參數資料
型號: AD7980ACPZ-RL
廠商: Analog Devices Inc
文件頁數: 10/28頁
文件大?。?/td> 0K
描述: IC ADC 16BIT 1MSPS SAR 10LFCSP
標準包裝: 5,000
系列: PulSAR®
位數: 16
采樣率(每秒): 1M
數據接口: DSP,MICROWIRE?,QSPI?,串行,SPI?
轉換器數目: 1
功率耗散(最大): 10mW
電壓電源: 單電源
工作溫度: -40°C ~ 125°C
安裝類型: 表面貼裝
封裝/外殼: 10-WFDFN 裸露焊盤,CSP
供應商設備封裝: 10-LFCSP-WD(3x3)
包裝: 帶卷 (TR)
輸入數目和類型: 1 個偽差分,單極
AD7980
Data Sheet
Rev. C | Page 18 of 28
CS MODE 3-WIRE WITH BUSY INDICATOR
This mode is usually used when a single AD7980 is connected
to an SPI-compatible digital host having an interrupt input.
The connection diagram is shown in Figure 33, and the
corresponding timing is given in Figure 34.
With SDI tied to VIO, a rising edge on CNV initiates a
conversion, selects the CS mode, and forces SDO to high
impedance. SDO is maintained in high impedance until the
completion of the conversion irrespective of the state of CNV.
Prior to the minimum conversion time, CNV can be used to
select other SPI devices, such as analog multiplexers, but CNV
must be returned low before the minimum conversion time
elapses and then held low for the maximum conversion time to
guarantee the generation of the busy signal indicator. When the
conversion is complete, SDO goes from high impedance to low.
With a pull-up on the SDO line, this transition can be used as an
interrupt signal to initiate the data reading controlled by the
digital host. The AD7980 then enters the acquisition phase and
powers down. The data bits are clocked out, MSB first, by
subsequent SCK falling edges. The data is valid on both SCK
edges. Although the rising edge can be used to capture the data,
a digital host using the SCK falling edge allows a faster reading
rate provided it has an acceptable hold time. After the optional
17th SCK falling edge or when CNV goes high, whichever is
earlier, SDO returns to high impedance.
If multiple AD7980s are selected at the same time, the SDO
output pin handles this contention without damage or induced
latch-up. Meanwhile, it is recommended to keep this contention
as short as possible to limit extra power dissipation.
06392-
017
AD7980 SDO
SDI
DATA IN
IRQ
DIGITAL HOST
CONVERT
CLK
VIO
47kΩ
CNV
SCK
Figure 33. 3-Wire CS Mode with Busy Indicator
Connection Diagram (SDI High)
06392-
018
tCONV
tCNVH
tCYC
AQUISITION
tACQ
tSCK
tSCKH
tSCKL
CONVERSION
SCK
CNV
SDI = 1
SDO
D15
D14
D1
D0
tHSDO
1
2
3
15
16
17
tDSDO
tDIS
Figure 34. 3-Wire CS Mode with Busy Indicator Serial Interface Timing (SDI High)
相關PDF資料
PDF描述
MS3106E28-4S CONN PLUG 9POS STRAIGHT W/SCKT
VI-BWY-MY CONVERTER MOD DC/DC 3.3V 33W
ADN4694EBRZ-RL7 IC TXRX MLVDS 100MBPS 8SOIC
AD7686BCPZRL IC ADC 16BIT 500KSPS 10-LFCSP
MS27499E20B16PB CONN RCPT 16POS BOX MNT W/PINS
相關代理商/技術參數
參數描述
AD7980ACPZ-RL7 功能描述:IC ADC 16BIT 1MSPS SAR 10LFCSP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:PulSAR® 標準包裝:1,000 系列:- 位數:12 采樣率(每秒):300k 數據接口:并聯 轉換器數目:1 功率耗散(最大):75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC(0.295",7.50mm 寬) 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端,單極;1 個單端,雙極
AD7980ARMZ 功能描述:ADC 16BIT 1MSPS LP 10-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:PulSAR® 標準包裝:1 系列:- 位數:14 采樣率(每秒):83k 數據接口:串行,并聯 轉換器數目:1 功率耗散(最大):95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP(0.600",15.24mm) 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端,雙極
AD7980ARMZ 制造商:Analog Devices 功能描述:; Leaded Process Compatible:Yes; Peak Re
AD7980ARMZRL7 功能描述:ADC 16BIT 1MSPS 2.5LSB 10-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:PulSAR® 標準包裝:1 系列:microPOWER™ 位數:8 采樣率(每秒):1M 數據接口:串行,SPI? 轉換器數目:1 功率耗散(最大):- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤(4x4) 包裝:Digi-Reel® 輸入數目和類型:8 個單端,單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6
AD7980ARMZ-RL7 制造商:Analog Devices 功能描述:- Tape and Reel