- 您現在的位置：買賣IC網 > PDF目錄1992 > CY28447LFXC (Silicon Laboratories Inc)IC CLOCK CALISTOGA CK410M 72QFN PDF資料下載
參數資料
| 型號： | CY28447LFXC |
| 廠商： | Silicon Laboratories Inc |
| 文件頁數： | 3/22頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC CLOCK CALISTOGA CK410M 72QFN |
| 標準包裝： | 240 |
| 類型： | 時鐘/頻率發生器 |
| PLL： | 是 |
| 主要目的： | Intel CPU 服務器 |
| 輸入： | LVTTL，晶體 |
| 輸出： | HCSL，LVCMOS |
| 電路數： | 1 |
| 比率 - 輸入:輸出： | 3:21 |
| 差分 - 輸入:輸出： | 無/是 |
| 頻率 - 最大： | 200MHz |
| 電源電壓： | 3.135 V ~ 3.465 V |
| 工作溫度： | 0°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 72-VFQFN 裸露焊盤 |
| 供應商設備封裝： | 72-QFN（10x10） |
| 包裝： | 托盤 |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁
CY28447
.......................Document #: 38-07724 Rev *C Page 11 of 22
PD (Power-down) Clarification
The VTT_PWRGD# /PD pin is a dual-function pin. During
initial power-up, the pin functions as VTT_PWRGD#. Once
VTT_PWRGD# has been sampled LOW by the clock chip, the
pin assumes PD functionality. The PD pin is an asynchronous
active HIGH input used to shut off all clocks cleanly prior to
shutting off power to the device. This signal is synchronized
internal to the device prior to powering down the clock synthe-
sizer. PD is also an asynchronous input for powering up the
system. When PD is asserted HIGH, all clocks need to be
driven to a LOW value and held prior to turning off the VCOs
and the crystal oscillator.
PD (Power-down) Assertion
When PD is sampled HIGH by two consecutive rising edges
of CPUC, all single-ended outputs will be held LOW on their
next HIGH-to-LOW transition and differential clocks must be
held HIGH or tri-stated (depending on the state of the control
register drive mode bit) on the next diff clock# HIGH-to-LOW
transition within 4 clock periods. When the SMBus PD drive
mode bit corresponding to the differential (CPU, SRC, and
DOT) clock output of interest is programmed to ‘0’, the clock
outputs are held with “Diff clock” pin driven HIGH at 2 x Iref,
and “Diff clock#” tri-state. If the control register PD drive mode
bit corresponding to the output of interest is programmed to
“1”, then both the “Diff clock” and the “Diff clock#” are tri-state.
Note that Figure 4 shows CPUT = 133 MHz and PD drive
mode = ‘1’ for all differential outputs. This diagram and
description is applicable to valid CPU frequencies 100, 133,
166, and 200 MHz. In the event that PD mode is desired as
the initial power-on state, PD must be asserted HIGH in less
than 10
s after asserting Vtt_PwrGd#. It should be noted that
96_100_SSC will follow the DOT waveform is selected for
96 MHz and the SRC waveform when in 100-MHz mode.
PD Deassertion
The power-up latency is less than 1.8 ms. This is the time from
the deassertion of the PD pin or the ramping of the power
supply until the time that stable clocks are output from the
clock chip. All differential outputs stopped in a three-state
condition resulting from power down will be driven high in less
than 300
s of PD deassertion to a voltage greater than
200 mV. After the clock chip’s internal PLL is powered up and
locked, all outputs will be enabled within a few clock cycles of
each other. Figure 5 is an example showing the relationship of
clocks coming up. It should be noted that 96_100_SSC will
follow the DOT waveform is selected for 96 MHz and the SRC
waveform when in 100-MHz mode.
Figure 4. Power-down Assertion Timing Waveform
PD
USB, 48MHz
DOT96T
DOT96C
SRCT 100MHz
SRCC 100MHz
CPUT, 133MHz
PCI, 33 MHz
REF
CPUC, 133MHz
Figure 5. Power-down Deassertion Timing Waveform
DOT96C
PD
CPUC, 133MHz
CPUT, 133MHz
SRCC 100MHz
USB, 48MHz
DOT96T
SRCT 100MHz
Tstable
<1.8 ms
PCI, 33MHz
REF
Tdrive_PWRDN#
<300
s, >200 mV
相關PDF資料 |
PDF描述 |
|---|---|
| CY28547LFXCT | IC CLOCK CK505/410M INTEL 72QFN |
| CY28548ZXC | IC CLK CK505 960M/965M 64TSSOP |
| CY28551LFXC-3T | IC CLOCK INTEL/AMD SIS VIA 56QFN |
| CY28551LFXC | IC CLOCK INTEL/AMD SIS VIA 64QFN |
| CY2SSTV855ZXI | IC CLOCK DIFFDRV PLL DDR 28TSSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CY28447LFXCT | 功能描述:時鐘發生器及支持產品 Calistoga System Clk Extra SRC Output RoHS:否 制造商:Silicon Labs 類型:Clock Generators 最大輸入頻率:14.318 MHz 最大輸出頻率:166 MHz 輸出端數量:16 占空比 - 最大:55 % 工作電源電壓:3.3 V 工作電源電流:1 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-56 |
| CY28506OC | 制造商:Rochester Electronics LLC 功能描述:FTG FOR MOTHERBOARDS - Bulk |
| CY28506OCT | 制造商:Rochester Electronics LLC 功能描述:CLOC - Tape and Reel |
| CY28507ZC-3 | 功能描述:時鐘緩沖器 PacketClockClk RoHS:否 制造商:Texas Instruments 輸出端數量:5 最大輸入頻率:40 MHz 傳播延遲（最大值）: 電源電壓-最大:3.45 V 電源電壓-最小:2.375 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LLP-24 封裝:Reel |
| CY28508OCT | 制造商:Cypress Semiconductor 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。