- 您現在的位置：買賣IC網 > PDF目錄44995 > LTC4009IUF-1#PBF (LINEAR TECHNOLOGY CORP) BATTERY CHARGE CONTROLLER, 633 kHz SWITCHING FREQ-MAX, PQCC20 PDF資料下載
參數資料
| 型號： | LTC4009IUF-1#PBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | BATTERY CHARGE CONTROLLER, 633 kHz SWITCHING FREQ-MAX, PQCC20 |
| 封裝： | 4 X 4 MM, 0.75 MM HEIGHT, LEAD FREE, PLASTIC, MO-220WGGD-1, QFN-20 |
| 文件頁數： | 6/28頁 |
| 文件大?。?/td> | 351K |
| 代理商： | LTC4009IUF-1#PBF |
第1頁第2頁第3頁第4頁第5頁當前第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
LTC4009
LTC4009-1/LTC4009-2
4009fd
PWM Watchdog Timer
Asinputandoutputconditionsvary,theLTC4009mayneed
toutilizePWMdutycyclesapproaching100%.Inthiscase,
operating frequency may be reduced well below 550kHz.
An internal watchdog timer observes the activity on the
TGATEpin.IfTGATEisonformorethan40s,thewatchdog
activates and forces the bottom NFET on (top NFET off)
for about 100ns. This avoids a potential source of audible
noise when using ceramic input or output capacitors and
prevents the boost supply capacitor for the top gate driver
from discharging. In low drop out operation, the actual
charge current may not be able to reach the programmed
full-scale value due to the watchdog function.
Overvoltage Protection
The LTC4009 also contains overvoltage detection that
preventstransientbatteryvoltageovershootsofmorethan
about 6% above the programmed output voltage. When
batteryovervoltageisdetected,bothexternalMOSFETsare
turned off until the overvoltage condition clears, at which
time a new soft start sequence begins. This is useful for
properlychargingbatterypacksthatuseaninternalswitch
to disconnect themselves for performing functions such
as calibration or pulse mode charging.
Reverse Charge Current Protection (Anti-Boost)
BecausetheLTC4009alwaysattemptstooperatesynchro-
nouslyinfullcontinuousmode(toavoidaudiblenoisefrom
ceramic capacitors), reverse average charge current can
occur during some invalid operating conditions. To avoid
boosting a lightly loaded system supply during reverse
operation, the LTC4009 monitors the voltage on CLP to
determine if it rises 25mV above DCIN during charge.
However, under heavier system loads, CLP may not boost
above DCIN, even though reverse average current is flow-
ing. In this case a second circuit monitors indication of
reverse average current on PROG.
If the designer intends to replace the input diode with a
MOSFET for improved efficiency, using the ACP signal of
the LTC4009 to control the MOSFET is not recommended.
In this case, the LTC4012 is strongly suggested, because
it includes ideal diode control of the MOSFET, instead of
driving it as a simple switch. This solution is the most ef-
fective at detecting boost conditions and quickly shutting
down the IC. If for some reason the LTC4012 solution is
not acceptable, and a MOSFET with external control is
used to replace the input diode, and there are conditions
involving very low reverse current under no system load
with an AC adapter that cannot sink current, it may still
be possible to boost the DCIN input supply. To cover this
case, the LTC4009 monitors the resistor divider attached
to the DCDIV pin and sets an input overvoltage fault if that
voltage exceeds 1.825V.
Ifanyofthesecircuitsdetectsboostoperation,TheLTC4009
turns off both external MOSFETs until the reverse current
condition clears. Once DCIN-CLP > 25mV, a new soft-start
sequence begins.
operaTion
相關PDF資料 |
PDF描述 |
|---|---|
| LTC4009CUF-2#PBF | BATTERY CHARGE CONTROLLER, 633 kHz SWITCHING FREQ-MAX, PQCC20 |
| LTC4009CUF-1#PBF | BATTERY CHARGE CONTROLLER, 633 kHz SWITCHING FREQ-MAX, PQCC20 |
| LTC4012IUF-3#PBF | BATTERY CHARGE CONTROLLER, 633 kHz SWITCHING FREQ-MAX, PQCC20 |
| LTC4012IUF-3#TRPBF | BATTERY CHARGE CONTROLLER, 633 kHz SWITCHING FREQ-MAX, PQCC20 |
| LTC4012IUF#TRPBF | SWITCHING CONTROLLER, 633 kHz SWITCHING FREQ-MAX, PQCC20 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC4009IUF-2#PBF | 功能描述:IC CHARGER BATTERY MC 20-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 功能:電池監控器 電池化學:堿性，鋰離子，鎳鎘，鎳金屬氫化物 電源電壓:1 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-6 包裝:帶卷 (TR) |
| LTC4009IUF-2#TRPBF | 功能描述:IC CTLR BATT CHARGER CC/CV 20QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 功能:電池監控器 電池化學:堿性，鋰離子，鎳鎘，鎳金屬氫化物 電源電壓:1 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-6 包裝:帶卷 (TR) |
| LTC4010 | 制造商:LINEAR 制造商全稱:LINEAR 功能描述:High Efficiency Standalone Nickel Battery Charger |
| LTC4010CFE | 制造商:Linear Technology 功能描述:Battery Charger NiCD/NiMH 16-Pin TSSOP EP |
| LTC4010CFE#PBF | 功能描述:IC CHARGER NIMH/NICD 16-TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 其它有關文件:STC3100 View All Specifications 特色產品:STC3100 - Battery Monitor IC 標準包裝:4,000 系列:- 功能:燃料，電量檢測計/監控器 電池化學:鋰離子（Li-Ion） 電源電壓:2.7 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:8-MiniSO 包裝:帶卷 (TR) 其它名稱:497-10526-2 |
發布緊急采購，3分鐘左右您將得到回復。