- 您現在的位置：買賣IC網 > PDF目錄357779 > EL7532IL-T7 (INTERSIL CORP) 2.4 A SWITCHING REGULATOR, 1650 kHz SWITCHING FREQ-MAX, PDSO10 PDF資料下載
參數資料
| 型號： | EL7532IL-T7 |
| 廠商： | INTERSIL CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 2.4 A SWITCHING REGULATOR, 1650 kHz SWITCHING FREQ-MAX, PDSO10 |
| 封裝： | 3 X 3 MM, 1 MM HEIGHT, MO-229, DFN-10 |
| 文件頁數： | 6/9頁 |
| 文件大?。?/td> | 829K |
| 代理商： | EL7532IL-T7 |
6
Applications Information
Product Description
The EL7532 is a synchronous, integrated FET 2A step-down
regulator which operates from an input of 2.5V to 6V. The
output voltage is user-adjustable with a pair of external
resistors.
The internally-compensated controller makes it possible to
use only two ceramic capacitors and one inductor to form a
complete, very small footprint 2A DC-DC converter.
Start-Up and Shut-Down
When the EN pin is tied to V
IN
, and V
IN
reaches
approximately 2.4V, the regulator begins to switch. The
output voltage is gradually increased to ensure proper soft-
start operation.
When the EN pin is connected to a logic low, the EL7532 is
in the shut-down mode. All the control circuitry and both
MOSFETs are off, and V
OUT
falls to zero. In this mode, the
total input current is less than 1μA.
When the EN reaches logic HI, the regulator repeats the
start-up procedure, including the soft-start function.
PWM Operation
In the PWM mode, the P channel MOSFET and N channel
MOSFET always operate complementary. When the
PMOSFET is on and the NMOSFET off, the inductor current
increases linearly. The input energy is transferred to the
output and also stored in the inductor. When the P channel
MOSFET is off and the N channel MOSFET on, the inductor
current decreases linearly, and energy is transferred from
the inductor to the output. Hence, the average current
through the inductor is the output current. Since the inductor
and the output capacitor act as a low pass filter, the duty
cycle ratio is approximately equal to V
O
divided by V
IN
.
The output LC filter has a second order effect. To maintain
the stability of the converter, the overall controller must be
compensated. This is done with the fixed internally
compensated error amplifier and the PWM compensator.
Because the compensations are fixed, the values of input
and output capacitors are 10μF to 22μF ceramic. The
inductor is nominally 1.8μH, though 1.5μA to 2.2μH can be
used.
100% Duty Ratio Operation
EL7532 utilizes CMOS power FET's as the internal
synchronous power switches. The upper switch is a PMOS
and lower switch a NMOS. This not only saves a boot
capacitor, it also allows 100% turn-on of the upper PFET
switch, achieving V
O
close to V
IN
. The maximum achievable
V
O
is,
Where RL is the DC resistance on the inductor and R
DSON1
the PFET on-resistance, nominal 70m
at room temperature
with tempco of 0.2m
/°C.
As the input voltage drops gradually close or even bellow the
preset V
O
, the converter gets into 100% duty ratio. At this
condition, the upper PFET needs some minimum turn-off
time if it is turned off. This off-time is related to input/output
conditions. This makes the duty ratio appears randomly and
increases the output ripple somewhat until the 100% duty
ratio is reached. Larger output capacitor could reduce the
random-looking ripple. Users need to verify if this condition
has adverse effect on overall circuit if close to 100% duty
ratio is expected.
RSI/POR Function
When powering up, the open-collector Power-On-Reset
output holds low for about 100ms after V
O
reaches the
preset voltage. When the active-HI reset signal RSI is
issued, POR goes to low immediately and holds for the
same period of time after RSI comes back to LOW. The
output voltage is unaffected. (Please refer to the timing
diagram). When the function is not used, connect RSI to
ground and leave open the pull-up resister R
4
at POR pin.
The POR output also serves as a 100ms delayed Power
Good signal when the pull-up resister R
4
is installed. The
RSI pin needs to be directly (or indirectly through a resister
R
6
) connected to Ground for this to function properly.
Output Voltage Selection
Users can set the output voltage of the converter with a
resister divider, which can be chosen based on the following
formula:
Component Selection
Because of the fixed internal compensation, the component
choice is relatively narrow. We recommend 10μF to 22μF
multi-layer ceramic capacitors with X5R or X7R rating for
both the input and output capacitors, and 1.5μH to 2.2μH
inductance for the inductor.
V
O
V
IN
R
L
R
DSON1
+
(
)
I
O
×
–
=
100ms
MIN
25ns
100ms
POR
RSI
V
O
FIGURE 10. RSI & POR TIMING DIAGRAM
V
O
0.8
1
R
2
R
1
------
+
×
=
EL7532
相關PDF資料 |
PDF描述 |
|---|---|
| ELC0607RA-560KR72 | 1 ELEMENT, 56 uH, GENERAL PURPOSE INDUCTOR |
| ELD-425USOWA/S530-A4 | 7 SEG NUMERIC DISPLAY, REDDISH ORANGE, 10.16 mm |
| ELED/1750/DMC/12 | SINGLE COLOR LED, HIGH EFFICIENCY RED, 6.35 mm |
| ELF-511SYGWA/S530-E2 | 7 SEG NUMERIC DISPLAY, BRILLIANT YELLOW GREEN, 14.22 mm |
| ELF-512UBWA/C470 | 7 SEG NUMERIC DISPLAY, BLUE, 14.22 mm |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EL7532IY | 功能描述:IC REG BUCK SYNC ADJ 2A 10MSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:3.3V 輸入電壓:4.5 V ~ 24 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:125mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 包裝:Digi-Reel® 供應商設備封裝:SOT-6 其它名稱:MAX1836EUT33#TG16DKR |
| EL7532IY-T13 | 功能描述:直流/直流開關調節器 EL7532IY MONOLITHIC 2A STP-DWNG RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| EL7532IY-T7 | 功能描述:IC REG BUCK SYNC ADJ 2A 10MSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:3.3V 輸入電壓:4.5 V ~ 24 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:125mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 包裝:Digi-Reel® 供應商設備封裝:SOT-6 其它名稱:MAX1836EUT33#TG16DKR |
| EL7532IYZ | 功能描述:直流/直流開關調節器 EL7532IYZ MONOLITHIC 2A STP-DWNG RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| EL7532IYZ-T13 | 功能描述:直流/直流開關調節器 EL7532IYZ MONOLITHIC 2A STP-DWNG RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
發布緊急采購，3分鐘左右您將得到回復。