- 您現在的位置：買賣IC網 > PDF目錄2006 > LTC2379HMS-18#PBF (Linear Technology)IC ADC 18BIT SPI/SRL 16MSOP PDF資料下載
參數資料
| 型號： | LTC2379HMS-18#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 7/26頁 |
| 文件大小： | 0K |
| 描述： | IC ADC 18BIT SPI/SRL 16MSOP |
| 產品培訓模塊： | LTC2379- 18-/16-bit Fully-Differential SAR ADC Family Overview |
| 標準包裝： | 37 |
| 位數： | 18 |
| 采樣率（每秒）： | 1.6M |
| 數據接口： | 串行，SPI? |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 21.5mW |
| 電壓電源： | 模擬和數字 |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-TFSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 16-MSOP |
| 包裝： | 管件 |
| 輸入數目和類型： | 1 個差分，雙極 |
| 配用： | DC1783A-E-ND - BOARD SAR ADC LTC2379-18 |
LTC2379-18
15
237918fa
reinitialize the ADC. No conversions should be initiated
until 20μs after a POR event to ensure the reinitialization
period has ended. Any conversions initiated before this
time will produce invalid results.
TIMING AND CONTROL
CNV Timing
The LTC2379-18 conversion is controlled by CNV. A ris-
ing edge on CNV will start a conversion and power up the
LTC2379-18. Once a conversion has been initiated, it cannot
be restarted until the conversion is complete. For optimum
performance, CNV should be driven by a clean low jitter
signal. Converter status is indicated by the BUSY output
which remains high while the conversion is in progress.
To ensure that no errors occur in the digitized results, any
additional transitions on CNV should occur within 40ns
from the start of the conversion or after the conversion
has been completed. Once the conversion has completed,
the LTC2379-18 powers down and begins acquiring the
input signal.
Internal Conversion Clock
The LTC2379-18 has an internal clock that is trimmed to
achieve a maximum conversion time of 412ns. With a min-
imum acquisition time of 200ns, throughput performance
of 1.6Msps is guaranteed without any external adjustments.
Auto Power-Down
The LTC2379-18 automatically powers down after a con-
version has been completed and powers up once a new
conversion is initiated on the rising edge of CNV. During
power down, data from the last conversion can be clocked
out. To minimize power dissipation during power down,
disable SDO and turn off SCK. The auto power-down feature
will reduce the power dissipation of the LTC2379-18 as
the sampling frequency is reduced. Since power is con-
sumed only during a conversion, the LTC2379-18 remains
APPLICATIONS INFORMATION
powered-down for a larger fraction of the conversion cycle
(tCYC) at lower sample rates, thereby reducing the average
power dissipation which scales with the sampling rate as
shown in Figure 12.
DIGITAL INTERFACE
The LTC2379-18 has a serial digital interface. The flexible
OVDD supply allows the LTC2379-18 to communicate with
any digital logic operating between 1.8V and 5V, including
2.5V and 3.3V systems.
The serial output data is clocked out on the SDO pin when
an external clock is applied to the SCK pin if SDO is enabled.
Clocking out the data after the conversion will yield the
best performance. With a shift clock frequency of at least
100MHz, a 1.6Msps throughput is still achieved. The serial
output data changes state on the rising edge of SCK and
can be captured on the falling edge or next rising edge of
SCK. D17 remains valid till the first rising edge of SCK.
The serial interface on the LTC2379-18 is simple and
straightforward to use. The following sections describe the
operation of the LTC2379-18. Several modes are provided
depending on whether a single or multiple ADCs share the
SPI bus or are daisy chained.
SAMPLING RATE (kHz)
0
200 400 600 800
1600
1400
1200
1000
0
POWER
SUPPL
Y
CURRENT
(mA)
5
4
2
1
3
8
7
6
237918 F12
IVDD
IREF
IOVDD
Figure 12. Power Supply Current of the LTC2379-18
Versus Sampling Rate
相關PDF資料 |
PDF描述 |
|---|---|
| LTC2380HMS-16#TRPBF | IC ADC 16BIT 2MSPS 16-MSOP |
| LTC2382HMS-16#PBF | IC ADC 16BIT 1CH 500KSPS 16-MSOP |
| LTC2383HMS-16#PBF | IC ADC 16BIT 1CH 1MSPS 16-MSOP |
| LTC2393IUK-16#TRPBF | IC ADC 16BIT SER/PAR 1M 48-QFN |
| LTC2410IGN#TRPBF | IC ADC 24BIT DIFF INP/REF 16SSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2379IDE-18#PBF | 功能描述:IC ADC 18BIT SPI/SRL 16DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6 |
| LTC2379IDE-18#PBF-ES | 制造商:Linear Technology 功能描述:18-BIT, 1.6MSPS, 101DB SNR, LO |
| LTC2379IDE-18#TRPBF | 功能描述:IC ADC 18BIT SPI/SRL 16DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
| LTC2379IDE-18#TRPBF-ES | 制造商:Linear Technology 功能描述:ADC Single SAR 1.6Msps 18-bit Serial 16-Pin DFN EP T/R |
| LTC2379IMS-18#PBF | 功能描述:IC ADC 18BIT SPI/SRL 16MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率（每秒）:20M 數據接口:并聯 轉換器數目:2 功率耗散（最大）:155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:Digi-Reel® 輸入數目和類型:4 個單端，單極；2 個差分，單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6 |
發布緊急采購，3分鐘左右您將得到回復。