- 您現在的位置：買賣IC網 > PDF目錄43901 > L6919E (STMICROELECTRONICS) SWITCHING CONTROLLER, PDSO28 PDF資料下載
參數資料
| 型號： | L6919E |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING CONTROLLER, PDSO28 |
| 封裝： | SO-28 |
| 文件頁數： | 32/33頁 |
| 文件大?。?/td> | 644K |
| 代理商： | L6919E |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁當前第32頁第33頁
Obsolete
Product(s)
- Obsolete
Product(s)
L6919E
8/33
DEVICE DESCRIPTION
The device is an integrated circuit realized in BCD technology. It provides complete control logic and protections for
a high performance dual-phase step-down DC-DC converter optimized for microprocessor power supply. It is de-
signed to drive N Channel MOSFETs in a dual-phase synchronous-rectified buck topology. A 180 deg phase shift is
provided between the two phases allowing reduction in the input capacitor current ripple, reducing also the size and
the losses. The output voltage of the converter can be precisely regulated, programming the VID pins, from 0.825V to
1.575V with 25mV binary steps, with a maximum tolerance of ±0.6% over temperature and line voltage variations. The
device automatically regulates 25mV higher than the HAMMER DAC avoiding the use of any external set-up resistor.
The device manages On-The-Fly VID Code changes stepping to the new configuration following the VID table with no
need for external components. The device provides an average current-mode control with fast transient response. It
includes a 150kHz free-running oscillator. The error amplifier features a 15V/
s slew rate that permits high converter
bandwidth for fast transient performances. Current information is read across the lower mosfets RdsON or across a
sense resistor in fully differential mode. The current information corrects the PWM output in order to equalize the av-
erage current carried by each phase. Current sharing between the two phases is then limited at ±10% over static and
dynamic conditions. The device protects against Over-Current, with an OC threshold for each phase, entering in con-
stant current mode. Since the current is read across the low side mosfets, the constant current keeps constant the
bottom of the inductors current triangular waveform. When an under voltage is detected the device latches and the
FAULT pin is driven high. The device performs also Over-Voltage protection that disables immediately the device turn-
ing ON the lower driver and driving high the FAULT pin.
OSCILLATOR
The switching frequency is internally fixed at 150kHz. Each phase works at the frequency fixed by the oscillator so
that the resulting switching frequency at the load side results in being doubled.
The internal oscillator generates the triangular waveform for the PWM charging and discharging with a constant cur-
rent an internal capacitor. The current delivered to the oscillator is typically 25 A (Fsw=150kHz) and may be varied
using an external resistor (ROSC) connected between OSC pin and GND or Vcc. Since the OSC pin is maintained at
fixed voltage (Typ. 1.237V), the frequency is varied proportionally to the current sunk (forced) from (into) the pin con-
sidering the internal gain of 6KHz/
A.
In particular connecting it to GND the frequency is increased (current is sunk from the pin), while connecting ROSC
to Vcc=12V the frequency is reduced (current is forced into the pin), according to the following relationships:
Note that forcing a 25
A into this pin, the device stops switching because no current is delivered to the oscillator.
Figure 1. ROSC vs. Switching Frequency
R
OSC vs. GND: fS
150 kHz
1.237
R
OSC
--------------- 6
kH z
A
-----------
+
150kHz
7.422 10
6
R
OSC K
()
------------------------------
+
==
R
OSC vs. 12V: fS
150kHz
12
1.237
–
R
OSC
--------------------------- 6
kHz
A
-----------
–
150 kHz
6.457 10
7
R
OSC K
()
------------------------------
–
==
0
2000
4000
6000
8000
10000
12000
14000
25
50
75
100
125
150
Frequency (KHz)
R
o
sc(
K
)v
s
.1
2
V
0
100
200
300
400
500
600
700
800
150
250
350
450
550
650
Frequency (KHz)
R
o
sc(
K
)vs.
G
N
D
相關PDF資料 |
PDF描述 |
|---|---|
| L6920DTR | 1.2 A SWITCHING REGULATOR, PDSO8 |
| L6920D | 1.2 A SWITCHING REGULATOR, PDSO8 |
| L6920 | 1.2 A SWITCHING REGULATOR, PDSO8 |
| L6924D013TR | 1-CHANNEL POWER SUPPLY SUPPORT CKT, QCC16 |
| L6926D | 1.4 A SWITCHING REGULATOR, 600 kHz SWITCHING FREQ-MAX, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| L6919ETR | 功能描述:DC/DC 開關控制器 5-Bit Dual Ph Contlr RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| L-692 | 制造商:RHOMBUS-IND 制造商全稱:Rhombus Industries Inc. 功能描述:Common Mode Inductor |
| L6920 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:1V HIGH EFFICIENCY SYNCRONOUS STEP UP CONVERTER |
| L6920D | 功能描述:直流/直流開關轉換器 0.6 to 5.5V Step-Up RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| L6920DB | 功能描述:直流/直流開關轉換器 Synchronous Rectifer Step Up Converter RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。