- 您現在的位置：買賣IC網 > PDF目錄97902 > EL4331C Triple 2:1 Mux-Amp AV = 1 PDF資料下載
參數資料
| 型號： | EL4331C |
| 英文描述： | Triple 2:1 Mux-Amp AV = 1 |
| 中文描述： | 三2:1復用放大器影音\u003d 1 |
| 文件頁數： | 13/13頁 |
| 文件大?。?/td> | 1648K |
| 代理商： | EL4331C |
9
EL4331C
Triple 2:1 Mux-Amp AV = 1
EL
4331C
significant output disturbance as one part turns on before
the other has fully turned off.
Single Supply Operation
Due to the fact that video signals often have negative
sync levels and invariably require ground to be within
the signal swing, running the EL4331 on a single supply
rail compromises many aspects of its performance. It is
difficult to generate a solid, clean, pseudo ground a few
volts away from ground without using more power, and
components than simply providing a negative power
rail. A signal ground has to be capable of handling all the
return currents from all the inputs, as well as the outputs,
from DC to frequencies in excess of 400 MHz. While
this is by no means impossible, a negative rail can be
generated from a standard +5V rail for a couple of dol-
lars and a square inch, or less, of board space. However,
a pseudo ground can be derived with for example an
LM336, to give an “AC ground” 2.5V above 0V. The
logic inputs will need some form of level shifting to
ensure that the logic “1” and “0” specifications can be
met. The pseudo ground must be well bypassed to the
real ground; note that the pseudo ground will have to
sink/source all the current that flows in the internal com-
pensation capacitors during slewing. This can easily be
several milliamps in a few nanoseconds. If the pseudo
ground “moves” because one channel is forcing current
into the derived ground, cross-talk into the other two
channels will become very significant.
Application Circuit #1
Figure 1 shows a very high speed RGB (or YUV) multi-
plexer. Two video sources can be displayed on one
monitor with the only stipulation that the video sources
have to be synchronous. An example is a picture-in-pic-
ture, or “window” is generated with one video source
(e.g. RGB TV) in a window, and a computer application
around it. Multiplexing synchronous RGB signals has
the advantage that the video signals do not have to be
digitized, and an image stored in RAM prior to being
displayed.
When the monitor is switched off, or goes into its
power-saving blanked mode, the EL4331 can be pow-
ered down to further save power. The input impedance
does not change appreciably between powered up and
down modes, although the bias current does drop to near
zero.
Figure 1. Two RGB Sources Multiplexed to One RGB Output
相關PDF資料 |
PDF描述 |
|---|---|
| EL4331CS | Triple 2:1 Mux-Amp AV = 1 |
| EL4332 | Triple 2:1 300 MHz Mux-Amp AV =2 |
| EL4332C | Triple 2:1 300 MHz Mux-Amp AV =2 |
| EL4332CS | Triple 2:1 300 MHz Mux-Amp AV =2 |
| EL4390C | 80 MHz Video Amplifier with DC Restore(80 MHz，視頻放大器（帶直流恢復）) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EL4331CS | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Triple 2:1 Mux-Amp AV = 1 |
| EL4331CS-T13 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Triple 2:1 Mux-Amp AV = 1 |
| EL4331CS-T7 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Triple 2:1 Mux-Amp AV = 1 |
| EL4331CSZ | 制造商:Rochester Electronics LLC 功能描述: 制造商:Intersil Corporation 功能描述: |
| EL4331CSZ-T13 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Triple 2:1 Mux-Amp AV = 1 |
發布緊急采購，3分鐘左右您將得到回復。