- 您現在的位置：買賣IC網 > PDF目錄44995 > LTC3890IGN-1#PBF (LINEAR TECHNOLOGY CORP) SWITCHING CONTROLLER, PDSO28 PDF資料下載
參數資料
| 型號： | LTC3890IGN-1#PBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING CONTROLLER, PDSO28 |
| 封裝： | LEAD FREE, PLASTIC, SSOP-28 |
| 文件頁數： | 3/36頁 |
| 文件大?。?/td> | 498K |
| 代理商： | LTC3890IGN-1#PBF |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
LTC3890-1
11
38901f
OPERATION (Refer to the Functional Diagram)
Main Control Loop
The LTC3890-1 uses a constant frequency, current mode
step-down architecture with the two controller channels
operating 180 degrees out of phase. During normal op-
eration, each external top MOSFET is turned on when the
clock for that channel sets the RS latch, and is turned off
when the main current comparator, ICMP, resets the RS
latch. The peak inductor current at which ICMP trips and
resets the latch is controlled by the voltage on the ITH pin,
which is the output of the error amplier, EA. The error
amplier compares the output voltage feedback signal at
the VFB pin, (which is generated with an external resistor
divider connected across the output voltage, VOUT, to
ground) to the internal 0.800V reference voltage. When
the load current increases, it causes a slight decrease
in VFB relative to the reference, which causes the EA to
increase the ITH voltage until the average inductor current
matches the new load current.
After the top MOSFET is turned off each cycle, the bot-
tom MOSFET is turned on until either the inductor current
starts to reverse, as indicated by the current comparator
IR, or the beginning of the next clock cycle.
INTVCC/EXTVCC Power
Power for the top and bottom MOSFET drivers and most
other internal circuitry is derived from the INTVCC pin.
When the EXTVCC pin is left open or tied to a voltage less
than 4.7V, the VIN LDO (low dropout linear regulator) sup-
plies 5.1V from VIN to INTVCC. If EXTVCC is taken above
4.7V, the VIN LDO is turned off and an EXTVCC LDO is
turned on. Once enabled, the EXTVCC LDO supplies 5.1V
from EXTVCC to INTVCC. Using the EXTVCC pin allows
the INTVCC power to be derived from a high efciency
external source such as one of the LTC3890-1 switching
regulator outputs.
Each top MOSFET driver is biased from the oating boot-
strap capacitor CB, which normally recharges during each
cycle through an external diode when the top MOSFET
turns off. If the input voltage, VIN, decreases to a voltage
close to VOUT, the loop may enter dropout and attempt
to turn on the top MOSFET continuously. The dropout
detector detects this and forces the top MOSFET off for
about one-twelfth of the clock period every tenth cycle to
allow CB to recharge.
Shutdown and Start-Up (RUN1, RUN2 and
TRACK/ SS1, TRACK/SS2 Pins)
The two channels of the LTC3890-1 can be independently
shut down using the RUN1 and RUN2 pins. Pulling either
of these pins below 1.2V shuts down the main control loop
for that controller. Pulling both pins below 0.7V disables
both controllers and most internal circuits, including the
INTVCC LDOs. In this state, the LTC3890-1 draws only
14μA of quiescent current.
Releasing either RUN pin allows a small internal current to
pull up the pin to enable that controller. The RUN1 pin has a
7μA pull-up current while the RUN2 pin has a smaller 0.5μA.
The 7μA current on RUN1 is designed to be large enough
so that the RUN1 pin can be safely oated (to always en-
able the controller) without worry of condensation or other
small board leakage pulling the pin down. This is ideal for
always-on applications where one or both controllers are
enabled continuously and never shut down.
The RUN pin may be externally pulled up or driven directly
by logic. When driving the RUN pin with a low impedance
source, do not exceed the absolute maximum rating of
8V. The RUN pin has an internal 11V voltage clamp that
allows the RUN pin to be connected through a resistor to a
higher voltage (for example, VIN), so long as the maximum
current into the RUN pin does not exceed 100μA.
The start-up of each controller’s output voltage VOUT is
controlled by the voltage on the TRACK/SS pin for that
channel. When the voltage on the TRACK/SS pin is less
than the 0.8V internal reference, the LTC3890-1 regulates
the VFB voltage to the TRACK/SS pin voltage instead of
the 0.8V reference. This allows the TRACK/SS pin to be
used to program a soft-start by connecting an external
capacitor from the TRACK/SS pin to SGND. An internal
1μA pull-up current charges this capacitor creating a
voltage ramp on the TRACK/SS pin. As the TRACK/SS
voltage rises linearly from 0V to 0.8V (and beyond up to
5V), the output voltage VOUT rises smoothly from zero to
its nal value.
Alternatively the TRACK/SS pin can be used to cause the
start-up of VOUT to track that of another supply. Typically,
this requires connecting to the TRACK/SS pin an external
resistor divider from the other supply to ground (see Ap-
plications Information section).
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3890MPUH#TRPBF | DUAL SWITCHING CONTROLLER, 585 kHz SWITCHING FREQ-MAX, PQCC32 |
| LTC3890EUH#PBF | DUAL SWITCHING CONTROLLER, 585 kHz SWITCHING FREQ-MAX, PQCC32 |
| LTC3890IUH#TRPBF | DUAL SWITCHING CONTROLLER, 585 kHz SWITCHING FREQ-MAX, PQCC32 |
| LTC3890HUH#PBF | DUAL SWITCHING CONTROLLER, 585 kHz SWITCHING FREQ-MAX, PQCC32 |
| LTC3890HUH#TRPBF | DUAL SWITCHING CONTROLLER, 585 kHz SWITCHING FREQ-MAX, PQCC32 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3890IGN-3#PBF | 制造商:Linear Technology 功能描述:IC REG CTRLR BUCK PWM CM 28SSOP 制造商:Linear Technology 功能描述:DC-DC CONTROLLER BUCK 900KHZ 制造商:Linear Technology 功能描述:BUCK DUAL CNTRL 4-60V 850K 制造商:Linear Technology 功能描述:DC-DC CONTROLLER, BUCK, 900KHZ, SSOP-28 制造商:Linear Technology 功能描述:DC-DC CONTROLLER, BUCK, 900KHZ, SSOP-28; Primary Input Voltage:60V; No. of Outputs:2; No. of Pins:28; Operating Temperature Min:-40C; Operating Temperature Max:125C; Operating Temperature Range:-40C to +125C ;RoHS Compliant: Yes |
| LTC3890IGN-3#TRPBF | 制造商:Linear Technology 功能描述:IC REG CTRLR BUCK PWM CM 28SSOP |
| LTC3890IUH#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC3890IUH#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC3890IUH-2#PBF | 制造商:Linear Technology 功能描述:DC DC Cntrlr Dual-OUT Sync Step Down 4V to 60V Input 32-Pin QFN EP 制造商:Linear Technology 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN 制造商:Linear Technology 功能描述:DP-SWREG/Controller, High Voltage Dual Output Synchronous Step-Down Controller |
發布緊急采購，3分鐘左右您將得到回復。