- 您現在的位置：買賣IC網 > PDF目錄1989 > ADF4150BCPZ-RL7 (Analog Devices Inc)IC PLL FREQ SYNTH 5.0GHZ 24LFCSP PDF資料下載
參數資料
| 型號： | ADF4150BCPZ-RL7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 17/28頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC PLL FREQ SYNTH 5.0GHZ 24LFCSP |
| 標準包裝： | 1,500 |
| 類型： | 分?jǐn)?shù) N，整數 N，頻率合成器（RF） |
| PLL： | 是 |
| 輸入： | CMOS，TTL |
| 輸出： | 時鐘 |
| 電路數： | 1 |
| 比率 - 輸入:輸出： | 2:2 |
| 差分 - 輸入:輸出： | 是/是 |
| 頻率 - 最大： | 4.4GHz |
| 除法器/乘法器： | 是/無 |
| 電源電壓： | 3 V ~ 3.6 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 24-WFQFN 裸露焊盤，CSP |
| 供應商設備封裝： | 24-LFCSP-WQ（4x4） |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
ADF4150
Data Sheet
Rev. A | Page 24 of 28
Reference Spurs
Reference spurs are generally not a problem in fractional-N
synthesizers because the reference offset is far outside the loop
bandwidth. However, any reference feedthrough mechanism
that bypasses the loop can cause a problem. Feedthrough of low
levels of on-chip reference switching noise, through the RFIN
pin back to the VCO, can result in reference spur levels as high
as 90 dBc. PCB layout needs to ensure adequate isolation
between VCO traces and the input reference to avoid a possible
feedthrough path on the board.
SPUR CONSISTENCY AND FRACTIONAL SPUR
OPTIMIZATION
With dither off, the fractional spur pattern due to the quanti-
zation noise of the SDM also depends on the particular phase
word with which the modulator is seeded.
The phase word can be varied to optimize the fractional and
subfractional spur levels on any particular frequency. Thus, a
look-up table of phase values corresponding to each frequency
can be constructed for use when programming the ADF4150.
If a look-up table is not used, keep the phase word at a constant
value to ensure consistent spur levels on any particular frequency.
PHASE RESYNC
The output of a fractional-N PLL can settle to any one of the
MOD phase offsets with respect to the input reference, where
MOD is the fractional modulus. The phase resync feature in the
ADF4150 produces a consistent output phase offset with respect
to the input reference. This is necessary in applications where the
output phase and frequency are important, such as digital beam
forming. See the Phase Programmability section for how to
program a specific RF output phase when using phase resync.
Phase resync is enabled by setting Bit DB16, Bit DB15 in
Register 3 to 1, 0. When PHASE resync is enabled, an internal
timer generates sync signals at intervals of tSYNC given by the
following formula:
tSYNC = CLK_DIV_VALUE × MOD × tPFD
where:
tPFD is the PFD reference period.
CLK_DIV_VALUE is the decimal value programmed in
Bits[DB14:DB3] of Register 3 and can be any integer in the
range of 1 to 4095.
MOD is the modulus value programmed in Bits[DB14:DB3] of
Register 1 (R1).
When a new frequency is programmed, the second sync pulse
after the LE rising edge is used to resynchronize the output
phase to the reference. The tSYNC time is to be programmed to
a value that is at least as long as the worst-case lock time. This
guarantees that the PHASE resync occurs after the last cycle slip
in the PLL settling transient.
In the example shown in Figure 29, the PFD reference is 25 MHz
and MOD is 125 for a 200 kHz channel spacing. tSYNC is set to
400 s by programming CLK_DIV_VALUE to 80.
Figure 29. Phase Resync Example
Phase Programmability
The phase word in Register 1 controls the RF output phase. As
this word is swept from 0 to MOD, the RF output phase sweeps
over a 360° range in steps of 360°/MOD.
LE
PHASE
FREQUENCY
SYNC
(INTERNAL)
–100
0
100
200
1000
300
400
500
600
700
800
900
TIME (s)
PLL SETTLES TO
CORRECT PHASE
AFTER RESYNC
tSYNC
LAST CYCLE SLIP
PLL SETTLES TO
INCORRECT PHASE
08226-
025
相關PDF資料 |
PDF描述 |
|---|---|
| ADF4150HVBCPZ | IC FRACTION-N FREQ SYNTH 32LFCSP |
| ADF4151BCPZ-RL7 | IC FRACTION-N FREQ SYNTH 32LFCSP |
| ADF4153YRUZ | IC SYNTH PLL RF F-N FREQ 16TSSOP |
| ADF4154BRU | IC FRAC-N FREQ SYNTH 16-TSSOP |
| ADF4156BRUZ-RL7 | IC PLL FRAC-N FREQ SYNTH 16TSSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADF4150HV | 制造商:AD 制造商全稱:Analog Devices 功能描述:High Voltage, Fractional-N |
| ADF4150HVBCPZ | 功能描述:IC FRACTION-N FREQ SYNTH 32LFCSP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:- 標準包裝:1,000 系列:Precision Edge® 類型:時鐘/頻率合成器 PLL:無 輸入:CML，PECL 輸出:CML 電路數:1 比率 - 輸入:輸出:2:1 差分 - 輸入:輸出:是/是 頻率 - 最大:10.7GHz 除法器/乘法器:無/無 電源電壓:2.375 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VFQFN 裸露焊盤，16-MLF? 供應商設備封裝:16-MLF?（3x3） 包裝:帶卷 (TR) 其它名稱:SY58052UMGTRSY58052UMGTR-ND |
| ADF4150HVBCPZ-RL7 | 功能描述:IC FRACTION-N FREQ SYNTH 32LFCSP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:- 標準包裝:1,000 系列:Precision Edge® 類型:時鐘/頻率合成器 PLL:無 輸入:CML，PECL 輸出:CML 電路數:1 比率 - 輸入:輸出:2:1 差分 - 輸入:輸出:是/是 頻率 - 最大:10.7GHz 除法器/乘法器:無/無 電源電壓:2.375 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VFQFN 裸露焊盤，16-MLF? 供應商設備封裝:16-MLF?（3x3） 包裝:帶卷 (TR) 其它名稱:SY58052UMGTRSY58052UMGTR-ND |
| ADF4151 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Fractional-N/Integer-N PLL Synthesizer |
| ADF4151BCPZ | 功能描述:IC PLL FREQ SYNTHESIZER 32LFCSP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:- 標準包裝:1,000 系列:Precision Edge® 類型:時鐘/頻率合成器 PLL:無 輸入:CML，PECL 輸出:CML 電路數:1 比率 - 輸入:輸出:2:1 差分 - 輸入:輸出:是/是 頻率 - 最大:10.7GHz 除法器/乘法器:無/無 電源電壓:2.375 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VFQFN 裸露焊盤，16-MLF? 供應商設備封裝:16-MLF?（3x3） 包裝:帶卷 (TR) 其它名稱:SY58052UMGTRSY58052UMGTR-ND |
發布緊急采購，3分鐘左右您將得到回復。