- 您現在的位置：買賣IC網 > PDF目錄17064 > DC1009A-B (Linear Technology)BOARD DELTA SIGMA ADC LTC2488 PDF資料下載
參數資料
| 型號： | DC1009A-B |
| 廠商： | Linear Technology |
| 文件頁數： | 26/30頁 |
| 文件大?。?/td> | 0K |
| 描述： | BOARD DELTA SIGMA ADC LTC2488 |
| 軟件下載： | QuikEval System |
| 設計資源： | DC1009A Design File DC1009A Schematic |
| 標準包裝： | 1 |
| 系列： | Easy Drive™, QuikEval™ |
| ADC 的數量： | 1 |
| 位數： | 16 |
| 采樣率（每秒）： | 6.9 |
| 數據接口： | MICROWIRE?，串行，SPI? |
| 已用 IC / 零件： | LTC2488 |
| 已供物品： | 板 |
| 相關產品： | LTC2488CDE#TRPBF-ND - IC ADC 16BIT DELTA SIG 14-DFN LTC2488IDE#TRPBF-ND - IC ADC 16BIT DELTA SIG 14-DFN LTC2488CDE#PBF-ND - IC ADC 16BIT DELTA SIG 14-DFN LTC2488IDE#PBF-ND - IC ADC 16BIT DELTA SIG 14-DFN |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁當前第26頁第27頁第28頁第29頁第30頁
LTC2488
5
2488fa
SYMBOL
PARAMETER
CONDITIONS
MIN
TYP
MAX
UNITS
fEOSC
External Oscillator Frequency Range
(Note 16)
●
10
4000
kHz
tHEO
External Oscillator High Period
●
0.125
100
μs
tLEO
External Oscillator Low Period
●
0.125
100
μs
tCONV
Conversion Time
Simultaneous 50Hz/60Hz
External Oscillator
●
144.1
146.9
41036/fEOSC (in kHz)
149.9
ms
fISCK
Internal SCK Frequency
Internal Oscillator (Notes 10, 17)
External Oscillator (Notes 10, 11, 15)
38.4
fEOSC/8
kHz
DISCK
Internal SCK Duty Cycle
(Notes 10, 17)
●
45
55
%
fESCK
External SCK Frequency Range
(Notes 10, 11, 15)
●
4000
kHz
tLESCK
External SCK Low Period
(Notes 10, 11, 15)
●
125
ns
tHESCK
External SCK High Period
(Notes 10, 11, 15)
●
125
ns
tDOUT_ISCK
Internal SCK 24-Bit Data Output Time
Internal Oscillator (Notes 10, 17)
External Oscillator (Notes 10, 11, 15)
●
0.61
0.625
192/fEOSC (in kHz)
0.64
ms
tDOUT_ESCK
External SCK 24-Bit Data Output Time
24/fESCK (in kHz)
ms
t1
CS↓ to SDO Low
●
0
200
ns
t2
CS↑ to SDO High Z
●
0
200
ns
t3
CS↓ to SCK↓
Internal SCK Mode
●
0
200
ns
t4
CS↓ to SCK↑
External SCK Mode
●
50
ns
tKQMAX
SCK↓ to SDO Valid
●
200
ns
tKQMIN
SDO Hold After SCK↓
(Note 5)
●
15
ns
t5
SCK Set-Up Before CS↓
●
50
ns
t7
SDI Setup Before SCK↑
(Note 5)
●
100
ns
t8
SDI Hold After SCK↑
(Note 5)
●
100
ns
DIGITAL INPUTS AND DIGITAL OUTPUTS The ● denotes the specications which apply over the
full operating temperature range, otherwise specications are at TA = 25°C. (Note 3)
Note 1: Stresses beyond those listed under Absolute Maximum Ratings may
cause permanent damage to the device. Exposure to any Absolute Maximum
Rating condition for extended periods may affect device reliability and lifetime.
Note 2: All voltage values are with respect to GND.
Note 3: Unless otherwise specied:
VCC = 2.7V to 5.5V
VREFCM = VREF/2, FS = 0.5VREF
VIN = IN+ – IN–, VIN(CM) = (IN+ – IN–)/2,
where IN+ and IN– are the selected input channels.
