參數資料
型號: LPC1313FHN33/01,55
廠商: NXP Semiconductors
文件頁數: 19/74頁
文件大小: 0K
描述: MCU CORTEX M3 32KB FLASH 32HVQFN
標準包裝: 260
系列: LPC13xx
核心處理器: ARM? Cortex?-M3
芯體尺寸: 32-位
速度: 72MHz
連通性: I²C,Microwire,SPI,SSI,UART/USART
外圍設備: 欠壓檢測/復位,POR,WDT
輸入/輸出數: 28
程序存儲器容量: 32KB(32K x 8)
程序存儲器類型: 閃存
RAM 容量: 8K x 8
電壓 - 電源 (Vcc/Vdd): 2 V ~ 3.6 V
數據轉換器: A/D 8x10b
振蕩器型: 內部
工作溫度: -40°C ~ 85°C
封裝/外殼: 32-VQFN 裸露焊盤
包裝: 托盤
其它名稱: 568-8375
LPC1311_13_42_43
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2012. All rights reserved.
Product data sheet
Rev. 5 — 6 June 2012
26 of 74
NXP Semiconductors
LPC1311/13/42/43
32-bit ARM Cortex-M3 microcontroller
Upon power-up, any chip reset, or wake-up from Deep power-down mode, the
LPC1311/13/42/43 use the IRC as the clock source. Software may later switch to one of
the other available clock sources.
7.18.1.2
System oscillator
The system oscillator can be used as the clock source for the CPU, with or without using
the PLL. On the LPC1342/43, the system oscillator must be used to provide the clock
source to USB.
The system oscillator operates at frequencies of 1 MHz to 25 MHz. This frequency can be
boosted to a higher frequency, up to the maximum CPU operating frequency, by the
system PLL.
7.18.1.3
Watchdog oscillator
The watchdog oscillator can be used as a clock source that directly drives the CPU, the
watchdog timer, or the CLKOUT pin. The watchdog oscillator nominal frequency is
programmable between 7.8 kHz and 1.7 MHz. The frequency spread over processing and
temperature is
±40 % (see also Table 16).
7.18.2 System PLL and USB PLL
The LPC1342/43 contain a system PLL and a dedicated PLL for generating the 48 MHz
USB clock. The LPC131x contain the system PLL only. The system and USB PLLs are
identical.
The PLL accepts an input clock frequency in the range of 10 MHz to 25 MHz. The input
frequency is multiplied up to a high frequency with a Current Controlled Oscillator (CCO).
The multiplier can be an integer value from 1 to 32. The CCO operates in the range of
156 MHz to 320 MHz, so there is an additional divider in the loop to keep the CCO within
its frequency range while the PLL is providing the desired output frequency. The output
divider may be set to divide by 2, 4, 8, or 16 to produce the output clock. The PLL output
frequency must be lower than 100 MHz. Since the minimum output divider value is 2, it is
insured that the PLL output has a 50 % duty cycle. The PLL is turned off and bypassed
following a chip reset and may be enabled by software. The program must configure and
activate the PLL, wait for the PLL to lock, and then connect to the PLL as a clock source.
The PLL settling time is 100
μs.
7.18.3 Clock output
The LPC1311/13/42/43 features a clock output function that routes the IRC oscillator, the
system oscillator, the watchdog oscillator, or the main clock to an output pin.
7.18.4 Wake-up process
The LPC1311/13/42/43 begin operation at power-up and when awakened from Deep
power-down mode by using the 12 MHz IRC oscillator as the clock source. This allows
chip operation to resume quickly. If the main oscillator or the PLL is needed by the
application, software will need to enable these features and wait for them to stabilize
before they are used as a clock source.
相關PDF資料
PDF描述
C8051F561-IQ IC 8051 MCU 32K FLASH 32-QFP
P80C32X2FN,112 IC 80C51 MCU 256 ROMLESS 40DIP
EFM32TG822F32 IC MCU 32BIT 32KB FLASH 48LQFP
LPC1313FHN33,551 IC MCU 32BIT 32KB FLASH 33HVQFN
P80C32SBAA,512 IC 80C51 MCU 8BIT ROMLESS 44PLCC
相關代理商/技術參數
參數描述
LPC1313FHN33551 制造商:NXP Semiconductors 功能描述:IC 32BIT MCU ARM 72MHZ HVQFN-33
LPC1313FHN33CP3264 制造商:NXP Semiconductors 功能描述:- Trays
LPC1313FHN33CP3265 制造商:NXP Semiconductors 功能描述:- Trays
LPC1315 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:32-bit ARM Cortex-M3 microcontroller; up to 64 kB flash; up to 12 kB SRAM; USB device; USART; EEPROM
LPC1315FBD48 制造商:NXP Semiconductors 功能描述:MCU 32BIT ARM CORTEX-M3 48LQFP 制造商:NXP Semiconductors 功能描述:MCU, 32BIT, ARM CORTEX-M3, 48LQFP 制造商:NXP Semiconductors 功能描述:MCU, 32BIT, ARM CORTEX-M3, 48LQFP, Controller Family/Series:LPC13xx, Core Size:32bit, No. of I/O's:40, Supply Voltage Min:2V, Supply Voltage Max:3.6V, Digital IC Case Style:LQFP, No. of Pins:48, Program Memory Size:32KB, EEPROM , RoHS Compliant: Yes