- 您現在的位置：買賣IC網 > PDF目錄1903 > AT87F52-24PC (Atmel)IC MICRO CTRL 24MHZ 40DIP PDF資料下載
參數資料
| 型號： | AT87F52-24PC |
| 廠商： | Atmel |
| 文件頁數： | 4/24頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC MICRO CTRL 24MHZ 40DIP |
| 標準包裝： | 10 |
| 系列： | 87F |
| 核心處理器： | 8051 |
| 芯體尺寸： | 8-位 |
| 速度： | 24MHz |
| 連通性： | UART/USART |
| 輸入/輸出數： | 32 |
| 程序存儲器容量： | 8KB（8K x 8） |
| 程序存儲器類型： | OTP 快速閃存 |
| RAM 容量： | 256 x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 4 V ~ 6 V |
| 振蕩器型： | 內部 |
| 工作溫度： | 0°C ~ 70°C |
| 封裝/外殼： | 40-DIP（0.600"，15.24mm） |
| 包裝： | 管件 |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁
Not
12
Program Memory Lock Bits
The AT87F52 has three lock bits that can be left unpro-
grammed (U) or can be programmed (P) to obtain the addi-
tional features listed in the following table.
Lock Bit Protection Modes
When lock bit 1 is programmed, the logic level at the EA pin
is sampled and latched during reset. If the device is pow-
ered up without a reset, the latch initializes to a random
value and holds that value until reset is activated. The
latched value of EA must agree with the current logic level
at that pin in order for the device to function properly.
Programming the QuickFlash
The AT87F52 is shipped with the on-chip QuickFlash mem-
ory array ready to be programmed. The programming inter-
face needs a high-voltage (12-volt) program enable signal
and is compatible with conventional third-party Flash or
EPROM programmers.
The AT87F52 code memory array is programmed byte-by-
byte.
Programming Algorithm: Before programming the
AT87F52, the address, data, and control signals should be
set up according to the QuickFlash programming mode
table and Figures 9 and 10. To program the AT87F52, take
the following steps:
1.
Input the desired memory location on the address
lines.
2.
Input the appropriate data byte on the data lines.
3.
Activate the correct combination of control signals.
4.
Raise EA/VPP to 12V.
5.
Pulse ALE/PROG once to program a byte in the Quick-
Flash array or the lock bits. The byte-write cycle is self-
timed and typically takes no more than 1.5 ms. Repeat
steps 1 through 5, changing the address and data for
the entire array or until the end of the object file is
reached.
Data Polling: The AT87F52 features Data Polling to indi-
cate the end of a write cycle. During a write cycle, an
attempted read of the last byte written will result in the com-
plement of the written data on PO.7. Once the write cycle
has been completed, true data is valid on all outputs, and
the next cycle may begin. Data Polling may begin any time
after a write cycle has been initiated.
Ready/Busy: The progress of byte programming can also
be monitored by the RDY/BSY output signal. P3.4 is pulled
low after ALE goes high during programming to indicate
BUSY. P3.4 is pulled high again when programming is
done to indicate READY.
Program Verify: If lock bits LB1 and LB2 have not been
programmed, the programmed code data can be read back
via the address and data lines for verification. The lock bits
cannot be verified directly. Verification of the lock bits is
achieved by observing that their features are enabled.
Reading the Signature Bytes: The signature bytes are
read by the same procedure as a normal verification of
locations 030H, 031H, and 032H, except that P3.6 and
P3.7 must be pulled to a logic low. The values returned are
as follows.
(030H) = 1EH indicates manufactured by Atmel
(031H) = 87H indicates 87F family
(032H) = 02H indicates 87F52
Program Lock Bits
LB1
LB2
LB3
Protection Type
1
U
No program lock features.
2
P
U
MOVC instructions executed
from external program
memory are disabled from
fetching code bytes from
internal memory, EA is
sampled and latched on reset,
and further programming of
the QuickFlash memory is
disabled.
3
P
U
Same as mode 2, but verify is
also disabled.
4
P
Same as mode 3, but external
execution is also disabled.
相關PDF資料 |
PDF描述 |
|---|---|
| AT88SA102S-TH-T | IC PRODUCT AUTHENTICATION 8TSSOP |
| AT88SC018-SU-CN-T | IC CRYPTOCOMPANION RF/MEM 8SOIC |
| AT89C2051-24SU | IC MCU 2K FLASH 24MHZ 20-SOIC |
| AT89C4051-24SJ | IC MCU 4K FLASH 24MHZ 20-SOIC |
| AT89C51-24PI | IC MICRO CTRL 24MHZ 40DIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AT87F52-24PI | 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:8-Bit Microcontroller with 8K Bytes QuickFlash |
| AT87F55WD | 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:8-bit Microcontroller with 20K Bytes QuickFlash⑩ |
| AT87F55WD-24AC | 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:8-bit Microcontroller with 20K Bytes QuickFlash⑩ |
| AT87F55WD-24AI | 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:8-bit Microcontroller with 20K Bytes QuickFlash⑩ |
| AT87F55WD-24JC | 功能描述:8位微控制器 -MCU 80C31 w/20k RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。