- 您現在的位置：買賣IC網 > PDF目錄5693 > AD8620BRZ-REEL7 (Analog Devices Inc)IC OPAMP JFET 25MHZ DUAL 8SOIC PDF資料下載
參數資料
| 型號： | AD8620BRZ-REEL7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 8/24頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC OPAMP JFET 25MHZ DUAL 8SOIC |
| 設計資源： | Using AD7328 in Appls with Single-Ended Industrial-Level Signals (CN0047) |
| 標準包裝： | 1,000 |
| 放大器類型： | J-FET |
| 電路數： | 2 |
| 轉換速率： | 60 V/µs |
| 增益帶寬積： | 25MHz |
| 電流 - 輸入偏壓： | 3pA |
| 電壓 - 輸入偏移： | 45µV |
| 電流 - 電源： | 3mA |
| 電流 - 輸出 / 通道： | 45mA |
| 電壓 - 電源，單路/雙路(±)： | ±5 V ~ 13 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 8-SO |
| 包裝： | 帶卷 (TR) |
AD8610/AD8620
Rev. F | Page 16 of 24
The slew rate of the AD8610/AD8620 is double that of the
OPA627 when configured in a unity gain of +1 (see Figure 53
and Figure 54).
02
73
0-
0
53
V
O
L
T
A
G
E
(
5V/
D
IV)
TIME (400ns/DIV)
VS = ±13V
RL = 2k
G= +1
SR = 85V/s
Figure 53. +Slew Rate of AD8610/AD8620 in Unity Gain of +1
02
73
0-
0
54
VO
L
T
A
G
E
(
5V/
D
IV)
TIME (400ns/DIV)
VS = ±13V
RL = 2k
G= +1
SR = 23V/s
Figure 54. +Slew Rate of OPA627 in Unity Gain of +1
The slew rate of an amplifier determines the maximum frequency
at which it can respond to a large signal input. This frequency
(known as full power bandwidth or FPBW) can be calculated
for a given distortion (for example, 1%) from the equation
()
PEAK
V
SR
FPBW
×
π
=
2
02
73
0-
05
5
V
O
LT
A
G
E
(
10
V
/D
IV
)
TIME (400ns/DIV)
CH1 = 20.8V p-p
CH2 = 19.4V p-p
0V
Figure 55. AD8610 FPBW
Input Overvoltage Protection
When the input of an amplifier is driven below VEE or above VCC
by more than one VBE, large currents flow from the substrate
through the negative supply (V–) or the positive supply (V+),
respectively, to the input pins and can destroy the device. If the
input source can deliver larger currents than the maximum
forward current of the diode (>5 mA), a series resistor can be
added to protect the inputs. With its very low input bias and
offset current, a large series resistor can be placed in front of the
AD8610/AD8620 inputs to limit current to below damaging
levels. Series resistance of 10 kΩ generates less than 25 μV of offset.
This 10 kΩ allows input voltages more than 5 V beyond either
power supply. Thermal noise generated by the resistor adds
7.5 nV/√Hz to the noise of the AD8610/AD8620. For the AD8610/
AD8620, differential voltages equal to the supply voltage do not
cause any problems (see Figure 55). In this context, note that the
high breakdown voltage of the input FETs eliminates the need to
include clamp diodes between the inputs of the amplifier, a practice
that is mandatory on many precision op amps. Unfortunately,
clamp diodes greatly interfere with many application circuits,
such as precision rectifiers and comparators. The AD8610/
AD8620 are free from these limitations.
V1
–13V
3
2
7
4
+13V
14V
0
6
AD8610
02
73
0
-05
6
Figure 56. Unity Gain Follower
No Phase Reversal
Many amplifiers misbehave when one or both of the inputs are
forced beyond the input common-mode voltage range. Phase
reversal is typified by the transfer function of the amplifier,
effectively reversing its transfer polarity. In some cases, this can
cause lockup and even equipment damage in servo systems and
can cause permanent damage or no recoverable parameter shifts
to the amplifier itself. Many amplifiers feature compensation
circuitry to combat these effects, but some are only effective for
the inverting input. The AD8610/AD8620 are designed to prevent
phase reversal when one or both inputs are forced beyond their
input common-mode voltage range.
02
73
0-
0
57
V
O
L
T
A
G
E
(
5V/
D
IV)
TIME (400s/DIV)
VOUT
VIN
Figure 57. No Phase Reversal
相關PDF資料 |
PDF描述 |
|---|---|
| 3428-6603UG | CONN HEADER 20POS STR LONG LATCH |
| 77313-818-64LF | CONN HEADER .100 DUAL STR 64POS |
| 961120-6300-AR-PT | CONN HEADER VERT 20POS GOLD SMD |
| 951232-7722-AR | CONN HEADER 32POS 2MM R/A SOLDER |
| 3793-650T02TC | CONN HEADER 10PS STR SHORT LATCH |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD8622 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Dual, Low Power, Low Noise, Low Bias Current Precision Rail-to-Rail Output Op Amp |
| AD8622_09 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Dual, Low Power, Precision Rail-to-Rail Output Op Amp |
| AD8622ARMZ | 功能描述:IC OPAMP GP R-R 540KHZ LP 8MSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:- 放大器類型:通用 電路數:4 輸出類型:- 轉換速率:0.6 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:45nA 電壓 - 輸入偏移:2000µV 電流 - 電源:1.4mA 電流 - 輸出 / 通道:40mA 電壓 - 電源，單路/雙路(±):3 V ~ 32 V，±1.5 V ~ 16 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:14-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:14-TSSOP 包裝:帶卷 (TR) 其它名稱:LM324ADTBR2G-NDLM324ADTBR2GOSTR |
| AD8622ARMZ | 制造商:Analog Devices 功能描述:OP-AMP, PRECISION, 560KHZ, 0.48V/us, MSO |
| AD8622ARMZ-R7 | 功能描述:IC OPAMP GP R-R 540KHZ LP 8MSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 其它有關文件:Automotive Product Guide 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- 放大器類型:通用 電路數:1 輸出類型:滿擺幅 轉換速率:3 V/µs 增益帶寬積:10MHz -3db帶寬:- 電流 - 輸入偏壓:1pA 電壓 - 輸入偏移:70µV 電流 - 電源:2.5mA 電流 - 輸出 / 通道:48mA 電壓 - 電源，單路/雙路(±):2.7 V ~ 5.5 V，±1.35 V ~ 2.75 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-6 包裝:Digi-Reel® 其它名稱:MAX4475AUT#TG16DKR |
發布緊急采購，3分鐘左右您將得到回復。