- 您現在的位置：買賣IC網 > PDF目錄358771 > LC895196K (Sanyo Electric Co.,Ltd.) ATA-PI Compatible CD-ROM Decoder IC(ATA-PI接口兼容的CD-ROM譯碼器) PDF資料下載
參數資料
| 型號： | LC895196K |
| 廠商： | Sanyo Electric Co.,Ltd. |
| 英文描述： | ATA-PI Compatible CD-ROM Decoder IC(ATA-PI接口兼容的CD-ROM譯碼器) |
| 中文描述： | ATA的皮兼容CD - ROM解碼器IC（ATA的接口兼容的有價證券的CD - ROM譯碼器） |
| 文件頁數： | 12/12頁 |
| 文件大?。?/td> | 143K |
| 代理商： | LC895196K |
No. 5852-12/12
LC895196K
MCK2 (output)
This outputs the XTALCK0, XTALCK0/2, XTALCK0/5 and XTALCK0/512 frequencies. The output can also be
turned off.
MCK3 (output)
This outputs the XTALCK0, XTALCK*0/2, XTALCK0/5 and XTALCK0/512 frequencies. The output can also be
turned off.
ZRSTIC (output)
The ZRSTIC output goes low when the microcontroller register R46-bit7 (ZSYSRET) or the ZHRST pin is put low.
When both the ZSYSRET and ZHRST pins are high, ZRSTIC enters a high impedance state. Attach and external
pull-up resistor.
ZRSTCPU (output)
When an ATAPI soft reset command (08h) is received, a low pulse is generated for approximately 1 ms (when
XTALCK1 = 34 MHz). When this happens, an interrupt is sent to the microcontroller. When the ZRESET pin has
become active, the ZRESET signal is output directly at the ZRSTCPU. Attach an external pull-up resistor.
ATPINSEL (input)
By changing the input to this pin, the ATAPI-side pin layout can be reversed.
This catalog provides information as of December, 1997. Specifications and information herein are subject to
change without notice.
I
No products described or contained herein are intended for use in surgical implants, life-support systems, aerospace
equipment, nuclear power control systems, vehicles, disaster/crime-prevention equipment and the like, the failure of
which may directly or indirectly cause injury, death or property loss.
I
Anyone purchasing any products described or contained herein for an above-mentioned use shall:
Accept full responsibility and indemnify and defend SANYO ELECTRIC CO., LTD., its affiliates, subsidiaries and
distributors and all their officers and employees, jointly and severally, against any and all claims and litigation and all
damages, cost and expenses associated with such use:
Not impose any responsibility for any fault or negligence which may be cited in any such claim or litigation on
SANYO ELECTRIC CO., LTD., its affiliates, subsidiaries and distributors or any of their officers and employees
jointly or severally.
I
Information (including circuit diagrams and circuit parameters) herein is for example only; it is not guaranteed for
volume production. SANYO believes information herein is accurate and reliable, but no guarantees are made or implied
regarding its use or any infringements of intellectual property rights or other rights of third parties.
相關PDF資料 |
PDF描述 |
|---|---|
| LC895196 | ATA-PI Compatible CD-ROM Decoder IC(ATA-PI接口兼容的CD-ROM譯碼器) |
| LC895198 | CD-ROM Decoder for 32 ×ATAPI (IDE) Drives(CD-ROM譯碼器用于32倍速ATAPI (IDE)驅動) |
| LC895199K | 32 CD-ROM Decoder with ATAPI (IDE) Interface |
| LC895297 | Full CAV 20× CD-ROM Decoder with Built-in ATA-PI (IDE) Interface and CD-DSP(全CAV 20倍速CD-ROM譯碼器帶內置式ATAPI (IDE)接口和CD-DSP) |
| LC895299L | 48× Speed ATAPI (IDE) CD-ROM Decoder with On-Chip Digital Servo System(48倍速ATAPI (IDE) CD-ROM譯碼器帶片上數字伺服系統) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LC895198 | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:CD-ROM Decoder for 32 x ATAPI (IDE) Drives |
| LC895199K | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:32 CD-ROM Decoder with ATAPI (IDE) Interface |
| LC895297 | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:Full CAV 20 x CD-ROM Decoder with Built-in ATA-PI (IDE) Interface and CD-DSP |
| LC895299L | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:48 x Speed ATAPI (IDE) CD-ROM Decoder with On-Chip Digital Servo System |
| LC895299W | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:48 x Speed ATAPI (IDE) CD-ROM Decoder with On-Chip Digital Servo System |
發布緊急采購，3分鐘左右您將得到回復。