- 您現在的位置：買賣IC網 > PDF目錄2006 > LTC2379HMS-18#PBF (Linear Technology)IC ADC 18BIT SPI/SRL 16MSOP PDF資料下載
參數資料
| 型號： | LTC2379HMS-18#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 6/26頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 18BIT SPI/SRL 16MSOP |
| 產品培訓模塊： | LTC2379- 18-/16-bit Fully-Differential SAR ADC Family Overview |
| 標準包裝： | 37 |
| 位數： | 18 |
| 采樣率（每秒）： | 1.6M |
| 數據接口： | 串行，SPI? |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 21.5mW |
| 電壓電源： | 模擬和數字 |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-TFSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 16-MSOP |
| 包裝： | 管件 |
| 輸入數目和類型： | 1 個差分，雙極 |
| 配用： | DC1783A-E-ND - BOARD SAR ADC LTC2379-18 |
第1頁第2頁第3頁第4頁第5頁當前第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁
LTC2379-18
14
237918fa
Figure 11. 32k Point FFT with fIN = 2kHz of the LTC2379-18
FREQUENCY (kHz)
0
100 200 300 400
800
700
600
500
–180
AMPLITUDE
(dBFS)
–60
–40
–20
–80
–100
–120
–140
–160
0
237918 F11
SNR = 101.2dB
THD = –120dB
SINAD = 101.1dB
SFDR = 121dB
APPLICATIONS INFORMATION
0μA to a maximum of 1.3mA at 1.6Msps. This step in DC
current draw triggers a transient response in the reference
that must be considered since any deviation in the refer-
ence output voltage will affect the accuracy of the output
code. In applications where the transient response of the
reference is important, the fast settling LTC6655-5 refer-
ence is also recommended.
DYNAMIC PERFORMANCE
Fast Fourier Transform (FFT) techniques are used to test
the ADC’s frequency response, distortion and noise at the
rated throughput. By applying a low distortion sine wave
and analyzing the digital output using an FFT algorithm,
the ADC’s spectral content can be examined for frequen-
cies outside the fundamental. The LTC2379-18 provides
guaranteed tested limits for both AC distortion and noise
measurements.
Signal-to-Noise and Distortion Ratio (SINAD)
The signal-to-noise and distortion ratio (SINAD) is the
ratio between the RMS amplitude of the fundamental input
frequency and the RMS amplitude of all other frequency
components at the A/D output. The output is band-limited
to frequencies from above DC and below half the sampling
frequency. Figure 11 shows that the LTC2379-18 achieves
a typical SINAD of 101dB at a 1.6MHz sampling rate with
a 2kHz input.
Signal-to-Noise Ratio (SNR)
The signal-to-noise ratio (SNR) is the ratio between the
RMS amplitude of the fundamental input frequency and
the RMS amplitude of all other frequency components
except the first five harmonics and DC. Figure 11 shows
that the LTC2379-18 achieves a typical SNR of 101.2dB
at a 1.6MHz sampling rate with a 2kHz input.
Total Harmonic Distortion (THD)
Total Harmonic Distortion (THD) is the ratio of the RMS sum
of all harmonics of the input signal to the fundamental itself.
The out-of-band harmonics alias into the frequency band
between DC and half the sampling frequency (fSMPL/2).
THD is expressed as:
THD
=20log
V2
2 + V32 + V42 +…+ V
N
2
V1
where V1 is the RMS amplitude of the fundamental fre-
quency and V2 through VN aretheamplitudesofthesecond
through Nth harmonics.
POWER CONSIDERATIONS
The LTC2379-18 provides two power supply pins: the
2.5V power supply (VDD), and the digital input/output
interface power supply (OVDD). The flexible OVDD supply
allows the LTC2379-18 to communicate with any digital
logic operating between 1.8V and 5V, including 2.5V and
3.3V systems.
Power Supply Sequencing
The LTC2379-18 does not have any specific power supply
sequencing requirements. Care should be taken to adhere
to the maximum voltage relationships described in the
Absolute Maximum Ratings section. The LTC2379-18
has a power-on-reset (POR) circuit that will reset the
LTC2379-18 at initial power-up or whenever the power
supply voltage drops below 1V. Once the supply voltage
re-enters the nominal supply voltage range, the POR will
相關PDF資料 |
PDF描述 |
|---|---|
| LTC2380HMS-16#TRPBF | IC ADC 16BIT 2MSPS 16-MSOP |
| LTC2382HMS-16#PBF | IC ADC 16BIT 1CH 500KSPS 16-MSOP |
| LTC2383HMS-16#PBF | IC ADC 16BIT 1CH 1MSPS 16-MSOP |
| LTC2393IUK-16#TRPBF | IC ADC 16BIT SER/PAR 1M 48-QFN |
| LTC2410IGN#TRPBF | IC ADC 24BIT DIFF INP/REF 16SSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2379IDE-18#PBF | 功能描述:IC ADC 18BIT SPI/SRL 16DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6 |
| LTC2379IDE-18#PBF-ES | 制造商:Linear Technology 功能描述:18-BIT, 1.6MSPS, 101DB SNR, LO |
| LTC2379IDE-18#TRPBF | 功能描述:IC ADC 18BIT SPI/SRL 16DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
| LTC2379IDE-18#TRPBF-ES | 制造商:Linear Technology 功能描述:ADC Single SAR 1.6Msps 18-bit Serial 16-Pin DFN EP T/R |
| LTC2379IMS-18#PBF | 功能描述:IC ADC 18BIT SPI/SRL 16MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率（每秒）:20M 數據接口:并聯 轉換器數目:2 功率耗散（最大）:155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:Digi-Reel® 輸入數目和類型:4 個單端，單極；2 個差分，單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6 |
發布緊急采購，3分鐘左右您將得到回復。