ratios of current are available which can be set
to correspond to USB low and high power modes with a
single programming resistor.
The input current limit is programmed by various com-
binations of the D0, D1 and D2 pins as shown in Table 1.
OPERATION
相關PDF資料 |
PDF描述 |
|---|---|
| LTC4110EUHF#TR | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC38 |
| LTC4110EUHF | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC38 |
| LTC4151CS-2#TRPBF | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO16 |
| LTC4151HMS#TRPBF | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO10 |
| LTC4151HDD#TRPBF | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO10 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC4098EUDC-3.6#PBF | 功能描述:IC CHARGER USB COMP 3.6V 20UTQFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:Bat-Track™, PowerPath™ 標準包裝:2,000 系列:Impedance Track™ 功能:燃料，電量檢測計/監控器 電池化學:鋰離子（Li-Ion） 電源電壓:2.4 V ~ 2.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:20-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:20-TSSOP 包裝:帶卷 (TR) 產品目錄頁面:1020 (CN2011-ZH PDF) 配用:BQ27350EVM-ND - BQ27350EVM 其它名稱:296-21665-2 |
| LTC4098EUDC-3.6#PBF | 制造商:Linear Technology 功能描述:IC, POWER MANAGER/BATTERY CHARGER, QFN20 |
| LTC4098EUDC-3.6#TRPBF | 功能描述:IC CHARGER USB COMP 3.6V 20UTQFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:Bat-Track™, PowerPath™ 標準包裝:61 系列:- 功能:電源管理 電池化學:鋰離子（Li-Ion）、鋰聚合物（Li-Pol） 電源電壓:4.35 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:22-WFDFN 裸露焊盤 供應商設備封裝:22-DFN（6x3）裸露焊盤 包裝:管件 |
| LTC4099 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:I2C Controlled USB Power Manager/Charger with Overvoltage Protection |
| LTC4099EPDC#PBF | 功能描述:IC USB PWR MANAGER/CHRGR 20UTQFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:PowerPath™ 標準包裝:1 系列:- 功能:充電管理 電池化學:鋰離子（Li-Ion）、鋰聚合物（Li-Pol） 電源電壓:3.75 V ~ 6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SC-74A，SOT-753 供應商設備封裝:SOT-23-5 包裝:剪切帶 (CT) 產品目錄頁面:669 (CN2011-ZH PDF) 其它名稱:MCP73831T-2ACI/OTCT |
發布緊急采購，3分鐘左右您將得到回復。