- 您現在的位置：買賣IC網 > PDF目錄370390 > GS9022A Serializer for SDI at 270-360Mb/s with Cable Driver PDF資料下載
參數資料
| 型號： | GS9022A |
| 英文描述： | Serializer for SDI at 270-360Mb/s with Cable Driver |
| 中文描述： | 串行器在270 - 360Mb / s的的SDI電纜驅動器 |
| 文件頁數： | 5/30頁 |
| 文件大?。?/td> | 445K |
| 代理商： | GS9022A |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁
19922 - 2
5
G
27
A/D
I
Parallel port address/data bus control. When HIGH, the parallel port is used for address input.
When LOW, the parallel port is used for data input or output. In I
2
C mode, this pin must be set
LOW.
28
CS
I
Parallel port chip select. When CS is LOW and R/W is HIGH, the GS9020A drives the address/
data bus. When CS is LOW and R/W is LOW, the user should drive the address/data bus.
When CS is HIGH, the address/data bus is in a high impedance state (Hi - Z). In I
2
C mode, this
pin must be set HIGH.
31
RESET
I
Reset. When LOW, the internal control circuitry is reset.
32 - 35
STD[3:0]
O
Video standards indication as described in section 1.4
36 - 40
FL[4:0]
I/O
EDH flag data port to allow access to the EDH flags.
41, 42
S[1:0]
I/O
Control bits which select whether FF, AP, or ANC EDH flags are active on the EDH flag data
port (FL[4:0]). In FLAG_MAP mode, the S[1:0] pins become outputs (see device description).
43
F_R/W
I
Flag port read/write control. When HIGH, FL[4:0] are configured as outputs allowing EDH flags
to be read from the device. When LOW, FL[4:0] are configured as inputs allowing EDH flags to
be overwritten in the outgoing EDH packet. In FLAG_MAP mode this pin must be set HIGH.
44
INTERRUPT
O
Interrupt output. This output goes low when EDH errors occur. This pin is an open drain output
and requires an external pullup resistor. If this output is not used, a pullup resistor is not
required.
45
FLYWDIS
I
Flywheel disable. When HIGH, the internal flywheel is disabled. When LOW, the internal
flywheel is enabled.
46
NO_EDH
O
No EDH present indication. When HIGH, indicates EDH packets are not present in the
incoming data stream.
47
FIFO_RESET
O
FIFO Reset output. Asserted LOW during the TRSID word for composite standards and the
EAV or SAV word for component standards.
48
PCLKOUT
O
Parallel clock output.
52-60,49
DOUT[9:0]
O
Parallel digital video data outputs.
61
V
O
Vertical sync indication.
62
H
O
Horizontal sync indication.
63 - 65
F[2:0]
O
Field indication. F2 is the MSB.
66
FLAG_MAP
I
FLAG_MAP mode enable. When HIGH, FLAG_MAP mode is enabled.
When LOW, FLAG_MAP mode is disabled.
70, 71
SDO/SDO
O
Differential serial data outputs.
73
VBLANKS/L
I
Vertical blanking interval control. For NTSC signals, when VBLANKS/L is set LOW the 19 line
blanking interval is selected and when set HIGH the 9 line blanking interval is selected. For
PAL D2 signals, when VBLANKS/L is set LOW the 17 line blanking interval is selected and
when set HIGH the 7 line blanking interval is selected. For PAL component signals VBLANKS/L
should be set LOW.
74
BYPASS_EDH
I
Bypass EDH control. When HIGH, the device allows the EDH packet to pass through
unaltered.
75
SDOMODE
I
Serial data output control. When LOW, the serial data output is re-serialized processed data.
When HIGH, the serial data output is the looped through serial input. After changing
SDOMODE, the GS9020A must be reset for proper operation.
76
BLANK_EN
I
Blanking enable. When LOW, incoming data words are set to appropriate blanking levels.
77
ANC_CHKSM
I
Ancillary checksum updating enable. When HIGH, ancillary checksum updating is enabled.
PIN DESCRIPTIONS
NUMBER
SYMBOL
TYPE
DESCRIPTION
相關PDF資料 |
PDF描述 |
|---|---|
| GS9022ACPJ | Peripheral IC |
| GS9022ACTJ | Peripheral IC |
| GS9022-CJP | SMPTE |
| GS9023A | SD Embedded Audio CODEC |
| GS9025 | GENLINX II Serial Digital Receiver |
相關代理商/技術參數 |
參數描述 |
|---|---|
| GS9022ACPJ | 制造商:Rochester Electronics LLC 功能描述: 制造商:Gennum Corporation 功能描述: |
| GS9022ACPJE3 | 制造商:Semtech Corporation 功能描述:Digital Video Serializer 28-Pin PLCC |
| GS9022ACTJ | 制造商:GENNUM 制造商全稱:GENNUM 功能描述:GENLINXTM GS9022A Digital Video Serializer |
| GS9022ACTJE3 | 制造商:GENNUM 制造商全稱:GENNUM 功能描述:GENLINXTM GS9022A Digital Video Serializer |
| GS9022-CJP | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:SMPTE |
發布緊急采購，3分鐘左右您將得到回復。