Note 4: Use internal conversion clock or external conversion clock source
with fEOSC = 307.2kHz unless other wise specied.
Note 5: Guaranteed by design, not subject to test.
Note 6: Integral nonlinearity is dened as the deviation of a code from a
straight line passing through the actual endpoints of the transfer curve.
The deviation is measured from the center of the quantization band.
Note 7: fEOSC = 256kHz ±2% (external oscillator).
Note 8: fEOSC = 307.2kHz ±2% (external oscillator).
Note 9: Simultaneous 50Hz/60Hz (internal oscillator) or fEOSC = 280kHz
±2% (external oscillator).
Note 10: The SCK can be congured in external SCK mode or internal SCK
mode. In external SCK mode, the SCK pin is used as a digital input and the
driving clock is fESCK. In the internal SCK mode, the SCK pin is used as a
digital output and the output clock signal during the data output is fISCK.
Note 11: The external oscillator is connected to the FO pin. The external
oscillator frequency, fEOSC, is expressed in kHz.
Note 12: The converter uses its internal oscillator.
Note 13: The output noise includes the contribution of the internal
calibration operations. VREF ≤ VCC.
Note 14: Guaranteed by design and test correlation.
Note 15: The converter is in external SCK mode of operation such that the
SCK pin is used as a digital input. The frequency of the clock signal driving
SCK during the data output is fESCK and is expressed in Hz.
Note 16: Refer to Applications Information section for performance vs
data rate graphs.
Note 17: The converter in internal SCK mode of operation such that the
SCK pin is used as a digital output.
Note 18: For VCC < 3V, VIH is 2.5V for pin fO.
相關PDF資料 |
PDF描述 |
|---|---|
| AD9787-DPG2-EBZ | BOARD EVALUATION FOR AD9787 |
| ESA10DTKS | CONN EDGECARD 20POS DIP .125 SLD |
| SDR0604-331KL | INDUCTOR POWER 330UH 10% SMD |
| AD9788-DPG2-EBZ | BOARD EVALUATION FOR AD9788 |
| SLPX223M025E7P3 | CAP ALUM 22000UF 25V 20% SNAP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DC1009A-C | 功能描述:BOARD DELTA SIGMA ADC LTC2486 RoHS:是 類別:編程器，開發系統 >> 評估板 - 模數轉換器 (ADC) 系列:Easy Drive™, QuikEval™ 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- ADC 的數量:1 位數:12 采樣率（每秒）:94.4k 數據接口:USB 輸入范圍:±VREF/2 在以下條件下的電源（標準）:- 工作溫度:-40°C ~ 85°C 已用 IC / 零件:MAX11645 已供物品:板，軟件 |
| DC100A10 | 功能描述:固態繼電器-工業安裝 SSR DC OUTPUT 10A 90-140VAC RoHS:否 制造商:Crydom 控制電壓范圍:4 VDC to 32 VDC 負載電壓額定值:7 VDC to 72 VDC 負載電流額定值:160 A 觸點形式: 輸出設備:SSR 安裝風格:Panel |
| DC100A10C | 功能描述:固態繼電器-工業安裝 SSR DC OUTPUT 10A 90-140VAC RoHS:否 制造商:Crydom 控制電壓范圍:4 VDC to 32 VDC 負載電壓額定值:7 VDC to 72 VDC 負載電流額定值:160 A 觸點形式: 輸出設備:SSR 安裝風格:Panel |
| DC100A20 | 功能描述:固態繼電器-工業安裝 SSR DC OUTPUT 20A 90-140VAC RoHS:否 制造商:Crydom 控制電壓范圍:4 VDC to 32 VDC 負載電壓額定值:7 VDC to 72 VDC 負載電流額定值:160 A 觸點形式: 輸出設備:SSR 安裝風格:Panel |
| DC100A20C | 功能描述:固態繼電器-工業安裝 SSR DC OUTPUT 20A 90-140VAC RoHS:否 制造商:Crydom 控制電壓范圍:4 VDC to 32 VDC 負載電壓額定值:7 VDC to 72 VDC 負載電流額定值:160 A 觸點形式: 輸出設備:SSR 安裝風格:Panel |
發布緊急采購，3分鐘左右您將得到回復。