參數資料
型號： KAD5512HP-12Q72
廠商： Intersil
文件頁數： 13/34頁
文件大?。?/td> 0K
描述： IC ADC 12BIT 125MSPS SGL 72-QFN
產品培訓模塊： High-Speed Analog-to-Digital Converters
標準包裝： 1
系列： FemtoCharge™
位數： 12
采樣率（每秒）： 125M
數據接口： 串行，SPI?
轉換器數目： 1
功率耗散（最大）： 376mW
電壓電源： 單電源
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 72-VFQFN 裸露焊盤
供應商設備封裝： 72-QFN（10x10）
包裝： 托盤
輸入數目和類型： 1 個差分，單極
20
FN6808.3
October 1, 2009
The clock divider can also be controlled through the SPI
port, which overrides the CLKDIV pin setting. Details on this
A delay-locked loop (DLL) generates internal clock signals
for various stages within the charge pipeline. If the frequency
of the input clock changes, the DLL may take up to 52s to
regain lock at 250MSPS. The lock time is inversely
proportional to the sample rate.
The DLL has two ranges of operation, slow and fast. The
slow range can be used for sample rates between 40MSPS
and 100MSPS, while the default fast range can be used from
80MSPS to the maximum specified sample rate.
Jitter
In a sampled data system, clock jitter directly impacts the
achievable SNR performance. The theoretical relationship
between clock jitter (tJ) and SNR is shown in Equation 1 and
is illustrated in Figure 30.
This relationship shows the SNR that would be achieved if
clock jitter were the only non-ideal factor. In reality,
achievable SNR is limited by internal factors such as
linearity, aperture jitter and thermal noise. Internal aperture
jitter is the uncertainty in the sampling instant shown in
Figure 1 on page 7. The internal aperture jitter combines
with the input clock jitter in a root-sum-square fashion, since
they are not statistically correlated, and this determines the
total jitter in the system. The total jitter, combined with other
noise sources, then determines the achievable SNR.
Voltage Reference
A temperature compensated voltage reference provides the
reference charges used in the successive approximation
operations. The full-scale range of each A/D is proportional
to the reference voltage. The voltage reference is internally
bypassed and is not accessible to the user.
Digital Outputs
Output data is available as a parallel bus in
LVDS-compatible or CMOS modes. Additionally, the data
can be presented in either double data rate (DDR) or single
data rate (SDR) formats. The even numbered data output
pins are active in DDR mode in the 72 pin package option.
When CLKOUT is low the MSB and all odd logical bits are
output, while on the high phase the LSB and all even logical
bits are presented (this is true in both the 72 pin and 48 pin
package options). Figures 1 and 2 show the timing
relationships for LVDS/CMOS and DDR/SDR modes.
The 48 Ld QFN package option contains six LVDS data
output pin pairs, and therefore can only support DDR mode.
Additionally, the drive current for LVDS mode can be set to a
nominal 3mA or a power-saving 2mA. The lower current
setting can be used in designs where the receiver is in close
physical proximity to the ADC. The applicability of this setting
is dependent upon the PCB layout, therefore the user should
experiment to determine if performance degradation is
observed.
The output mode and LVDS drive current are selected via
the OUTMODE pin as shown in Table 2.
The output mode can also be controlled through the SPI
port, which overrides the OUTMODE pin setting. Details on
An external resistor creates the bias for the LVDS drivers. A
10k
Ω, 1% resistor must be connected from the RLVDS pin to
OVSS.
Over-Range Indicator
The over-range (OR) bit is asserted when the output code
reaches positive full-scale (e.g. 0xFFF in offset binary
mode). The output code does not wrap around during an
over-range condition. The OR bit is updated at the sample
rate.
Power Dissipation
The power dissipated by the KAD5512HP is primarily
dependent on the sample rate and the output modes: LVDS
vs CMOS and DDR vs SDR. There is a static bias in the
analog supply, while the remaining power dissipation is
linearly related to the sample rate. The output supply
dissipation changes to a lesser degree in LVDS mode, but is
more strongly related to the clock frequency in CMOS mode.
SNR
20 log
10
1
2
πf
IN tJ
--------------------
=
(EQ. 1)
FIGURE 30. SNR vs CLOCK JITTER
tj = 100ps
tj = 10ps
tj = 1ps
tj = 0.1ps
10 BITS
12 BITS
14 BITS
50
55
60
65
70
75
80
85
90
95
100
1M
10M
100M
1G
SN
R
(dB)
INPUT FREQUENCY (Hz)
TABLE 2. OUTMODE PIN SETTINGS
OUTMODE PIN
MODE
AVSS
LVCMOS
Float
LVDS, 3mA
AVDD
LVDS, 2mA
KAD5512HP
相關PDF資料
PDF描述
SI4126-F-GM IC WLAN SYNTH (RF2/IF) 28MLP
KAD5512HP-12Q48 IC ADC 12BIT 125MSPS SGL 48-QFN
VE-B12-MW-F2 CONVERTER MOD DC/DC 15V 100W
VE-B12-MW-F1 CONVERTER MOD DC/DC 15V 100W
KAD2710C-21Q68 IC ADC 10BIT 210MSPS SGL 68-QFN
相關代理商/技術參數
參數描述
KAD5512HP-17Q48 功能描述:模數轉換器 - ADC 12-BIT 170MSPS HI PERF SINGLE ADC RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32
KAD5512HP-17Q72 功能描述:模數轉換器 - ADC 12-BIT 170MSPS HI PERF SINGLE ADC RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32
KAD5512HP-21Q48 功能描述:模數轉換器 - ADC 12-BIT 210MSPS HI PERF SINGLE ADC PROG RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32
KAD5512HP-21Q72 功能描述:模數轉換器 - ADC 12-BIT 210MSPS HI PERF SINGLE ADC PROG RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32
KAD5512HP-25Q48 功能描述:模數轉換器 - ADC 12-BIT 250MSPS HI PERF SINGLE ADC RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*