- 您現在的位置：買賣IC網 > PDF目錄44995 > LTC4009IUF-1#PBF (LINEAR TECHNOLOGY CORP) BATTERY CHARGE CONTROLLER, 633 kHz SWITCHING FREQ-MAX, PQCC20 PDF資料下載
參數資料
| 型號： | LTC4009IUF-1#PBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | BATTERY CHARGE CONTROLLER, 633 kHz SWITCHING FREQ-MAX, PQCC20 |
| 封裝： | 4 X 4 MM, 0.75 MM HEIGHT, LEAD FREE, PLASTIC, MO-220WGGD-1, QFN-20 |
| 文件頁數： | 7/28頁 |
| 文件大?。?/td> | 351K |
| 代理商： | LTC4009IUF-1#PBF |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
4009fd
LTC4009
LTC4009-1/LTC4009-2
applicaTions inForMaTion
Programming Charge Current
The formula for charge current is:
I
R
V
R
A
CHRG
IN
SENSE
PROG
=
.
– .
1 2085
11 67
The LTC4009 operates best with 3.01k input resistors,
although other resistors near this value can be used to
accommodate standard sense resistor values. Refer to
the subsequent discussion on inductor selection for other
considerations that come into play when selecting input
resistors RIN.
RSENSE should be chosen according to the following
equation:
R
mV
I
SENSE
MAX
=
100
where IMAX is the desired maximum charge current ICHRG.
The100mVtargetcanbeadjustedtosomedegreetoobtain
standard RSENSE values and/or a desired RPROG value, but
targetvoltageslowerthan100mVwillcauseaproportional
reduction in current regulation accuracy.
TherequiredminimumresistancebetweenPROGandGND
can be determined by applying the suggested expression
for RSENSE while solving the first equation given above for
charge current with ICHRG = IMAX:
R
V R
V
A R
PROG MIN
IN
(
)
.
.
=
+
1 2085
0 1
11 67
If RIN is chosen to be 3.01k with a sense voltage of 100mV,
this equation indicates a minimum value for RPROG of
26.9k. Table 6 gives some examples of recommended
charge current programming component values based
on these equations.
The resistance between PROG and GND can simply be
set with a single a resistor, if only maximum charge cur-
rent needs to be controlled during the desired charging
algorithm. However, some batteries require a low charge
current for initial conditioning when they are heavily dis-
charged. The charge current can then be safely switched
to a higher level after conditioning is complete. Figure 3
illustrates one method of doing this with 2-level control
of the PROG pin resistance. Turning Q1 off reduces the
charge current to IMAX/10 for battery conditioning. When
Q1 is on, the LTC4009 is programmed to allow full IMAX
current for bulk charge. This technique can be expanded
through the use of additional digital control inputs for an
arbitrary number of pre-programmed current values.
Figure 3. Programming 2-Level Charge Current
13
Q1
2N7002
4009 F03
R2
53.6k
PROG
LTC4009
R1
26.7k
CPROG
4.7nF
BULK
CHARGE
PRECHARGE
For a truly continuous range of maximum charge current
control, pulse width modulation can be used as shown in
Figure 4. The value of RPROG controls the maximum value
of charge current which can be programmed (Q1 continu-
ously on). PWM of the Q1 gate voltage changes the value
of RPROG to produce lower currents. The frequency of this
modulation should be higher than a few kHz, and CPROG
must be increased to reduce the ripple caused by switch-
ing Q1. In addition, it may be necessary to increase loop
相關PDF資料 |
PDF描述 |
|---|---|
| LTC4009CUF-2#PBF | BATTERY CHARGE CONTROLLER, 633 kHz SWITCHING FREQ-MAX, PQCC20 |
| LTC4009CUF-1#PBF | BATTERY CHARGE CONTROLLER, 633 kHz SWITCHING FREQ-MAX, PQCC20 |
| LTC4012IUF-3#PBF | BATTERY CHARGE CONTROLLER, 633 kHz SWITCHING FREQ-MAX, PQCC20 |
| LTC4012IUF-3#TRPBF | BATTERY CHARGE CONTROLLER, 633 kHz SWITCHING FREQ-MAX, PQCC20 |
| LTC4012IUF#TRPBF | SWITCHING CONTROLLER, 633 kHz SWITCHING FREQ-MAX, PQCC20 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC4009IUF-2#PBF | 功能描述:IC CHARGER BATTERY MC 20-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 功能:電池監控器 電池化學:堿性，鋰離子，鎳鎘，鎳金屬氫化物 電源電壓:1 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-6 包裝:帶卷 (TR) |
| LTC4009IUF-2#TRPBF | 功能描述:IC CTLR BATT CHARGER CC/CV 20QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 功能:電池監控器 電池化學:堿性，鋰離子，鎳鎘，鎳金屬氫化物 電源電壓:1 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-6 包裝:帶卷 (TR) |
| LTC4010 | 制造商:LINEAR 制造商全稱:LINEAR 功能描述:High Efficiency Standalone Nickel Battery Charger |
| LTC4010CFE | 制造商:Linear Technology 功能描述:Battery Charger NiCD/NiMH 16-Pin TSSOP EP |
| LTC4010CFE#PBF | 功能描述:IC CHARGER NIMH/NICD 16-TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 其它有關文件:STC3100 View All Specifications 特色產品:STC3100 - Battery Monitor IC 標準包裝:4,000 系列:- 功能:燃料，電量檢測計/監控器 電池化學:鋰離子（Li-Ion） 電源電壓:2.7 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:8-MiniSO 包裝:帶卷 (TR) 其它名稱:497-10526-2 |
發布緊急采購，3分鐘左右您將得到回復。