- 您現在的位置：買賣IC網 > PDF目錄97859 > DS1307Z (MAXIM INTEGRATED PRODUCTS INC) 1 TIMER(S), REAL TIME CLOCK, PDSO8 PDF資料下載
參數資料
| 型號： | DS1307Z |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | Timer or RTC |
| 英文描述： | 1 TIMER(S), REAL TIME CLOCK, PDSO8 |
| 封裝： | 0.150 INCH, SOIC-8 |
| 文件頁數： | 14/17頁 |
| 文件大?。?/td> | 765K |
| 代理商： | DS1307Z |
DS1307 64 x 8, Serial, I
2C Real-Time Clock
6 of 15
PIN DESCRIPTION
PIN
NAME
FUNCTION
1
X1
2
X2
Connections for Standard 32.768kHz Quartz Crystal. The internal oscillator circuitry is
designed for operation with a crystal having a specified load capacitance (CL) of 12.5pF.
X1 is the input to the oscillator and can optionally be connected to an external 32.768kHz
oscillator. The output of the internal oscillator, X2, is floated if an external oscillator is
connected to X1.
Note: For more information on crystal selection and crystal layout considerations, refer to
Application Note 58: Crystal Considerations with Dallas Real-Time Clocks.
3
VBAT
Backup Supply Input for Any Standard 3V Lithium Cell or Other Energy Source. Battery
voltage must be held between the minimum and maximum limits for proper operation.
Diodes in series between the battery and the VBAT pin may prevent proper operation. If a
backup supply is not required, VBAT must be grounded. The nominal power-fail trip point
(VPF) voltage at which access to the RTC and user RAM is denied is set by the internal
circuitry as 1.25 x VBAT nominal. A lithium battery with 48mAhr or greater will back up
the DS1307 for more than 10 years in the absence of power at +25°C.
UL recognized to ensure against reverse charging current when used with a lithium
battery. Go to: www.maxim-ic.com/qa/info/ul/.
4
GND
Ground
5
SDA
Serial Data Input/Output. SDA is the data input/output for the I2C serial interface. The
SDA pin is open drain and requires an external pullup resistor.
6
SCL
Serial Clock Input. SCL is the clock input for the I2C interface and is used to synchronize
data movement on the serial interface.
7
SWQ/OUT
Square Wave/Output Driver. When enabled, the SQWE bit set to 1, the SQW/OUT pin
outputs one of four square-wave frequencies (1Hz, 4kHz, 8kHz, 32kHz). The SQW/OUT
pin is open drain and requires an external pullup resistor. SQW/OUT operates with either
VCC or VBAT applied.
8
VCC
Primary Power Supply. When voltage is applied within normal limits, the device is fully
accessible and data can be written and read. When a backup supply is connected to the
device and VCC is below VTP, read and writes are inhibited. However, the timekeeping
function continues unaffected by the lower input voltage.
DETAILED DESCRIPTION
The DS1307 is a low-power clock/calendar with 56 bytes of battery-backed SRAM. The clock/calendar
provides seconds, minutes, hours, day, date, month, and year information. The date at the end of the
month is automatically adjusted for months with fewer than 31 days, including corrections for leap year.
The DS1307 operates as a slave device on the I2C bus. Access is obtained by implementing a START
condition and providing a device identification code followed by a register address. Subsequent registers
can be accessed sequentially until a STOP condition is executed. When VCC falls below 1.25 x VBAT, the
device terminates an access in progress and resets the device address counter. Inputs to the device will not
be recognized at this time to prevent erroneous data from being written to the device from an out-of-
tolerance system. When VCC falls below VBAT, the device switches into a low-current battery-backup
mode. Upon power-up, the device switches from battery to VCC when VCC is greater than VBAT +0.2V and
recognizes inputs when VCC is greater than 1.25 x VBAT. The block diagram in Figure 1 shows the main
elements of the serial RTC.
相關PDF資料 |
PDF描述 |
|---|---|
| DS1307N | 1 TIMER(S), REAL TIME CLOCK, PDIP8 |
| DS1307ZN | 1 TIMER(S), REAL TIME CLOCK, PDSO8 |
| DS1307 | 1 TIMER(S), REAL TIME CLOCK, PDIP8 |
| DS1315EN-5 | 0 TIMER(S), REAL TIME CLOCK, PDSO20 |
| DS1315-5 | 0 TIMER(S), REAL TIME CLOCK, PDIP16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS1307Z/T&R | 制造商:Maxim Integrated Products 功能描述:SERIAL TIME CHIP 8PIN SOIC, T&R - Tape and Reel 制造商:Maxim Integrated Products 功能描述:Maxim Integrated DS1307Z/T&R Real Time Clocks (RTC) 制造商:Maxim Integrated Products 功能描述:IC RTC SERIAL 512K 8-SOIC 制造商:Maxim Integrated Products 功能描述:Real Time Clock 64x8 Serial I2C RTC |
| DS1307Z/T&R | 功能描述:實時時鐘 64x8 Serial I2C RTC RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| DS1307Z/T&R/C03 | 功能描述:實時時鐘 RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| DS1307Z/TR | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:64 x 8, Serial, I2C Real-Time Clock |
| DS1307Z+ | 功能描述:實時時鐘 64x8 Serial I2C RTC RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。