- 您現在的位置：買賣IC網 > PDF目錄385502 > LT1941EFE (LINEAR TECHNOLOGY CORP) Triple Monolithic Switching Regulator PDF資料下載
參數資料
| 型號： | LT1941EFE |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | Triple Monolithic Switching Regulator |
| 中文描述： | 6 A SWITCHING REGULATOR, 1350 kHz SWITCHING FREQ-MAX, PDSO28 |
| 封裝： | 4.40 MM, PLASTIC, TSSOP-28 |
| 文件頁數： | 17/24頁 |
| 文件大?。?/td> | 336K |
| 代理商： | LT1941EFE |
17
LT1941
1941f
APPLICATIOU
Table 5. Converter Equivalent Model Parameters
STEP-DOWN1
STEP-DOWN2
V
FB
0.628V
R
O
500k
g
ma
1700
μ
mho
1700
μ
mho
g
mp
5mho
3.6mho
W
U
U
single capacitor providing soft-start. The internal current
sources will charge these pins to ~2V.
The RUN/SS pins provide a soft-start function that limits
peak input current to the circuit during start-up. This helps
to avoid drawing more current than the input source can
supply or glitching the input supply when the LT1941 is
enabled. The RUN/SS pins do not provide an accurate
delay to start or an accurately controlled ramp at the
output voltage, both of which depend on the output
capacitance and the load current. However, the power
good indicators can be used to sequence the three out-
puts, as described below.
POWER GOOD INDICATORS
The PGOOD pin is the open-collector output of an internal
comparator. PGOOD remains low until the FB pin is within
10% of the final regulation voltage. Tie the PGOOD to any
supply with a pull-up resistor that will supply less than
200
μ
A. Note that this pin will be open when the LT1941 is
in shutdown mode (all three RUN/SS pins at ground)
regardless of the voltage at the FB pin. PGOOD is valid
when the LT1941 is enabled (any RUN/SS pin is high) and
V
IN
is greater than ~3.5V.
The 5GOOD and 12GOOD pins are also open-collector
outputs of internal comparators. The 5GOOD pin remains
low until the input is within 10% of 5V. Tie the 5GOOD and
12GOOD pins to any supply with a pull-up resistor that will
supply less than 100
μ
A. The 12GOOD pin remains low
until the input is within 10% of 12V. The 5GOOD and
12GOOD pins are valid as long as V
IN
is greater than 1.1V.
Both the 5GOOD and 12GOOD pins will sink current when
the part is in shutdown, independent of the voltage at V
IN.
Output Sequencing
The PG and RUN/SS pins can be used to sequence the
three outputs. Figure 6 shows several circuits to do this.
The techniques shown to sequence two channels can be
extended to sequence the third. In each case channel 1
starts first. Note that these circuits sequence the outputs
during start-up. When shut down the three channels turn
off simultaneously.
BOOST
1.25
500k
800
μ
mho
V
IN
5mho
V
OUT
INVERTER
1.24
500k
800
μ
mho
V
IN
5mho
–
V
OUT
0.628V
500k
Figure 5. Model for Loop Response
–
+
V
FB
V
SW
V
C
LT1941
GND
1941 F05
R1
OUTPUT
ESR
C
F
C
C
R
C
500k
ERROR
AMPLIFIER
FB
R2
C1
C1
CURRENT MODE
POWER STAGE
g
mp
g
ma
+
POLYMER
OR
TANTALUM
CERAMIC
C
PL
SOFT-START AND SHUTDOWN
The RUN/SS (Run/Soft-Start) pins are used to place the
individual switching regulators and the internal bias cir-
cuits in shutdown mode. They also provide a soft-start
function. To shut down a regulator, pull its RUN/SS pin to
ground with an open drain or collector. If all three RUN/SS
pins are pulled to ground, the LT1941 enters its shutdown
mode with all regulators off and quiescent current reduced
to ~50mA. Internal 2
μ
A current sources pull up on each
pin. If any RUN/SS pin reaches ~0.6V, the internal bias
circuits start and the quiescent currents increase to their
nominal levels.
If a capacitor is tied from the RUN/SS pin to ground, then
the internal pull-up current will generate a voltage ramp on
this pin. This voltage clamps the V
C
pin, limiting the peak
switch current and therefore input current during start-up.
A good value for the soft-start capacitor is C
OUT
/10,000,
where C
OUT
is the value of the output capacitor.
The RUN/SS pins can be left floating if the shutdown
feature is not used. They can also be tied together with a
相關PDF資料 |
PDF描述 |
|---|---|
| LT1959C | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| LT1959I | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| LTC1047 | Dual Micropower Chopper Stabilized Op Amp With Internal Capacitors(雙路微功耗斬波穩定運算放大器（帶內部電容）) |
| LTC1049 | Low Power Chopper Stabilized Op Amp With Internal Capacitors(單路低功耗斬波穩定運算放大器（帶內部電容）) |
| LTC1064-1 | Low Noise, 8th Order, Clock Sweepable Elliptic Lowpass Filter(低噪聲，８階，時鐘掃描橢圓形低通濾波器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1941EFE#PBF | 功能描述:IC REG MULTI CONFIG TRPL 28TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 產品培訓模塊:MIC23xxx HyperLight Load™ Regulators 標準包裝:5,000 系列:HyperLight Load® 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.8V 輸入電壓:2.7 V ~ 5.5 V PWM 型:混合物 頻率 - 開關:4MHz 電流 - 輸出:2A 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:8-VFDFN 裸露焊盤，8-MLF? 包裝:帶卷 (TR) 供應商設備封裝:8-MLF?（2x2） 產品目錄頁面:1094 (CN2011-ZH PDF) 其它名稱:576-3303-2 |
| LT1941EFE#TR | 功能描述:IC REG MULTI CONFIG TRPL 28TSSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓（升壓） 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT |
| LT1941EFE#TRPBF | 功能描述:IC REG MULTI CONFIG TRPL 28TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓（升壓） 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT |
| LT1942 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Quad DCDC Converter for Triple Outputs TFT Supply Plus LED Driver |
| LT1942EUF | 制造商:Linear Technology 功能描述:Conv DC-DC Quad Inv/Step Up 2.6V to 16V 24-Pin QFN EP |
發布緊急采購，3分鐘左右您將得到回復。