Sin" />
參數資料
型號: FIN210ACMLX
廠商: Fairchild Semiconductor
文件頁數: 5/17頁
文件大?。?/td> 0K
描述: IC SER/DES 10BIT 32-MLP
標準包裝: 3,000
功能: 串行器/解串器
輸入類型: LVCMOS
輸出類型: 串行
輸入數: 10
輸出數: 1
電源電壓: 1.65 V ~ 3.6 V
工作溫度: -30°C ~ 70°C
安裝類型: 表面貼裝
封裝/外殼: 32-WFQFN 裸露焊盤
供應商設備封裝: 32-MLP(5x5)
包裝: 帶卷 (TR)
SC16IS741_1
NXP B.V. 2010. All rights reserved.
Product data sheet
Rev. 01 — 29 April 2010
13 of 52
NXP Semiconductors
SC16IS741
Single UART with I2C-bus/SPI interface, 64-byte FIFOs, IrDA SIR
7.6 Sleep mode
Sleep mode is an enhanced feature of the SC16IS741 UART. It is enabled when EFR[4],
the enhanced functions bit, is set and when IER[4] is set. Sleep mode is entered when:
The serial data input line, RX, is idle (see Section 7.7 “Break and time-out
The TX FIFO and TX shift register are empty.
There are no interrupts pending except THR.
Remark: Sleep mode will not be entered if there is data in the RX FIFO.
In Sleep mode, the clock to the UART is stopped. Since most registers are clocked using
these clocks, the power consumption is greatly reduced. The UART will wake up when
any change is detected on the RX line, when there is any change in the state of the
modem input pins, or if data is written to the TX FIFO.
Remark: Writing to the divisor latches, DLL and DLH, to set the baud clock, must not be
done during Sleep mode. Therefore, it is advisable to disable Sleep mode using IER[4]
before writing to DLL or DLH.
7.7 Break and time-out conditions
When the UART receives a number of characters and these data are not enough to set off
the receive interrupt (because they do not reach the receive trigger level), the UART will
generate a time-out interrupt instead, 4 character times after the last character is
received. The time-out counter will be reset at the center of each stop bit received or each
time the receive FIFO is read.
A break condition is detected when the RX pin is pulled LOW for a duration longer than
the time it takes to send a complete character plus Start, Stop and Parity bits. A break
condition can be sent by setting LCR[6]. When this happens the TX pin will be pulled LOW
until LSR[6] is cleared by the software.
7.8 Programmable baud rate generator
The SC16IS741 UART contains a programmable baud rate generator that takes any clock
input and divides it by a divisor in the range between 1 and (216 – 1). An additional
divide-by-4 prescaler is also available and can be selected by MCR[7], as shown in
Figure 10. The output frequency of the baud rate generator is 16 times the baud rate. The
formula for the divisor is given in Equation 1:
(1)
where:
prescaler = 1, when MCR[7] is set to ‘0’ after reset (divide-by-1 clock selected)
prescaler = 4, when MCR[7] is set to ‘1’ after reset (divide-by-4 clock selected).
Remark: The default value of prescaler after reset is divide-by-1.
Figure 10 shows the internal prescaler and baud rate generator circuitry.
divisor
XTAL1 crystal input frequency
prescaler
-----------------------------------------------------------------------------------
desired baud rate
16
×
-----------------------------------------------------------------------------------------
=
相關PDF資料
PDF描述
FIN212ACGFX IC SER/DESER 12BIT 42USS-BGA
FIN224ACGFX IC SERIALIZER/DESERIALIZER 42BGA
FIN224CMLX IC SER/DES 24-BIT BIDIR 40-MLP
FIN324CGFX IC SER DES 24BIT ULP 42-BGA
FIN424CMLX IC SERIALIZER 20BIT 32-MLP
相關代理商/技術參數
參數描述
FIN212AC 制造商:FAIRCHILD 制造商全稱:Fairchild Semiconductor 功能描述:12-Bit Serializer Deserializer with Multiple Frequency Ranges
FIN212AC_08 制造商:FAIRCHILD 制造商全稱:Fairchild Semiconductor 功能描述:12-Bit Serializer Deserializer with Multiple Frequency Ranges
FIN212ACBFX 制造商:Fairchild Semiconductor Corporation 功能描述:
FIN212ACGFX 功能描述:LVDS 接口集成電路 12-Bit Serializer Deserializer RoHS:否 制造商:Texas Instruments 激勵器數量:4 接收機數量:4 數據速率:155.5 Mbps 工作電源電壓:5 V 最大功率耗散:1025 mW 最大工作溫度:+ 85 C 封裝 / 箱體:SOIC-16 Narrow 封裝:Reel
FIN212ACMLX 功能描述:LVDS 接口集成電路 12-Bit Serializer Deserializer RoHS:否 制造商:Texas Instruments 激勵器數量:4 接收機數量:4 數據速率:155.5 Mbps 工作電源電壓:5 V 最大功率耗散:1025 mW 最大工作溫度:+ 85 C 封裝 / 箱體:SOIC-16 Narrow 封裝:Reel