- 您現在的位置：買賣IC網 > PDF目錄10992 > DS2151QNB (Maxim Integrated Products)IC TXRX T1 1-CH 5V LP IND 44PLCC PDF資料下載
參數資料
| 型號： | DS2151QNB |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 56/60頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC TXRX T1 1-CH 5V LP IND 44PLCC |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 26 |
| 功能： | 單芯片收發器 |
| 接口： | T1 |
| 電路數： | 1 |
| 電源電壓： | 4.75 V ~ 5.25 V |
| 電流 - 電源： | 65mA |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 44-LCC（J 形引線） |
| 供應商設備封裝： | 44-PLCC（16.59x16.59） |
| 包裝： | 管件 |
| 包括： | 警報檢測器和發生器，CSU 回路代碼發生器和檢測器，DSX-1和CSU 線路補償發生器 |
| 產品目錄頁面： | 1429 (CN2011-ZH PDF) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁當前第56頁第57頁第58頁第59頁第60頁
DS2151Q
6 of 60
2 PIN DESCRIPTION
PIN
NAME
TYPE
FUNCTION
1–4,
41–44
AD4–AD7,
AD0–AD3
I/O
Address/Data Bus. An 8-bit multiplexed address/data bus.
5
RD(DS)
I
Active-Low Read Input (Data Strobe)
6
CS
I
Active-Low Chip Select. Must be low to read or write the port.
7
ALE(AS)
I
Address Latch Enable (Address Strobe). A positive going edge serves to
demultiplex the bus.
8
WR(R/W)
I
Active-Low Write Input (Read/Write)
9
RLINK
O
Receive Link Data. Updated with either FDL data (ESF) or Fs bits (D4) or
Z bits (ZBTSI) one RCLK before the start of a frame. See Section 14 for
timing details.
10
RLCLK
O
Receive Link Clock. 4kHz or 2kHz (ZBTSI) demand clock for the RLINK
output. See Section 14 for timing details.
11
DVSS
—
Digital Signal Ground. 0.0V. Should be tied to local ground plane.
12
RCLK
O
Receive Clock. Recovered 1.544MHz clock.
13
RCHCLK
O
Receive Channel Clock. 192kHz clock that pulses high during the LSB of
each channel. Useful for parallel to serial conversion of channel data,
locating Robbed-Bit signaling bits, and for blocking clocks in DDS
applications. See Section 14 for timing details.
14
RSER
O
Receive Serial Data. Received NRZ serial data, updated on rising edges of
RCLK or SYSCLK.
15
RSYNC
I/O
Receive Sync. An extracted pulse, one RCLK wide, is output at this pin,
which identifies either frame (RCR2.4 = 0) or multiframe boundaries
(RCR2.4 = 1). If set to output frame boundaries, then via RCR2.5, RSYNC
can also be set to output double-wide pulses on signaling frames. If the
elastic store is enabled via the CCR1.2, then this pin can be enabled to be
an input via RCR2.3 at which a frame boundary pulse is applied. See
Section 14 for timing details.
16
RLOS/LOT
C
O
Receive Loss of Sync/Loss of Transmit Clock. A dual function output. If
CCR3.5 = 0, will toggle high when the synchronizer is searching for the T1
frame and multiframe; if CCR3.5 = 1, will toggle high if the TCLK pin has
not toggled for 5
s.
17
SYSCLK
I
System Clock. 1.544MHz or 2.048MHz clock. Only used when the elastic
store functions are enabled via either CCR1.7 or CCR1.2. Should be tied
low in applications that do not use the elastic store. If tied high for more
than 100
s, will force all output pins (including the parallel port) to tri-
state.
18
RCHBLK
O
Receive Channel Block. A user-programmable output that can be forced
high or low during any of the 24 T1 channels. Useful for blocking clocks to
a serial UART or LAPD controller in applications where not all T1
channels are used such as Fractional T1, 384kbps service, 768kbps, or
ISDN-PRI. Also useful for locating individual channels in drop-and-insert
applications. See Section 14 for timing details.
19
ACLKI
I
Alternate Clock Input. Upon a receive carrier loss, the clock applied at
this pin (normally 1.544MHz) will be routed to the RCLK pin. If no clock
is routed to this pin, then it should be tied to DVSS via a 1k
resistor.
相關PDF資料 |
PDF描述 |
|---|---|
| VI-B0Z-IY-F1 | CONVERTER MOD DC/DC 2V 20W |
| VI-B0Z-IX-F2 | CONVERTER MOD DC/DC 2V 30W |
| VI-B0Y-IY-F2 | CONVERTER MOD DC/DC 3.3V 33W |
| VI-B0Y-IX-F2 | CONVERTER MOD DC/DC 3.3V 49.5W |
| VI-B0X-IY-F4 | CONVERTER MOD DC/DC 5.2V 50W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS2151QNB/T&R | 制造商:Maxim Integrated Products 功能描述:T1 SINGLE CHIP XCVR REV B IND - Tape and Reel |
| DS2151QNB/T&R | 功能描述:網絡控制器與處理器 IC RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
| DS2151QNB+ | 功能描述:網絡控制器與處理器 IC RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
| DS2151QNB+T&R | 制造商:Maxim Integrated Products 功能描述:FRAMER DS1/E1/ISDN-PRI/T1 5V 44PLCC - Tape and Reel |
| DS2151QNB+T&R | 功能描述:網絡控制器與處理器 IC RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。